Cargando…

IN VITRO STUDY OF THE PULP CHAMBER TEMPERATURE RISE DURING LIGHT-ACTIVATED BLEACHING

This study evaluated in vitro the pulp chamber temperature rise induced by the light-activated dental bleaching technique using different light sources. The root portions of 78 extracted sound human mandibular incisors were sectioned approximately 2 mm below the cementoenamel junction. The root cavi...

Descripción completa

Detalles Bibliográficos
Autores principales:	Carrasco, Thaise Graciele, Carrasco-Guerisoli, Laise Daniela, Fröner, Izabel Cristina
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Faculdade de Odontologia de Bauru da Universidade de São Paulo 2008
Materias:	Original Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4327603/ https://www.ncbi.nlm.nih.gov/pubmed/19089234 http://dx.doi.org/10.1590/S1678-77572008000500010

Ejemplares similares

EFFECTIVENESS OF HOME BLEACHING AGENTS IN DISCOLORED TEETH AND INFLUENCE ON ENAMEL MICROHARDNESS
por: Delfino, Carina Sinclér, et al.
Publicado: (2009)

Comparison of temperature rise in the pulp chamber with different light curing units: An in-vitro study
por: Rajesh Ebenezar, A V, et al.
Publicado: (2010)

In-office dental bleaching with violet light emitting diode: bleaching efficacy and pulpal temperature rise
por: Guanaes, Brunna Katyuscia de Almeida, et al.
Publicado: (2022)

Temperature Rise Within the Pulp Chamber During Composite Resin Polymerisation Using Three Different Light Sources
por: Santini, A, et al.
Publicado: (2008)

Temperature Rises in the Pulp Chamber with Different Techniques of Orthodontic Adhesive Removal
por: Mezomo, Maurício Barbieri, et al.
Publicado: (2017)

Temperature changes in the pulp chamber and bleaching gel during tooth bleaching assisted by diode laser (445 nm) using different power settings
por: Papadopoulou, Aggeliki, et al.
Publicado: (2023)

Pulp chamber temperature rise in light-cure bonding of brackets with and without primer, in intact versus restored teeth
por: SCHMITZ, Gabriela Cenci, et al.
Publicado: (2023)

Comparison of temperature rise in pulp chamber during polymerization of materials used for direct fabrication of provisional restorations: An in-vitro study
por: Khajuria, Rajat R., et al.
Publicado: (2015)

An in-vitro study to compare the temperature rise in the pulp chamber by direct method using three different provisional restorative materials
por: Piplani, Ankita, et al.
Publicado: (2016)

EVALUATION OF APICAL MICROLEAKAGE OF TEETH SEALED WITH FOUR DIFFERENT ROOT CANAL SEALERS
por: Dultra, Fábio, et al.
Publicado: (2006)

Resin Bonding of Self-Etch Adhesives to Bovine Dentin Bleached from Pulp Chamber
por: Haruyama, Akiko, et al.
Publicado: (2016)

Temperature Changes of Pulp Chamber during In Vitro Laser Welding of Orthodontic Attachments
por: İşman, Eren, et al.
Publicado: (2014)

Comparison of in vivo and in vitro models to evaluate pulp temperature rise during exposure to a Polywave(®) LED light curing unit
por: Runnacles, Patricio, et al.
Publicado: (2019)

Pulp Temperature Rise Induced by Light-Emitting Diode Light-Curing Units Using an Ex Vivo Model
por: Vinagre, Alexandra, et al.
Publicado: (2019)

Pulpal Temperature Rise: Evaluation after Light Activation of Newer Pulp-Capping Materials and Resin Composite
por: Lakhani, Jash, et al.
Publicado: (2018)

Change in the pulp chamber temperature with different stripping techniques
por: Pereira, José Carlos d’Ornellas, et al.
Publicado: (2014)

Evaluation of temperature rise in the pulp during various IPR techniques—an in vivo study
por: Banga, Kiran, et al.
Publicado: (2020)

Does the heat generated by fluorescence-aided caries excavation system effect the pulp temperature of primary teeth irreversibly? An in-vitro evaluation of the temperature changes in the pulp chamber
por: Aksoy, Merve, et al.
Publicado: (2021)

