FIBTEM provides early prediction of massive transfusion in trauma

INTRODUCTION: Prediction of massive transfusion (MT) among trauma patients is difficult in the early phase of trauma management. Whole-blood thromboelastometry (ROTEM(®)) tests provide immediate information about the coagulation status of acute bleeding trauma patients. We investigated their value for early prediction of MT. METHODS: This retrospective study included patients admitted to the AUVA Trauma Centre, Salzburg, Austria, with an injury severity score ≥16, from whom blood samples were taken immediately upon admission to the emergency room (ER). ROTEM(® )analyses (extrinsically-activated test with tissue factor (EXTEM), intrinsically-activated test using ellagic acid (INTEM) and fibrin-based extrinsically activated test with tissue factor and the platelet inhibitor cytochalasin D (FIBTEM) tests) were performed. We divided patients into two groups: massive transfusion (MT, those who received ≥10 units red blood cell concentrate within 24 hours of admission) and non-MT (those who received 0 to 9 units). RESULTS: Of 323 patients included in this study (78.9% male; median age 44 years), 78 were included in the MT group and 245 in the non-MT group. The median injury severity score upon admission to the ER was significantly higher in the MT group than in the non-MT group (42 vs 27, P < 0.0001). EXTEM and INTEM clotting time and clot formation time were significantly prolonged and maximum clot firmness (MCF) was significantly lower in the MT group versus the non-MT group (P < 0.0001 for all comparisons). Of patients admitted with FIBTEM MCF 0 to 3 mm, 85% received MT. The best predictive values for MT were provided by hemoglobin and Quick value (area under receiver operating curve: 0.87 for both parameters). Similarly high predictive values were observed for FIBTEM MCF (0.84) and FIBTEM A10 (clot amplitude at 10 minutes; 0.83). CONCLUSIONS: FIBTEM A10 and FIBTEM MCF provided similar predictive values for massive transfusion in trauma patients to the most predictive laboratory parameters. Prospective studies are needed to confirm these findings.