Cargando…

The influence of a new sole geometry while running

Running shoe construction influences the forces experienced by the human body while running. The aim of this study was to ascertain whether the new sole architecture of the On running shoe reduces ground reaction forces compared with running barefoot or with a conventional running shoe and whether i...

Descripción completa

Detalles Bibliográficos
Autores principales:	Knoepfli-Lenzin, Claudia, Waech, Jennifer Carole, Gülay, Turgut, Schellenberg, Florian, Lorenzetti, Silvio
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Routledge 2014
Materias:	Biomechanics
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4160293/ https://www.ncbi.nlm.nih.gov/pubmed/24977468 http://dx.doi.org/10.1080/02640414.2014.915421

Ejemplares similares

The grazing gait, and implications of toppling table geometry for primate footfall sequences
por: Usherwood, James R., et al.
Publicado: (2018)

Inverted pendular running: a novel gait predicted by computer optimization is found between walk and run in birds
por: Usherwood, James Richard
Publicado: (2010)

A little damping goes a long way: a simulation study of how damping influences task-level stability in running
por: Heim, Steve, et al.
Publicado: (2020)

Vaulting mechanics successfully predict decrease in walk–run transition speed with incline
por: Hubel, Tatjana Y., et al.
Publicado: (2013)

Visual feedback influences the consistency of the locomotor pattern in Asian elephants (Elephas maximus)
por: Kurz, Max J., et al.
Publicado: (2023)

Thickness of simple calcaneal tuberosity avulsion fractures influences the optimal fixation method employed
por: Wang, Chunliang, et al.
Publicado: (2023)

Experimental and numerical investigation into the influence of loading conditions in biomechanical testing of locking plate fracture fixation devices
por: MacLeod, A., et al.
Publicado: (2018)

Enthalpy efficiency of the soleus muscle contributes to improvements in running economy
por: Bohm, Sebastian, et al.
Publicado: (2021)

Pitch then power: limitations to acceleration in quadrupeds
por: Williams, Sarah B., et al.
Publicado: (2009)

Constraints on muscle performance provide a novel explanation for the scaling of posture in terrestrial animals
por: Usherwood, James R.
Publicado: (2013)

Can Prevention of a Reherniation Be Investigated? Establishment of a Herniation Model and Experiments With an Anular Closure Device
por: Wilke, Hans-Joachim, et al.
Publicado: (2013)

A kinematic analysis of the spine during rugby scrummaging on natural and synthetic turfs
por: Swaminathan, Ramesh, et al.
Publicado: (2016)

L5 – S1 Segmental Kinematics After Facet Arthroplasty
por: Voronov, Leonard I., et al.
Publicado: (2009)

Kinematics of total facet replacement (TFAS-TL) with total disc replacement
por: Voronov, Leonard I., et al.
Publicado: (2009)

Biomechanical evaluation of a spherical lumbar interbody device at varying levels of subsidence
por: Rundell, Steven A., et al.
Publicado: (2011)

Measurement of occlusion of the spinal canal and intervertebral foramen by intervertebral disc bulge
por: Cuchanski, Mathieu, et al.
Publicado: (2011)

A comparison of the shock-absorbing properties of cervical disc prosthesis bearing materials
por: Dahl, Michael C., et al.
Publicado: (2011)

In Vivo Assessment of Bone Graft/Endplate Contact Pressure in a Caprine Interbody Pseudarthrosis Model: A Preliminary Biomechanical Characterization of the Fusion Process for the Development of a Microelectromechanical Systems (MEMS) Biosensor
por: Ferrara, Lisa A., et al.
Publicado: (2008)

Male Spine Motion During Coitus: Implications for the Low Back Pain Patient
por: Sidorkewicz, Natalie, et al.
Publicado: (2014)

Improving paddling efficiency through raising sitting height in female white water kayakers
por: Broomfield, Shelley A. L., et al.
Publicado: (2015)

Validation of Moticon’s OpenGo sensor insoles during gait, jumps, balance and cross-country skiing specific imitation movements
por: Stöggl, Thomas, et al.
Publicado: (2017)

Structural biomechanics determine spectral purity of bush-cricket calls
por: Chivers, Benedict D., et al.
Publicado: (2017)

Marker free model-based radiostereometric analysis for evaluation of hip joint kinematics: A validation study
por: Hansen, L., et al.
Publicado: (2018)

Biomechanical behaviour of a French femoral component with thin cement mantle: The ‘French paradox’ may not be a paradox after all
por: Numata, Y., et al.
Publicado: (2018)

Effects of mechanical forces on osteogenesis and osteoclastogenesis in human periodontal ligament fibroblasts: A systematic review of in vitro studies
por: Li, M., et al.
Publicado: (2019)

Time-dependent behaviour of bone accentuates loosening in the fixation of fractures using bone-screw systems
por: Xie, S., et al.
Publicado: (2018)

Relative movement on the articular surfaces of the tibiotalar and subtalar joints during walking
por: Phan, C-B., et al.
Publicado: (2018)

The effect of malalignment on proximal tibial strain in fixed-bearing unicompartmental knee arthroplasty: A comparison between metal-backed and all-polyethylene components using a validated finite element model
por: Danese, I., et al.
Publicado: (2019)

The dynamic role of the ilio-sacral joint in jumping frogs
por: Richards, Christopher T., et al.
Publicado: (2018)

Spinal Tissue Loading Created by Different Methods of Spinal Manipulative Therapy Application
por: Funabashi, Martha, et al.
Publicado: (2017)

The effect of plate design, bridging span, and fracture healing on the performance of high tibial osteotomy plates: An experimental and finite element study
por: MacLeod, A. R., et al.
Publicado: (2019)

Screw head plugs increase the fatigue strength of stainless steel, but not of titanium, locking plates
por: Hung, L-W., et al.
Publicado: (2019)

Half-threaded holes markedly increase the fatigue life of locking plates without compromising screw stability
por: Chao, Ching-Kong, et al.
Publicado: (2020)

Biomechanical evaluation of locked plating fixation for unstable femoral neck fractures
por: Bliven, E., et al.
Publicado: (2020)

Biomechanical evaluation of a novel double rip-stop technique with medial row knots for rotator cuff repair: an in vitro study
por: Wang, Zhanwen, et al.
Publicado: (2020)

Effect of material selection on tibial post stresses in posterior-stabilized knee prosthesis: a comparison among conventional, cross-linked, and vitamin E-stabilized polyethylene
por: Huang, Chang-Hung, et al.
Publicado: (2020)

Restoration of normal knee kinematics with respect to tibial insert design in mobile bearing lateral unicompartmental arthroplasty using computational simulation
por: Koh, Yong-Gon, et al.
Publicado: (2020)

Effects of condensation and compressive strain on implant primary stability: A longitudinal, in vivo, multiscale study in mice
por: Li, Zhijun, et al.
Publicado: (2020)

Stripping torques in human bone can be reliably predicted prior to screw insertion with optimum tightness being found between 70% and 80% of the maximum
por: Fletcher, James W. A., et al.
Publicado: (2020)

The 17β-oestradiol treatment minimizes the adverse effects of protein restriction on bone parameters in ovariectomized Wistar rats: Relevance to osteoporosis and the menopause
por: de Quadros, Victoria P., et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_os6956unov8rqusdvnmfd02o88