Cargando…
Fabrication and Characterization of Single Phase α-Alumina Membranes with Tunable Pore Diameters
Nanoporous and single phase α-alumina membranes with pore diameters tunable over a wide range of approximately 60–350 nm were successfully fabricated by optimizing the conditions for anodizing, subsequent detachment, and heat treatment. The pore diameter increased and the cell diameter shrunk upon c...
Autores principales: | Masuda, Tatsuya, Asoh, Hidetaka, Haraguchi, Satoshi, Ono, Sachiko |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2015
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5455454/ https://www.ncbi.nlm.nih.gov/pubmed/28788005 http://dx.doi.org/10.3390/ma8031350 |
Ejemplares similares
-
Triangle pore arrays fabricated on Si (111) substrate by sphere lithography combined with metal-assisted chemical etching and anisotropic chemical etching
por: Asoh, Hidetaka, et al.
Publicado: (2012) -
Flexible fabrication of new-type porous anodic alumina membranes with tunable geometric features by low-cost nanoimprint lithography
por: Lang, Xianzhong, et al.
Publicado: (2021) -
Sub-100-nm ordered silicon hole arrays by metal-assisted chemical etching
por: Asoh, Hidetaka, et al.
Publicado: (2013) -
Corrosion Resistance and Apatite-Forming Ability of Composite Coatings formed on Mg–Al–Zn–Ca Alloys
por: Anawati, Anawati, et al.
Publicado: (2019) -
Effects of Alloying Element Ca on the Corrosion Behavior and Bioactivity of Anodic Films Formed on AM60 Mg Alloys
por: Anawati, Anawati, et al.
Publicado: (2016)