Photoaligning Polymeric Command Surfaces: Bind, or Mix?

We compare photoaligning properties of polymer layers fabricated from the same constituents: polymethyl-methacrylate (PMMA) and azo-dye Disperse Red 1 (DR1), either chemically attached to the PMMA main-chain, or physically mixed with it. Photoaligning properties depend on the preparation method dras...

Descripción completa

Detalles Bibliográficos
Autores principales: Nassrah, Ameer R. K., Batkova, Marianna, Tomašovičová, Natália, Tóth-Katona, Tibor
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2023
Materias:
Article
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10649986/
https://www.ncbi.nlm.nih.gov/pubmed/37959951
http://dx.doi.org/10.3390/polym15214271
Descripción
Sumario:We compare photoaligning properties of polymer layers fabricated from the same constituents: polymethyl-methacrylate (PMMA) and azo-dye Disperse Red 1 (DR1), either chemically attached to the PMMA main-chain, or physically mixed with it. Photoaligning properties depend on the preparation method drastically. Photoalignment was found to be far more efficient when PMMA is functionalized with DR1 compared to the case of physically mixing the constituents. This finding is supported by atomic force microscope (AFM) scans monitoring the light-induced changes at the polymer–air interface, and revealing a photoinduced mass transfer, especially in the case of functionalized PMMA.

Ejemplares similares