Cargando…

Effect of different gingival margin restorations of class II cavities on microleakage: an in-vitro study

INTRODUCTION: Microleakage is one of the important contributing factors in the failure of resin restorations. The aim of this study was to determine the effect of the location of the gingival margin (enamel, dentin, or cementum) on nanohybrid composite resin on the microleakage of Class II posterior...

Descripción completa

Detalles Bibliográficos
Autores principales:	Mahrous, Ahmed Ibrahim, Eltiti, Hani Abdulmoniem, Ahmed, Iffat Mirza, Alagha, Ebaa Ibrahim
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Electronic physician 2015
Materias:	Original Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4700887/ https://www.ncbi.nlm.nih.gov/pubmed/26767095 http://dx.doi.org/10.19082/1435

Ejemplares similares

Microleakage Evaluation in Class V Cavities Restored with Five Different Resin Composites: In vitro Dye Leakage Study
por: Bajabaa, Sahar, et al.
Publicado: (2021)

Microleakage in Class II composite restorations with margins below the CEJ: In vitro evaluation of different restorative techniques
por: Poggio, Claudio, et al.
Publicado: (2013)

Evaluation of gingival microleakage of class II resin composite restorations with fiber inserts: An in vitro study
por: Basavanna, RS, et al.
Publicado: (2012)

Evaluation of Gingival Microleakage in Class II Composite Restorations with Different Lining Techniques: An In Vitro Study
por: Bore Gowda, Vedavathi, et al.
Publicado: (2015)

Effect of different placement techniques on marginal microleakage of deep class-II cavities restored with two composite resin formulations
por: M, Radhika, et al.
Publicado: (2010)

In vitro microleakage at the enamel and dentin margins of class II cavities of primary molars restored with a bulk‐fill and a conventional composite
por: Mosharrafian, Shahram, et al.
Publicado: (2023)

Finite Element Analysis of Restored Principal Abutment in Free-End Saddle Partial Denture
por: Mahrous, Ahmed, et al.
Publicado: (2022)

Effect of Different Bonding Techniques on Marginal Adaptation of Harmonize Composite Resin at Different Storage Times
por: Alagha, Ebaa Ibrahim
Publicado: (2021)

Comparison of microleakage between different restorative materials to restore marginal gap at crown margin
por: Haralur, Satheesh B., et al.
Publicado: (2021)

Evaluation of microleakage in class-II bulk-fill composite restorations
por: Turkistani, Alaa, et al.
Publicado: (2020)

Assessment of Microleakage in Class II Cavities having Gingival Wall in Cementum using Three Different Posterior Composites
por: Narayana, Vanamala, et al.
Publicado: (2014)

Evaluation of Microleakage in Class II Cavities using Packable Composite Restorations with and without use of Liners
por: Arora, Rajesh, et al.
Publicado: (2012)

Comparing marginal microleakage of three Bulk Fill composites in Class II cavities using confocal microscope: An in vitro study
por: Swapna, Manne Udaya, et al.
Publicado: (2015)

Comparative evaluation of microleakage in class II cavities restored with Ceram X and Filtek P-90: An in vitro study
por: Bogra, Poonam, et al.
Publicado: (2012)

Comparison of three adhesive systems in class II composite restorations in endodontically treated teeth: Influence of Er:YAG laser conditioning and gingival margin levels on microleakage
por: Onay, Emel-Olga, et al.
Publicado: (2018)

Effect of the Combination of Restorative Material and the Etching Protocol in Enamel Microleakage in Class II Cavities after Thermocycling
por: Dutra, Natalia Menezes Santana, et al.
Publicado: (2023)

Evaluation of Marginal Adaptation and Microleakage of Three Glass Ionomer-Based Class V Restorations: In Vitro Study
por: Ebaya, Maha M., et al.
Publicado: (2019)

Analysis of microleakage and marginal gap presented by new polymeric systems in class V restorations: An in vitro study
por: Pereira, Jefferson Ricardo, et al.
Publicado: (2021)

