Cargando…
Orthodontic Bracket Manufacturing Tolerances and Dimensional Differences between Select Self-Ligating Brackets
In all manufacturing processes there are tolerances; however, orthodontic bracket manufacturers seldom state the slot dimensional tolerances. This experiment develops a novel method of analyzing slot profile dimensions using photographs of the slot. Five points are selected along each wall, and line...
Autores principales: | Major, Thomas W., Carey, Jason P., Nobes, David S., Major, Paul W. |
---|---|
Formato: | Texto |
Lenguaje: | English |
Publicado: |
SAGE-Hindawi Access to Research
2010
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC2958443/ https://www.ncbi.nlm.nih.gov/pubmed/20981299 http://dx.doi.org/10.4061/2010/781321 |
Ejemplares similares
-
Three-dimensional deformation of orthodontic brackets
por: Melenka, Garrett W, et al.
Publicado: (2013) -
Torque expression in self-ligating orthodontic brackets
and conventionally ligated brackets: A systematic review
por: Al-Thomali, Yousef, et al.
Publicado: (2017) -
Measurement of Orthodontic Bracket Tie Wing Elastic and Plastic Deformation by Arch Wire Torque Expression Utilizing an Optical Image Correlation Technique
por: Lacoursiere, Ryan A., et al.
Publicado: (2009) -
Oral health-related quality of life in orthodontic patients during initial therapy with conventional brackets or self-ligating brackets
por: Lai, Tai-Ting, et al.
Publicado: (2017) -
Frictional resistance of self-ligating versus conventional brackets in
different bracket-archwire-angle combinations
por: MONTEIRO, Maria Regina Guerra, et al.
Publicado: (2014)