Cargando…
Spring constant of a tuning-fork sensor for dynamic force microscopy
We present an overview of experimental and numerical methods to determine the spring constant of a quartz tuning fork in qPlus configuration. The simple calculation for a rectangular cantilever is compared to the values obtained by the analysis of the thermal excitation and by the direct mechanical...
Autores principales: | van Vörden, Dennis, Lange, Manfred, Schmuck, Merlin, Schmidt, Nico, Möller, Rolf |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
Beilstein-Institut
2012
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC3555690/ https://www.ncbi.nlm.nih.gov/pubmed/23365793 http://dx.doi.org/10.3762/bjnano.3.90 |
Ejemplares similares
-
A measurement of the hysteresis loop in force-spectroscopy curves using a tuning-fork atomic force microscope
por: Lange, Manfred, et al.
Publicado: (2012) -
Calibration of quartz tuning fork spring constants for non-contact atomic force microscopy: direct mechanical measurements and simulations
por: Falter, Jens, et al.
Publicado: (2014) -
Photo-Induced Force Microscopy by Using Quartz Tuning-Fork Sensor
por: Jahng, Junghoon, et al.
Publicado: (2019) -
Atomic Force Microscopy Sidewall Imaging with a Quartz Tuning Fork Force Sensor
por: Hussain, Danish, et al.
Publicado: (2018) -
Equivalent Electromechanical Model for Quartz Tuning Fork Used in Atomic Force Microscopy
por: Lin, Rui, et al.
Publicado: (2023)