Evaluation of Class II Restoration Microleakage with Various Restorative Materials: A Comparative In vitro Study
por: Pawar, Madhura, et al.
Publicado: (2021)

Nanoleakage of Class V Resin Restorations Using Two Nanofilled Adhesive Systems
por: Al-Agha, Ebaa I, et al.
Publicado: (2015)

Decision tree protocol for demineralized gingival margin extension in class II composite cavity preparations
por: Yamakami, Shelyn Akari, et al.
Publicado: (2021)

Dentine deproteinization and microleakage around gingival third resin restorations
por: Shetty, Sowmya, et al.
Publicado: (2008)

Micro-computed tomography evaluation of microleakage of Class II composite restorations: An in vitro study
por: Zavattini, Angelo, et al.
Publicado: (2018)

The Effect of Scuba Diving on Microleakage of a Class II Composite Restoration: An In-Vitro Study
por: Shahnavazi, Maryam, et al.
Publicado: (2021)

Effect of cavity preparation techniques and different preheating procedures on microleakage of class V resin restorations
por: Karaarslan, Emine Sirin, et al.
Publicado: (2012)

Comparison of microleakage in Class II cavities restored with silorane-based and methacrylate-based composite resins using different restorative techniques over time
por: Khosravi, Kazem, et al.
Publicado: (2015)

Evaluation of Immediate and Delayed Microleakage of Class V Cavities Restored with Chitosan-incorporated Composite Resins: An In Vitro Study
por: Deb, Arpita, et al.
Publicado: (2021)

Microleakage around Class V Composite Restorations after Ultrasonic Scaling and Sonic Toothbrushing around their Margin
por: Goldstein, Ronald E., et al.
Publicado: (2016)

An in vitro evaluation of the effects of desensitizing agents on microleakage of Class V cavities
por: Yikilgan, İhsan, et al.
Publicado: (2016)

Effect of Thermo-mechanical Load Cycling on Microleakage in Class II Ormocer Restorations
por: Erdilek, Dina, et al.
Publicado: (2009)

Does Bleaching Affect the Microleakage of Class II Restoration with Bulk-Fill Composite?
por: Zajkani, Elham, et al.
Publicado: (2022)

Microbial microleakage assessment of class V cavities restored with different materials and techniques: A laboratory study
por: Nematollahi, Hossein, et al.
Publicado: (2017)

Microleakage and Marginal Integrity of Ormocer/Methacrylate-Based Bulk-Fill Resin Restorations in MOD Cavities: SEM and Stereomicroscopic Evaluation
por: Şenol, Aslı A., et al.
Publicado: (2023)

Microleakage Evaluation in Class V Cavities Restored with Five Different Resin Composites: In vitro Dye Leakage Study [Corrigendum]
Publicado: (2021)

Microleakage of Restorative Materials Used for Temporization of Endodontic Access Cavities
por: Wuersching, Sabina Noreen, et al.
Publicado: (2023)

A comparative evaluation of microleakage of restorations using silorane-based dental composite and methacrylate-based dental composites in Class II cavities: An in vitro study
por: Sivakumar, Jambai Sampath Kumar, et al.
Publicado: (2016)

Microleakage of Four Dental Cements in Metal Ceramic Restorations With Open Margins
por: Eftekhar Ashtiani, Reza, et al.
Publicado: (2015)

Evaluation of microleakage in Class II composite restorations: Bonded-base and bulk-fill techniques
por: Feiz, Atiyeh, et al.
Publicado: (2021)

Assessing microleakage of composite restorations in class V cavities prepared by Er:YAG laser irradiation or diamond bur
por: Arami, Sakineh, et al.
Publicado: (2014)

Comparison of self-adhering flowable composite microleakage with several types of bonding agent in class V cavity restoration
por: Jordehi, Atefeh Yousefi, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_28rba564fjkpu8fq3dn1a4i6rq