Cargando…
Data analysis and other considerations concerning the study of precipitation in Al–Mg–Si alloys by Atom Probe Tomography
Atom Probe Tomography (APT) analysis and hardness measurements were used to characterize the early stages of precipitation in an Al–0.51 at%Mg–0.94 at%Si alloy as reported in the accompanying Acta Materialia paper [1]. The changes in microstructure were investigated after single-stage or multi-stage...
Autores principales: | Zandbergen, M.W., Xu, Q., Cerezo, A., Smith, G.D.W. |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
Elsevier
2015
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4773378/ https://www.ncbi.nlm.nih.gov/pubmed/26958619 http://dx.doi.org/10.1016/j.dib.2015.09.045 |
Ejemplares similares
-
Data on atomic structures of precipitates in an Al-Mg-Cu alloy studied by high resolution transmission electron microscopy and first-principles calculations
por: Chen, Xuanliang, et al.
Publicado: (2021) -
Aging Behavior and Precipitates Analysis of Wrought Al-Si-Mg Alloy
por: Liu, Fang, et al.
Publicado: (2022) -
Influence of Zn and Sn on the Precipitation Behavior of New Al–Mg–Si Alloys
por: Glöckel, Felix, et al.
Publicado: (2019) -
The Effect of Cu Addition on the Precipitation Sequence in the Al-Si-Mg-Cr Alloy
por: Chen, Bin, et al.
Publicado: (2022) -
Effects of the Mg/Si Ratio on Microstructure, Mechanical Properties, and Precipitation Behavior of Al–Mg–Si–1.0 wt %-Zn Alloys
por: Li, Yong, et al.
Publicado: (2018)