Cargando…

Tribo-Mechanical Properties of HVOF Deposited Fe(3)Al Coatings Reinforced with TiB(2) Particles for Wear-Resistant Applications

This study reveals the effect of TiB(2) particles on the mechanical and tribological properties of Fe(3)Al-TiB(2) composite coatings against an alumina counterpart. The feedstock was produced by milling Fe(3)Al and TiB(2) powders in a high energy ball mill. The high-velocity oxy-fuel (HVOF) techniqu...

Descripción completa

Detalles Bibliográficos
Autores principales:	Amiriyan, Mahdi, Blais, Carl, Savoie, Sylvio, Schulz, Robert, Gariépy, Mario, Alamdari, Houshang
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2016
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5456485/ https://www.ncbi.nlm.nih.gov/pubmed/28787917 http://dx.doi.org/10.3390/ma9020117

Ejemplares similares

Effect of VN and TiB(2)-TiC(x) Reinforcement on Wear Behavior of Al 7075-Based Composites
por: Bai, Yaping, et al.
Publicado: (2021)

Calculation of Volume Fractions of In Situ TiB and Residual Stress Distributions in Functionally Graded Composite of Ti–TiB–TiB(2)
por: Zhang, Youfeng, et al.
Publicado: (2019)

Effect of the Mass Fraction of NiTi–TiB(2) SHS-Particles on the Phase Composition, Structure, and Mechanical Properties of Inconel 625–NiTi–TiB(2) Composites Produced by Direct Laser Deposition
por: Matveev, Alexey, et al.
Publicado: (2022)

Hot Sliding Wear of 88 wt.% TiB–Ti Composite from SHS Produced Powders
por: Kumar, Rahul, et al.
Publicado: (2021)

Corrosion and Erosion Wear Behaviors of HVOF-Sprayed Fe-Based Amorphous Coatings on Dissolvable Mg-RE Alloy Substrates
por: Yang, Jun, et al.
Publicado: (2023)

Thermomechanical Processing of a Near-α Ti Matrix Composite Reinforced by TiB(w)
por: Feng, Hong, et al.
Publicado: (2020)

Sliding Wear Performance of AlCrN Coating on TiB(2)/Ti Composites at High Temperatures
por: Michalczewski, Remigiusz, et al.
Publicado: (2021)

The Microstructure of Nanocrystalline TiB(2) Films Prepared by Chemical Vapor Deposition
por: Huang, Xiaoxiao, et al.
Publicado: (2017)

Corrosion and wear behaviour of highly porous Ti-TiB-TiN(x) in situ composites in simulated physiological solution
por: TOPTAN, Fatih
Publicado: (2020)

Effect of TiB Orientation on Near-Threshold Fatigue Crack Propagation in TiB-Reinforced Ti-3Al-2.5V Matrix Composites Treated with Heat Extrusion
por: Kikuchi, Shoichi, et al.
Publicado: (2019)

Impact Wear of the Protective Cr(3)C(2)-Based HVOF-Sprayed Coatings
por: Daniel, Josef, et al.
Publicado: (2020)

Spark Plasma Sintering of Copper Matrix Composites Reinforced with TiB(2) Particles
por: Pellizzari, Massimo, et al.
Publicado: (2020)

TiB Nanowhisker Reinforced Titanium Matrix Composite with Improved Hardness for Biomedical Applications
por: Otte, Joseph A., et al.
Publicado: (2020)

Investigation of the Wear Performance of TiB(2) Coated Cutting Tools during the Machining of Ti6Al4V Alloy
por: Chowdhury, Mohammad Shariful Islam, et al.
Publicado: (2021)

Preparation and Characterization of In Situ (TiC-TiB(2))/Al-Cu-Mg-Si Composites with High Strength and Wear Resistance
por: Gao, Yu-Yang, et al.
Publicado: (2022)

In situ controlled rapid growth of novel high activity TiB(2)/(TiB(2)–TiN) hierarchical/heterostructured nanocomposites
por: Wang, Jilin, et al.
Publicado: (2017)

The Conditions Necessary for the Formation of Dissipative Structures in Tribo-Films on Friction Surfaces That Decrease the Wear Rate
por: Gershman, Iosif S., et al.
Publicado: (2023)

Influence of W Addition on Microstructure and Resistance to Brittle Cracking of TiB(2) Coatings Deposited by DCMS
por: Chudzik-Poliszak, Edyta, et al.
Publicado: (2021)

