Cargando…

Dissolution and Precipitation Behaviour during Continuous Heating of Al–Mg–Si Alloys in a Wide Range of Heating Rates

In the present study, the dissolution and precipitation behaviour of four different aluminium alloys (EN AW-6005A, EN AW-6082, EN AW-6016, and EN AW-6181) in four different initial heat treatment conditions (T4, T6, overaged, and soft annealed) was investigated during heating in a wide dynamic range...

Descripción completa

Detalles Bibliográficos
Autores principales:	Osten, Julia, Milkereit, Benjamin, Schick, Christoph, Kessler, Olaf
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2015
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5455566/ http://dx.doi.org/10.3390/ma8052830

Ejemplares similares

In-situ analysis of continuous cooling precipitation in Al alloys by wide-angle X-ray scattering
por: Rowolt, Christian, et al.
Publicado: (2020)

Isothermal Time-Temperature-Precipitation Diagram for an Aluminum Alloy 6005A by In Situ DSC Experiments
por: Milkereit, Benjamin, et al.
Publicado: (2014)

Development of Precipitation Hardening Parameters for High Strength Alloy AA 7068
por: Osten, Julia, et al.
Publicado: (2020)

Review of the Quench Sensitivity of Aluminium Alloys: Analysis of the Kinetics and Nature of Quench-Induced Precipitation
por: Milkereit, Benjamin, et al.
Publicado: (2019)

Optimization of Heat Treatment Parameters of AlSi7Mg Alloy
por: Pezda, Jacek
Publicado: (2022)

Precipitation of a new platelet phase during the quenching of an Al-Zn-Mg-Cu alloy
por: Zhang, Yong, et al.
Publicado: (2016)

Aging Behavior and Precipitates Analysis of Wrought Al-Si-Mg Alloy
por: Liu, Fang, et al.
Publicado: (2022)

Heat Treatments and Critical Quenching Rates in Additively Manufactured Al–Si–Mg Alloys
por: Hitzler, Leonhard, et al.
Publicado: (2020)

Influence of Zn and Sn on the Precipitation Behavior of New Al–Mg–Si Alloys
por: Glöckel, Felix, et al.
Publicado: (2019)

The Effect of Cu Addition on the Precipitation Sequence in the Al-Si-Mg-Cr Alloy
por: Chen, Bin, et al.
Publicado: (2022)

Friction-Stir Welding of a Wrought Al-Si-Mg Alloy in As-Fabricated and Heat-Treatment States
por: Wang, Chunxia, et al.
Publicado: (2020)

Study on the Effect of Pre-Refinement and Heat Treatment on the Microstructure and Properties of Hypoeutectic Al-Si-Mg Alloy
por: Lin, Ling, et al.
Publicado: (2022)

Effects of the Mg/Si Ratio on Microstructure, Mechanical Properties, and Precipitation Behavior of Al–Mg–Si–1.0 wt %-Zn Alloys
por: Li, Yong, et al.
Publicado: (2018)

The Precipitation Behavior of a Cu-Ni-Si Alloy with Cr Addition Prepared by Heating-Cooling Combined Mold (HCCM) Continuous Casting
por: Meng, Xianghao, et al.
Publicado: (2022)

Structural and compositional study of precipitates in under-aged Cu-added Al-Mg-Si alloy
por: Maeda, Takuya, et al.
Publicado: (2018)

Nano-scale characterisation of sheared β” precipitates in a deformed Al-Mg-Si alloy
por: Christiansen, Emil, et al.
Publicado: (2019)

Requirements for Processing High-Strength AlZnMgCu Alloys with PBF-LB/M to Achieve Crack-Free and Dense Parts
por: Heiland, Steffen, et al.
Publicado: (2021)

Effects of Solidification Pressure and Heat Treatment on the Microstructure and Micro-Hardness of AlSi9CuMg Alloy
por: Wei, Lijun, et al.
Publicado: (2019)

