Effect of clay nanoparticles on model lung surfactant: a potential marker of hazard from nanoaerosol inhalation

This work investigates influence of different aluminosillicate nanoparticles (NPs) which are found in air in selected workplaces on the properties of the phospholipid (DPPC) monolayer at air–saline interface considered as ex vivo model of the lung surfactant (LS). The measurements were done under physiological-like conditions (deformable liquid interface at 37 °C) for NP concentrations matching the calculated lung doses after exposure in the working environment. Measured surface pressure–area (π–A) isotherms and compressibility curves demonstrated NP-induced changes in the structure and mechanical properties of the lipid monolayer. It was shown that hydrophilic nanomaterials (halloysite and bentonite) induced concentration-dependent impairment of DPPC’s ability of attaining high surface pressures on interfacial compression, suggesting a possibility of reduction of physiological function of natural LS. Hydrophobic montmorillonites affected DPPC monolayer in the opposite way; however, they significantly changed the mechanical properties of the air–liquid interface during compression. The results support the hypothesis of possible reduction or even degradation of the natural function of the lung surfactant induced by particle–phospholipid interactions after inhalation of nanoclays. Presented data do not only supplement the earlier results obtained with another LS model (animal-derived surfactant in oscillating bubble experiments) but also offer an explanation of physicochemical mechanisms responsible for detrimental effects which arise after deposition of inhaled nanomaterials on the surface of the respiratory system.