Cargando…

Flow Rate and Interference Studies for Copper Binding to a Silica-Immobilized Humin Polymer Matrix: Column and Batch Experiments

Batch and column experiments were performed to determine the Cu(II) binding capacity of silica-immobilized humin biomass. For column studies, 500 bed volumes of a 0.1 mM Cu(II) solution were passed through humin packed columns at the flow rates of 1, 1.5, 2, and 3 mL/min. The biopolymer showed an av...

Descripción completa

Detalles Bibliográficos
Autores principales: Gardea-Torresdey, Jorge L., Contreras, Carolina, de la Rosa, Guadalupe, Peralta-Videa, Jose R.
Formato: Texto
Lenguaje:English
Publicado: Hindawi Publishing Corporation 2005
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC2267088/
https://www.ncbi.nlm.nih.gov/pubmed/18365085
http://dx.doi.org/10.1155/BCA.2005.1
Descripción
Sumario:Batch and column experiments were performed to determine the Cu(II) binding capacity of silica-immobilized humin biomass. For column studies, 500 bed volumes of a 0.1 mM Cu(II) solution were passed through humin packed columns at the flow rates of 1, 1.5, 2, and 3 mL/min. The biopolymer showed an average Cu binding capacity of 12 ± 1.5 mg/g and a Cu recovery of about 96.5 % ± 1.5. The breakthrough points for Cu(II) alone were approximately 420, 390, 385, and 300 bed volumes for the flow rates of 1, 1.5, 2 and 3 mL/min, respectively. The interference studies demonstrated that at low concentrations, the hard cations Ca(II) and Mg(II) did not seem to represent a major interference on Cu(II) binding to the humin biopolymer. The selectivity showed by this biopolymer was Cu(II)>Ca(II)>Mg(II). On the other hand, batch experiments showed that Ca(II) + Mg(II) at 100mM each reduced the Cu(II) binding to 73 %. However, 1000 mM concentrations of Ca(II) and Mg(II), separately and in mixture, reduced the Cu(II) binding to 47 %, 44 % and 31 %, respectively. The results of this study showed that immobilized humin in a silica matrix could represent an inexpensive bio-source for Cu removal from contaminated water, even in the presence of low concentrations of the hard cations Ca(II) and Mg(II).