Cyclic Deformation Behavior of A Heat-Treated Die-Cast Al-Mg-Si-Based Aluminum Alloy
por: Mohammed, Sohail, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of an Al–Mg–Si–Zr Alloy Processed by L-PBF and Subsequent Heat Treatments
por: Yang, Wonseok, et al.
Publicado: (2022)

The Behaviour of Bifilm Defects in Cast Al-7Si-Mg Alloy
por: El-Sayed, Mahmoud Ahmed
Publicado: (2016)

Research Progress on Multi-Component Alloying and Heat Treatment of High Strength and Toughness Al–Si–Cu–Mg Cast Aluminum Alloys
por: Zhang, Mingshan, et al.
Publicado: (2023)

Aging Response and Precipitation Behavior after 5% Pre-Deformation of an Al-Mg-Si-Cu Alloy
por: Jin, Shuoxun, et al.
Publicado: (2018)

Influence of Minor Zn Addition on Precipitation Behavior and Intergranular Corrosion Properties of Al-Mg-Si Alloy
por: Chi, Shuiqing, et al.
Publicado: (2020)

A First-Principles Study of the Cu-Containing β″ Precipitates in Al-Mg-Si-Cu Alloy
por: He, Shaozhi, et al.
Publicado: (2021)

Effect of solution heat treatment on the internal architecture and compressive strength of an AlMg4.7Si8 alloy()
por: Tolnai, D., et al.
Publicado: (2013)

Nucleation Behavior of a Single Al-20Si Particle Rapidly Solidified in a Fast Scanning Calorimeter
por: Peng, Qin, et al.
Publicado: (2021)

Effect of Al(2)Ca Addition and Heat Treatment on the Microstructure Modification and Tensile Properties of Hypo-Eutectic Al–Mg–Si Alloys
por: Shah, Abdul Wahid, et al.
Publicado: (2021)

Data analysis and other considerations concerning the study of precipitation in Al–Mg–Si alloys by Atom Probe Tomography
por: Zandbergen, M.W., et al.
Publicado: (2015)

Mechanical Performance and Precipitation Behavior in Al-Si-Cu-Mg Cast Alloys: Effect of Prolonged Thermal Exposure
por: Abdelaziz, Mohamed H., et al.
Publicado: (2022)

Sub-micrometre holotomographic characterisation of the effects of solution heat treatment on an AlMg7.3Si3.5 alloy
por: Tolnai, D., et al.
Publicado: (2012)

Achievement of High Strength and Ductility in Al–Si–Cu–Mg Alloys by Intermediate Phase Optimization in As-Cast and Heat Treatment Conditions
por: Zhang, Bingrong, et al.
Publicado: (2020)

Effect of Cd on Mechanical Properties of Al-Si-Cu-Mg Alloys under Different Multi-Stage Solution Heat Treatment
por: Mao, Hongkui, et al.
Publicado: (2022)

Ageing Behaviour of Al–Mg–Si Alloys After Cryogenic and Room Temperature Deformation
por: Gruber, Belinda, et al.
Publicado: (2020)

Influence of Microstructure on Fracture Mechanisms of the Heat-Treated AlSi10Mg Alloy Produced by Laser-Based Powder Bed Fusion
por: Di Egidio, Gianluca, et al.
Publicado: (2023)

Investigating the Influence of Mg Content Variations on Microstructures, Heat-Treatment, and Mechanical Properties of Al-Cu-Mg Alloys
por: Shah, Abdul Wahid, et al.
Publicado: (2023)

Quenching Sensitivity of Al-Zn-Mg Alloy after Non-Isothermal Heat Treatment
por: Li, Shuai, et al.
Publicado: (2019)

The Effect of Heat Treatment on the Sensitized Corrosion of the 5383-H116 Al-Mg Alloy
por: Lin, Ying-Kai, et al.
Publicado: (2017)

Effect of intracanal and extracanal heating on pulp dissolution property of continuous chelation irrigant
por: Jaiswal, Shikha, et al.
Publicado: (2021)

Effect of Thermal Treatments on Sn-Alloyed Al-Mg-Si Alloys
por: Schmid, Florian, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_85aqeqj8fpqtrrso3eedf3ivh9