Microstructural Modeling and Strengthening Mechanism of TiB/Ti-6Al-4V Discontinuously-Reinforced Titanium Matrix Composite
por: Zhao, Shuai, et al.
Publicado: (2019)

Effects of TiB(2) Particles on the Microstructure Evolution and Mechanical Properties of B(4)C/TiB(2) Ceramic Composite
por: Niu, Haiyan, et al.
Publicado: (2021)

In-Situ Synthesis, Microstructure, and Mechanical Properties of TiB(2)-Reinforced Fe-Cr-Mn-Al Steel Matrix Composites Prepared by Spark Plasma Sintering
por: Liu, Jian, et al.
Publicado: (2021)

Tribo-mechanical properties evaluation of HA/TiO(2)/CNT nanocomposite
por: Zalnezhad, Erfan, et al.
Publicado: (2021)

Structure, Properties and Phase Composition of Composite Materials Based on the System NiTi-TiB(2)
por: Promakhov, Vladimir, et al.
Publicado: (2022)

Effect of Mn, Fe and Co on the compression strength and ductility of in situ nano-sized TiB(2)/TiAl composites
por: Shu, Shili, et al.
Publicado: (2015)

Effects of Aluminum Addition on Microstructure and Properties of TiC-TiB(2)/Fe Coatings In Situ Synthesized by TIG Cladding
por: Ma, Ning, et al.
Publicado: (2023)

Effect of Adjusted Gas Nitriding Parameters on Microstructure and Wear Resistance of HVOF-Sprayed AISI 316L Coatings
por: Kutschmann, Pia, et al.
Publicado: (2019)

Effects of Cr and Zr Addition on Microstructures, Compressive Properties, and Abrasive Wear Behaviors of In Situ TiB(2)/Cu Cermets
por: Qiu, Feng, et al.
Publicado: (2018)

Tribo-Mechanical Characterization of Carbon Fiber-Reinforced Cyanate Ester Resins Modified With Fillers
por: Bajpai, Ankur, et al.
Publicado: (2020)

Tribo-Mechanical Investigation of Glass Fiber Reinforced Polymer Composites under Dry Conditions
por: Birleanu, Corina, et al.
Publicado: (2023)

A Unified Treatment of Tribo-Components Degradation Using Thermodynamics Framework: A Review on Adhesive Wear
por: Koottaparambil, Lijesh, et al.
Publicado: (2021)

First Principle Study of TiB(2) (0001)/γ-Fe (111) Interfacial Strength and Heterogeneous Nucleation
por: Wang, Qin, et al.
Publicado: (2021)

In Situ Ti6Al4V/TiB Composites Prepared by Hydrogen-Assisted Sintering of Blends Containing TiH(2) and Ball-Milled Ti+TiB(2) Powders
por: Song, Yuchao, et al.
Publicado: (2022)

Effect of TiB(2) Nanoparticle Content on the Microstructure and Mechanical Properties of TiB(2)/Mg-4Al-1.5Si Composites
por: Liu, Jian, et al.
Publicado: (2023)

Investigation on Microstructure, Mechanical and Wear Properties of HVOF Sprayed Composite Coatings (WC–Co + CR) On Ductile Cast Iron
por: Ksiazek, Marzanna, et al.
Publicado: (2021)

High Temperature Deformation Behavior of In-Situ Synthesized Titanium-Based Composite Reinforced with Ultra-Fine TiB Whiskers
por: Xu, Rongjun, et al.
Publicado: (2018)

Fabrication and Characterization of In Situ Zn-TiB(2) Nanocomposite
por: Guan, Zeyi, et al.
Publicado: (2020)

Bulk TiB(2)-Based Ceramic Composites with Improved Mechanical Property Using Fe–Ni–Ti–Al as a Sintering Aid
por: Yang, Chao, et al.
Publicado: (2014)

Investigation on Inorganic Salts K2TiF6 and KBF4 to Develop Nanoparticles Based TiB2 Reinforcement Aluminium Composites
por: Mohanavel, Vinayagam, et al.
Publicado: (2022)

Removal Mechanism and Electrochemical Milling of (TiB+TiC)/TC4 Composites
por: Fan, Shukai, et al.
Publicado: (2022)

TIBS — Noticeboard
Publicado: (1980)

Cannot write session to /tmp/vufind_sessions/sess_nim2qnhogpj0d1j876ogako52i