Cargando…

A Numerical Investigation of the Thermal Stresses of a Planar Solid Oxide Fuel Cell

A typical operating temperature of a solid oxide fuel cell (SOFC) is quite high above 750 °C and affects the thermomechanical behavior of the cell. Thermal stresses may cause microstructural instability and sub-critical cracking. Therefore, a joint analysis by the computational fluid dynamics (CFD)...

Descripción completa

Detalles Bibliográficos
Autores principales:	Pianko-Oprych, Paulina, Zinko, Tomasz, Jaworski, Zdzisław
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2016
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5456594/ https://www.ncbi.nlm.nih.gov/pubmed/28773935 http://dx.doi.org/10.3390/ma9100814

Ejemplares similares

Multiphysics Coupling Simulation and Parameter Study of Planar Solid Oxide Fuel Cell
por: Dang, Zheng, et al.
Publicado: (2021)

Solid oxide fuel cell interconnect design optimization considering the thermal stresses
por: Xu, Min, et al.
Publicado: (2016)

Numerical Investigation of the Effects of Coke on Transport Properties in an Oxidative Fuel Cell Reformer
por: Arku, Precious, et al.
Publicado: (2020)

Comparative Study of the Thermal Conductivity of Solid Biomass Fuels
por: Mason, P. E., et al.
Publicado: (2016)

Numerical and Experimental Investigation on a “Tai Chi”-Shaped Planar Passive Micromixer
por: Xia, Annan, et al.
Publicado: (2023)

A comprehensive investigation of direct ammonia-fueled thin-film solid-oxide fuel cells: Performance, limitation, and prospects
por: Oh, Seongkook, et al.
Publicado: (2022)

Classification of Solid Oxide Fuel Cells
por: Kuterbekov, Kairat A., et al.
Publicado: (2022)

Numerical investigation of blood flow in a deformable coronary bifurcation and non-planar branch
por: Razavi, Seyed Esmail, et al.
Publicado: (2014)

Solid oxide fuel cell (SOFC) materials
por: Saravanan, R
Publicado: (2018)

Investigation of the Effects of Working Conditions on Performance of Planar and Cylindrical Proton Exchange Membrane Fuel Cells
por: Cellek, Muhammed Salih, et al.
Publicado: (2023)

Thermal-Fluid–Solid Coupling—Parametrical Numerical Analysis of Hot Turbine Nozzle Guide Vane
por: Froissart, Marcin, et al.
Publicado: (2021)

Numerical Study on Thermal Stress of High Temperature Proton Exchange Membrane Fuel Cells during Start-Up Process
por: Li, Shian, et al.
Publicado: (2023)

Numerical investigation of dimensions and arrangement of obstacle on the performance of PEM fuel cell
por: Ebrahimzadeh, A.A., et al.
Publicado: (2018)

Solid oxide fuel cell lifetime and reliability: critical challenges in fuel cells
por: Brandon, Nigel
Publicado: (2017)

The Utilisation of Solid Fuels Derived from Waste Pistachio Shells in Direct Carbon Solid Oxide Fuel Cells
por: Dudek, Magdalena, et al.
Publicado: (2021)

Operando X-ray Investigation of Electrode/Electrolyte Interfaces in Model Solid Oxide Fuel Cells
por: Volkov, Sergey, et al.
Publicado: (2016)

Constrained Sintering in Fabrication of Solid Oxide Fuel Cells
por: Lee, Hae-Weon, et al.
Publicado: (2016)

Numerical and Experimental Investigation of the Opposite Influence of Dielectric Anisotropy and Substrate Bending on Planar Radiators and Sensors
por: Dankov, Plamen I., et al.
Publicado: (2020)

Numerical Modeling of Ink Widening and Coating Gap in Roll-to-Roll Slot-Die Coating of Solid Oxide Fuel Cell Electrolytic Layer
por: Kim, Seongyong, et al.
Publicado: (2020)

Micro solid oxide fuel cell fabricated on porous stainless steel: a new strategy for enhanced thermal cycling ability
por: Kim, Kun Joong, et al.
Publicado: (2016)

Lanthanum Ferrites-Based Exsolved Perovskites as Fuel-Flexible Anode for Solid Oxide Fuel Cells
por: Lo Faro, Massimiliano, et al.
Publicado: (2020)

Computing Planar Five-Gluon Amplitudes with Numerical Unitarity
por: Abreu, Samuel, et al.
Publicado: (2018)

Numerical Investigation of Special Heat Transfer Phenomenon in Wire-Wrapped Fuel Rod of SFR
por: Tan, Xuefeng, et al.
Publicado: (2022)

An Anisotropic Microstructure Evolution in a Solid Oxide Fuel Cell Anode
por: Brus, Grzegorz, et al.
Publicado: (2020)

Numerical investigation on the solid particle erosion in elbow with water–hydrate–solid flow
por: Zhang, Liang, et al.
Publicado: (2019)

Intermediate-temperature solid oxide fuel cells: materials and applications
por: Shao, Zongping, et al.
Publicado: (2016)

Coupled Transport Effects in Solid Oxide Fuel Cell Modeling
por: Gedik, Aydan, et al.
Publicado: (2022)

Solid fuel reactors/
por: Dietrich, Joseph R.
Publicado: (1958)

Solid fuel reactors
por: Zinn, Walter H, et al.
Publicado: (1958)

Parametric sensitivity analysis for a natural gas fueled high temperature tubular solid oxide fuel cell
por: Kalra, Pankaj, et al.
Publicado: (2020)

Reduced modelling of planar fuel cells: spatial smoothing and asymptotic reduction
por: He, Zhongjie, et al.
Publicado: (2017)

Carbonate-superstructured solid fuel cells with hydrocarbon fuels
por: Su, Hanrui, et al.
Publicado: (2022)

Numerical Investigation of Thermal Counterflow of He II Past Cylinders
por: Soulaine, Cyprien, et al.
Publicado: (2017)

Planar Indium Tin Oxide Heater for Improved Thermal Distribution for Metal Oxide Micromachined Gas Sensors
por: Çakır, M. Cihan, et al.
Publicado: (2016)

A Review of RedOx Cycling of Solid Oxide Fuel Cells Anode
por: Faes, Antonin, et al.
Publicado: (2012)

Improving the durability of cobaltite cathode of solid oxide fuel cells – a review
por: Mehdi, Ali Muqaddas, et al.
Publicado: (2023)

Design and operation of solid oxide fuel cells: multidisciplinary industrial applications
por: Sharifzadeh, Mahdi
Publicado: (2019)

Advances in medium and high temperature solid oxide fuel cell technology
por: Boaro, Marta, et al.
Publicado: (2017)

High-temperature solid oxide fuel cells: fundamentals, design and applications
por: Singhal, S C, et al.
Publicado: (2003)

Hybrid systems based on solid oxide fuel cells: modelling and design
por: Ferrari, M L, et al.
Publicado: (2017)

Cannot write session to /tmp/vufind_sessions/sess_ckvmqbojs2fi0sbn5ghnm6mnrm