Cargando…

Three-dimensional evaluation of surface roughness of resin composites after finishing and polishing

AIM: This study aims to investigate the effects of finishing and polishing procedures on four novel resin composites using three-dimensional optical profilometer. MATERIALS AND METHODS: Four composites classified according to their filler size, were selected: Filtek™ Z350 XT/Nanofill (3M™ ESPE™), Es...

Descripción completa

Detalles Bibliográficos
Autores principales: Nair, Veena S, Sainudeen, Shan, Padmanabhan, Prabeesh, Vijayashankar, L V, Sujathan, Unu, Pillai, Rajesh
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Medknow Publications & Media Pvt Ltd 2016
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4760024/
https://www.ncbi.nlm.nih.gov/pubmed/26957802
http://dx.doi.org/10.4103/0972-0707.173208
Descripción
Sumario:AIM: This study aims to investigate the effects of finishing and polishing procedures on four novel resin composites using three-dimensional optical profilometer. MATERIALS AND METHODS: Four composites classified according to their filler size, were selected: Filtek™ Z350 XT/Nanofill (3M™ ESPE™), Esthet-X HD/Hybrid (Dentsply Caulk), Te Econom/Microfill (Ivoclar Vivadent(®)), Tetric EvoCeram(®) /Nanohybrid (Ivoclar Vivadent(®)). Composite specimens were made in Plexiglass mold and polished with Soflex (3M ESPE), Enhance + Pogo (Dentsply Caulk). Both the systems were used according to the manufacturers’ instructions, and the polished surfaces were assessed with an optical profilometer. STATISTICAL ANALYSIS USED: Kruskal-Wallis test and further pairwise comparison were performed by Mann-Whitney test. RESULTS: The smoothest surfaces for all the resin composites tested were obtained from the Mylar strip; statistically significant differences were observed among them (P = 0.001). The order of composites was ranked from the lowest to highest surface roughness; Filtek Z350 XT < Te Econom < Tetric EvoCeram < Esthet XHD. Pairwise multiple comparison with Mann-Whitney test showed Filtek Z350 to have the smoothest surface and the least with Teric EvoCeram. Among the polishing systems, Soflex showed the smoothest surface and was significantly different from Pogo (P = 0.046). CONCLUSIONS: The effectiveness of the polishing systems seems to be dependent on the material used, treatment modality and also on the filler particle size.