Cargando…

A study on the evaluations of emission factors and uncertainty ranges for methane and nitrous oxide from combined-cycle power plant in Korea

In this research, in order to develop technology/country-specific emission factors of methane (CH(4)) and nitrous oxide (N(2)O), a total of 585 samples from eight gas-fired turbine combined cycle (GTCC) power plants were measured and analyzed. The research found that the emission factor for CH(4) st...

Descripción completa

Detalles Bibliográficos
Autores principales: Lee, Seehyung, Kim, Jinsu, Lee, Jeongwoo, Lee, Seongho, Jeon, Eui-Chan
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Springer-Verlag 2012
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC3536972/
https://www.ncbi.nlm.nih.gov/pubmed/23001757
http://dx.doi.org/10.1007/s11356-012-1144-1
Descripción
Sumario:In this research, in order to develop technology/country-specific emission factors of methane (CH(4)) and nitrous oxide (N(2)O), a total of 585 samples from eight gas-fired turbine combined cycle (GTCC) power plants were measured and analyzed. The research found that the emission factor for CH(4) stood at “0.82 kg/TJ”, which was an 18 % lower than the emission factor for liquefied natural gas (LNG) GTCC “1 kg/TJ” presented by Intergovernmental Panel on Climate Change (IPCC). The result was 8 % up when compared with the emission factor of Japan which stands at “0.75 kg/TJ”. The emission factor for N(2)O was “0.65 kg/TJ”, which is significantly lower than “3 kg/TJ” of the emission factor for LNG GTCC presented by IPCC, but over six times higher than the default N(2)O emission factor of LNG. The evaluation of uncertainty was conducted based on the estimated non-CO(2) emission factors, and the ranges of uncertainty for CH(4) and N(2)O were between −12.96 and +13.89 %, and −11.43 and +12.86 %, respectively, which is significantly lower than uncertainties presented by IPCC. These differences proved that non-CO(2) emissions can change depending on combustion technologies; therefore, it is vital to establish country/technology-specific emission factors.