Cargando…

District Nursing

Detalles Bibliográficos
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Scientific Press 1919
Materias:	The Life of a Nurse: Its Moral and Material Advantages
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5252182/ https://www.ncbi.nlm.nih.gov/pubmed/29831884

Ejemplares similares

School Nursing
Publicado: (1919)

Mental Nursing
Publicado: (1919)

Industrial Hygiene: Factory Nursing
Publicado: (1919)

Massage
Publicado: (1920)

The District Nurse's Training
Publicado: (1909)

Progress in District Nursing
Publicado: (1907)

Predictors of district nursing care utilisation for community-living people in the Netherlands: an exploratory study using claims data
por: Veldhuizen, Jessica Desirée, et al.
Publicado: (2021)

District Nursing Committees: A Danger
Publicado: (1908)

District Nursing
Publicado: (1920)

Work hours and overtime of nurses working in Cambodian hospitals
por: Bae, Sung‐Heui, et al.
Publicado: (2021)

Psychological, physical, and social effects of the COVID‐19 pandemic on hospital nurses
por: Häussl, Alfred, et al.
Publicado: (2021)

Effect of effort‐reward imbalance and burnout on infection control among Ecuadorian nurses
por: Colindres, C.V., et al.
Publicado: (2017)

Tackling the workforce crisis in district nursing: can the Dutch Buurtzorg model offer a solution and a better patient experience? A mixed methods case study
por: Drennan, Vari M, et al.
Publicado: (2018)

Full-scale model of the ALICE ITS Detector
Publicado: (2004)

ALICE ITS
Publicado: (2003)

ALICE Pixel Ladder (5 chips bump bonded to 1 sensor) mounted on prototype bus
Publicado: (2002)

ALICE pixel prototype bus with 10 readout chips
Publicado: (2002)

ALICE pixel readout chip with 8192 readout channels
Publicado: (2001)

ALICE ITS Testbeam setup with 4 pixel reference planes
Publicado: (2002)

ALICE ITS
Publicado: (2003)

ALICE Carbon fibre sector support
Publicado: (2001)

ALICE ladder mounted on prototype bus
Publicado: (2002)

ALICE ladder mounted and wire bonded on prototype bus
Publicado: (2002)

ALICE Testbeam 2002-Reference plane made of 2 bump bonded single chip assemblies
Publicado: (2002)

SEM picture of bump bonding pads on ALICE readout chip
Publicado: (2002)

Probing of ALICE single chip assembly
Publicado: (2001)

Multiple trigger scintillators were installed: big ones covering the total surface of the sensor and several smaller ones. The former give a trigger for each beam particle. The latter are used to select a part of the sensor surface for efficiency measurements.
por: Nooren, G.
Publicado: (2004)

In ALICE particles will hit the sensors at oblique angles. This is partly simulated here by rotating the modules.
por: Nooren, G.
Publicado: (2004)

Installation of the light tight cover for the SSD modules (the modules are behind the aluminium plate). The silicon sensors are sensitive to light tight, so ambient light will increase the noise and may even damage them.
por: Nooren, G.
Publicado: (2004)

The T10 beam produces a few hits per event. In ALICE the SSD will have to cope with many hits per strip. In the three centimeters of aluminium the beam will produce many secondary particles. This increases the chance of multiple hits per strip, although not to the level in ALICE.
por: Nooren, G.
Publicado: (2004)

A silicon Drift Detector and its two fronted boards
por: Nouais, D.
Publicado: (2004)

Particular of the set up for testing the cooling system of SDD
por: Alessandro, B.
Publicado: (2004)

Set up to test the cooling system of SDD
por: Alessandro, B.
Publicado: (2004)

The board with the front-end ASIC's called PASCAL and AMBRA (part of readout setup)
por: Alessandro, B.
Publicado: (2004)

The DAQ screen during the test of the readout of SDD
por: Alessandro, B.
Publicado: (2004)

Set up to test the redout chain of SDD
por: Alessandro, B.
Publicado: (2004)

The board with the compression ASIC called CARLOS (part of readout setup)
por: Alessandro, B.
Publicado: (2004)

Front-end chip cable and jif on Delvotec (bonding machine)
por: Alessandro, B.
Publicado: (2004)

Hybrid bonding on K&S manual bonder
por: Alessandro, B.
Publicado: (2004)

Completed hybrid
por: Alessandro, B.
Publicado: (2004)

Cannot write session to /tmp/vufind_sessions/sess_skka2ii0f0kbgjg8297juj09ba