Cargando…
Investigation on the Achievable Flow Length in Injection Moulding of Polymeric Materials with Dynamic Mould Tempering
A variety of parts in microsystems technology are manufactured by injection moulding of polymeric materials. In Particular the high cooling velocity affects negatively the process and the resulting part properties. The scope of this paper is to investigate the influence on the reachable flow length...
Autores principales: | Meister, Steve, Drummer, Dietmar |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
Hindawi Publishing Corporation
2013
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC3732639/ https://www.ncbi.nlm.nih.gov/pubmed/23970840 http://dx.doi.org/10.1155/2013/845916 |
Ejemplares similares
-
Effect of Process Parameters on Flow Length and Flash Formation in Injection Moulding of High Aspect Ratio Polymeric Micro Features
por: Eladl, Abdelkhalik, et al.
Publicado: (2018) -
Effects of Mould Temperature on Rice Bran-Based Bioplastics Obtained by Injection Moulding
por: Alonso-González, María, et al.
Publicado: (2021) -
Comparing the Replication Fidelity of Solid Microneedles Using Injection Compression Moulding and Conventional Injection Moulding
por: Evens, Tim, et al.
Publicado: (2022) -
Moulding
por: Holmes, E. S.
Publicado: (1850) -
Influence of the material for preformed moulds on the polymerization temperature of resin materials for temporary FPDs
por: Pott, Philipp-Cornelius, et al.
Publicado: (2017)