In Vitro Infrared Thermographic Assessment of Temperature Change in the Pulp Chamber during Provisionalization: Effect of Remaining Dentin Thickness
por: Lipski, Mariusz, et al.
Publicado: (2020)

Laser Teeth Bleaching: Evaluation of Eventual Side Effects on Enamel and the Pulp and the Efficiency In Vitro and In Vivo
por: De Moor, Roeland Jozef Gentil, et al.
Publicado: (2015)

Temperature Rise In The SPS Vacuum Chamber Due To Loss Of Electrons
por: Stevenson, Graham Roger
Publicado: (1980)

Dissolution and Hydrolysis of Bleached Kraft Pulp Using Ionic Liquids
por: Reyes, Guillermo, et al.
Publicado: (2019)

Real-Time Analysis of Temperature Changes in Composite Increments and Pulp Chamber during Photopolymerization
por: Kim, Ryan Jin-Young, et al.
Publicado: (2015)

Inflammatory response of human dental pulp to at-home and in-office tooth bleaching
por: Vaz, Maysa Magalhães, et al.
Publicado: (2016)

PHOTOCHEMISTRY OF VISUAL PURPLE : II. THE EFFECT OF TEMPERATURE ON THE BLEACHING OF VISUAL PURPLE BY LIGHT.
por: Hecht, Selig
Publicado: (1921)

The effect of cold-light-activated bleaching treatment on enamel surfaces in vitro
por: Shi, Xin-Chang, et al.
Publicado: (2012)

Lime Formations in the Pulp-Chamber
por: Kirk, Edward C.
Publicado: (1893)

Evaluation of temperature increase during in-office bleaching
por: MONDELLI, Rafael Francisco Lia, et al.
Publicado: (2016)

Temperature change in pulp chamber of primary teeth during curing of coloured compomers: an in vitro study using pulpal blood microcirculation model
por: Ertuğrul, Ceylan Çağıl, et al.
Publicado: (2019)

Evaluation of the Pulp Chamber Temperature during Tooth Veneer Preparation Using Burs with Different Degrees of Wear—A Preliminary In Vitro Study
por: Ciora, Edmond, et al.
Publicado: (2023)

Treatment of the Bleaching Effluent from Sulfite Pulp Production by Ceramic Membrane Filtration
por: Ebrahimi, Mehrdad, et al.
Publicado: (2015)

Pulp response of rats submitted to bleaching and the use of different anti-inflammatory drugs
por: Gallinari, Marjorie de Oliveira, et al.
Publicado: (2019)

Safety assessment of bleached cellulose pulp for use in plastic food contact materials
por: Lambré, Claude, et al.
Publicado: (2022)

Effect of cooling water temperature on the temperature changes in pulp chamber and at handpiece head during high-speed tooth preparation
por: Farah, Ra'fat I.
Publicado: (2018)

THE INTERPLAY OF LIGHT AND HEAT IN BLEACHING RHODOPSIN
por: St. George, Robert C. C.
Publicado: (1952)

Effect of High Light Intensity Bleaching Protocol versus Descending Light Intensities Bleaching Protocol on Post Bleaching Teeth Sensitivity: A Randomized Clinical Trial
por: Kabil, Shadwa H., et al.
Publicado: (2019)

Temperature increases in primary teeth pulp chamber during polymerization of glass ionomer-based restorative materials
por: Buyukkok, Cigdem, et al.
Publicado: (2021)

One-Step Treatment for Upgrading Bleached Bamboo Pulp to Dissolving Pulp High Solvency in Green Alkali/Urea Aqueous Solution
por: Shang, Jiao-Ping, et al.
Publicado: (2023)

Effects of the Preferential Oxidation of Phenolic Lignin Using Chlorine Dioxide on Pulp Bleaching Efficiency
por: Liu, Yi, et al.
Publicado: (2022)

Use of a Novel Extremophilic Xylanase for an Environmentally Friendly Industrial Bleaching of Kraft Pulps
por: Almeida, Nazaré, et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_h5hiu6mr350ifin5vf9jcr4q6i