Cargando…

Extreme lithium isotopic fractionation in three zircon standards (Plešovice, Qinghu and Temora)

To understand the behavior of Li in zircon, we have analyzed the abundance and isotopic composition of Li in three zircon standards (Plešovice, Qinghu and Temora) widely used for microbeam analysis of U-Pb ages and O-Hf isotopes. We have mapped Li concentration ([Li]) on large grains, using a Cameca...

Descripción completa

Detalles Bibliográficos
Autores principales: Gao, Yu-Ya, Li, Xian-Hua, Griffin, William L., Tang, Yan-Jie, Pearson, Norman J., Liu, Yu, Chu, Mei-Fei, Li, Qiu-Li, Tang, Guo-Qiang, O’Reilly, Suzanne Y.
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Nature Publishing Group 2015
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4655365/
https://www.ncbi.nlm.nih.gov/pubmed/26594042
http://dx.doi.org/10.1038/srep16878
Descripción
Sumario:To understand the behavior of Li in zircon, we have analyzed the abundance and isotopic composition of Li in three zircon standards (Plešovice, Qinghu and Temora) widely used for microbeam analysis of U-Pb ages and O-Hf isotopes. We have mapped Li concentration ([Li]) on large grains, using a Cameca 1280HR Secondary Ion Mass Spectrometer (SIMS). All zircons have a rim 5–20 μm wide in which [Li] is 5 to 20 times higher than in the core. Up to ~20‰ isotopic fractionation is observed on a small scale in the rims of a single zircon grain. The measured δ(7)Li values range from –14.3 to 3.7‰ for Plešovice, –22.8 to 1.4‰ for Qinghu and –4.7 to 16.1‰ for Temora zircon. The [Li] and δ(7)Li are highly variable at the rims, but relatively homogenous in the cores of the grains. From zircon rim to core, [Li] decreases rapidly, while δ(7)Li increases, suggesting that the large isotopic variation of Li in zircons could be caused by diffusion. Our data demonstrate that homogeneous δ(7)Li in the cores of zircon can retain the original isotopic signatures of the magmas, while the bulk analysis of Li isotopes in mineral separates and in bulk-rock samples may produce misleading data.