Cargando…

Three-Dimensional Assessment of Volumetric Changes in Sinuses Augmented with Two Different Bone Substitutes

Introduction. The bone volume of the posterior maxilla may not be appropriate for implant placement, due to factors such as pneumatized maxillary sinus. The purpose of this study was to evaluate the percentage of graft volume reduction following sinus floor elevation (SFE), with either slow resorbab...

Descripción completa

Detalles Bibliográficos
Autores principales:	Gultekin, B. Alper, Borahan, Oguz, Sirali, Ali, Karabuda, Z. Cuneyt, Mijiritsky, Eitan
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Hindawi Publishing Corporation 2016
Materias:	Clinical Study
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4969509/ https://www.ncbi.nlm.nih.gov/pubmed/27517044 http://dx.doi.org/10.1155/2016/4085079

Ejemplares similares

Does the Laser-Microtextured Short Implant Collar Design Reduce Marginal Bone Loss in Comparison with a Machined Collar?
por: Gultekin, B. Alper, et al.
Publicado: (2016)

Comparison of Bone Resorption Rates after Intraoral Block Bone and Guided Bone Regeneration Augmentation for the Reconstruction of Horizontally Deficient Maxillary Alveolar Ridges
por: Gultekin, B. Alper, et al.
Publicado: (2016)

Maxillary Sinus Floor Augmentation to Enable One-Stage Implant Placement by Using Bovine Bone Substitute and Platelet-Rich Fibrin
por: Barbu, Horia Mihail, et al.
Publicado: (2018)

Histologic, Histomorphometric, and Clinical Analysis of the Effects of Growth Factors in a Fibrin Network Used in Maxillary Sinus Augmentation
por: Cinar, Ihsan Caglar, et al.
Publicado: (2020)

Comparison between Micro-Computed Tomography and Cone-Beam Computed Tomography in the Assessment of Bone Quality and a Long-Term Volumetric Study of the Augmented Sinus Grafted with an Albumin Impregnated Allograft
por: Kivovics, Márton, et al.
Publicado: (2020)

Three-dimensional linear and volumetric analysis of maxillary sinus pneumatization
por: Hamdy, Reham M., et al.
Publicado: (2014)

Clinical evaluation of the stability of implants placed at different supracrestal levels
por: Gultekin, B. Alper, et al.
Publicado: (2016)

Three-dimensional linear and volumetric computed tomography analysis of the frontal sinus
por: Park, Jung-Ah, et al.
Publicado: (2022)

Radiographic Comparison of Bovine Bone Substitute Alone Versus Bovine Bone Substitute and Simvastatin for Human Maxillary Sinus Augmentation
por: Yaghobee, Siamak, et al.
Publicado: (2018)

Volumetric analysis of bone substitute material performance within the human sinus cavity of former head and neck cancer patients: A prospective, randomized clinical trial
por: Lorenz, Jonas, et al.
Publicado: (2016)

Allograft and Collagen Membrane Augmentation Procedures Preserve the Bone Level around Implants after Immediate Placement and Restoration
por: Kolerman, Roni, et al.
Publicado: (2020)

Barbell Technique for Three-Dimensional Bone Augmentation
por: Nunes, Marcelo Pereira, et al.
Publicado: (2023)

Microarchitecture of the Augmented Bone Following Sinus Elevation with an Albumin Impregnated Demineralized Freeze-Dried Bone Allograft (BoneAlbumin) versus Anorganic Bovine Bone Mineral: A Randomized Prospective Clinical, Histomorphometric, and Micro-Computed Tomography Study
por: Márton, Kivovics, et al.
Publicado: (2018)

Three-dimensional intraoperative computed tomography imaging for zygomatic fracture repair
por: Peleg, Oren, et al.
Publicado: (2021)

Maxillary Sinus Floor Augmentation with Autogenous Bone Graft Compared with a Composite Grafting Material or Bone Substitute Alone: a Systematic Review and Meta-Analysis Assessing Volumetric Stability of the Grafting Material
por: Starch-Jensen, Thomas, et al.
Publicado: (2021)

Synthetic Bone Substitute Engineered with Amniotic Epithelial Cells Enhances Bone Regeneration after Maxillary Sinus Augmentation
por: Barboni, Barbara, et al.
Publicado: (2013)

Effect of Septal Deviation, Concha Bullosa and Haller’s Cell on Maxillary Sinus’s Inferior Pneumatization; a Retrospective Study
por: Göçmen, Gökhan, et al.
Publicado: (2015)

Aspergillus fumigatus biofilm formation on different bone substitutes used in maxillary sinus augmentation: an in vitro analysis
por: Stacchi, Claudio, et al.
Publicado: (2019)

Volumetric techniques: three-dimensional midface modeling
por: Macierzyńska, Arleta, et al.
Publicado: (2014)

The use of hydroxyapatite bone substitute grafting for alveolar ridge preservation, sinus augmentation, and periodontal bone defect: A systematic review
por: Dewi, Anne Handrini, et al.
Publicado: (2018)

Sinus augmentation using rhBMP-2-loaded synthetic bone substitute with simultaneous implant placement in rabbits
por: Joo, Myung-Jae, et al.
Publicado: (2017)

Volumetric study of the maxillary sinus in patients with sinus pathology
por: Pérez Sayáns, Mario, et al.
Publicado: (2020)

Comparative Study on the Efficacy of Anorganic Bovine Bone (Bio-Oss) and Nanocrystalline Hydroxyapatite (Ostim) in Maxillary Sinus Floor Augmentation
por: Shirmohammadi, Adileh, et al.
Publicado: (2014)

Use of Three-dimensional Mapping to Identify an Alternating Atrial Activation Pattern in the Coronary Sinus
por: Sundaram, Sri A., et al.
Publicado: (2018)

15-Year Retrospective Study on the Success Rate of Maxillary Sinus Augmentation and Implants: Influence of Bone Substitute Type, Presurgical Bone Height, and Membrane Perforation during Sinus Lift
por: Jamcoski, Vanessa Helena, et al.
Publicado: (2023)

Immediate Maxillary Full-Arch Rehabilitation of Periodontal Patients with Terminal Dentition Using Tilted Implants and Bone Augmentation: A 5-Year Retrospective Cohort Study
por: Slutzkey, Gil S., et al.
Publicado: (2022)

Presence of ROS in Inflammatory Environment of Peri-Implantitis Tissue: In Vitro and In Vivo Human Evidence
por: Mijiritsky, Eitan, et al.
Publicado: (2019)

Systematic Parameterization, Storage, and Representation of Volumetric DICOM Data
por: Fischer, Felix, et al.
Publicado: (2015)

Correlation between Primary, Secondary Stability, Bone Density, Percentage of Vital Bone Formation and Implant Size
por: Ivanova, Vasilena, et al.
Publicado: (2021)

CBCT Study of Morphologic Variations of Maxillary Sinus Septa in Relevance to Sinus Augmentation Procedures
por: Dandekeri, Shilpa S, et al.
Publicado: (2020)

Quantitative volumetric Raman imaging of three dimensional cell cultures
por: Kallepitis, Charalambos, et al.
Publicado: (2017)

Three-Dimensional Volumetric Measurement of Endolymphatic Hydrops in Meniere's Disease
por: Noh, Tae-Soo, et al.
Publicado: (2021)

Reproducibility of Three-Dimensional Volumetric Measurement of Periocular Tumor Models
por: Fan, Wanlin, et al.
Publicado: (2022)

3D Printing/Additive Manufacturing Single Titanium Dental Implants: A Prospective Multicenter Study with 3 Years of Follow-Up
por: Tunchel, Samy, et al.
Publicado: (2016)

Three-Dimensional Bone Substitutes for Oral and Maxillofacial Surgery: Biological and Structural Characterization
por: Turco, Gianluca, et al.
Publicado: (2018)

Evaluation of five CAD/CAM materials by microstructural characterization and mechanical tests: a comparative in vitro study
por: Sonmez, Nesrin, et al.
Publicado: (2018)

Volumetric stability of autogenous bone graft with mandibular body bone: cone-beam computed tomography and three-dimensional reconstruction analysis
por: Lee, Hyeong-Geun, et al.
Publicado: (2015)

Bone Flap Changes after Cranioplasty Using Frozen Autologous Bone Flaps: A Three-Dimensional Volumetric Reconstruction Study
por: Lee, Jung Hwan, et al.
Publicado: (2019)

Cone Beam CT-Based Preoperative Volumetric Estimation of Bone Graft Required for Lateral Window Sinus Augmentation, Compared with Intraoperative Findings: A Pilot Study
por: Abdel-Wahed, Nagla'a A., et al.
Publicado: (2018)

Biomechanical Analysis of Grafted and Nongrafted Maxillary Sinus Augmentation in the Atrophic Posterior Maxilla with Three-Dimensional Finite Element Method
por: Wang, Xuan, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_dv928agfai60slenih02c09tks