Cargando…

Fabrication of Al/Mg/Al Composites via Accumulative Roll Bonding and Their Mechanical Properties

Al(1060)/Mg(AZ31)/Al(1060) multilayered composite was successfully produced using an accumulative roll bonding (ARB) process for up to four cycles at an elevated temperature (400 °C). The microstructure evolution of the composites and the bonding characteristics at the interfaces between Al and Mg l...

Descripción completa

Detalles Bibliográficos
Autores principales:	Nie, Jinfeng, Liu, Mingxing, Wang, Fang, Zhao, Yonghao, Li, Yusheng, Cao, Yang, Zhu, Yuntian
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2016
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5457262/ https://www.ncbi.nlm.nih.gov/pubmed/28774072 http://dx.doi.org/10.3390/ma9110951

Ejemplares similares

Microstructure Evolution and Mechanical Properties of Al-TiB(2)/TiC In Situ Aluminum-Based Composites during Accumulative Roll Bonding (ARB) Process
por: Nie, Jinfeng, et al.
Publicado: (2017)

Microstructure, mechanical properties, and electrical conductivity of Mg–8Li–2Y–Zn/Al multilayered composites fabricated by cross asynchronous accumulative roll bonding
por: Hu, Hao, et al.
Publicado: (2022)

Microstructure and Mechanical Properties of Al-Mg-Si Similar Alloy Laminates Produced by Accumulative Roll Bonding
por: Li, Zhigang, et al.
Publicado: (2021)

Evolution of Microstructure, Texture and Mechanical Properties for Multilayered Al Matrix Composites by Accumulative Roll Bonding
por: Wang, Wen-Jing, et al.
Publicado: (2021)

Effect of Cold and Warm Rolling on the Particle Distribution and Tensile Properties of Heterogeneous Structured AlN/Al Nanocomposites
por: Song, Lei, et al.
Publicado: (2020)

Study on Fabrication and Properties of Graphite/Al Composites by Hot Isostatic Pressing-Rolling Process
por: Jia, Hao, et al.
Publicado: (2021)

Anisotropic Behavior of Al1050 through Accumulative Roll Bonding
por: Sattarpanah Karganroudi, Sasan, et al.
Publicado: (2021)

Studies on Hot-Rolling Bonding of the Al-Cu Bimetallic Composite
por: Sas-Boca, Ioana-Monica, et al.
Publicado: (2022)

Microstructure and Mechanical Properties of Ultrafine-Grained Copper by Accumulative Roll Bonding and Subsequent Annealing
por: Liu, Xueran, et al.
Publicado: (2020)

Effect of Rolling Temperature on Microstructure and Properties of Al-Mg-Li Alloy
por: Li, Weiwei, et al.
Publicado: (2022)

Study on Rolling Defects of Al-Mg Alloys with High Mg Content in Normal Rolling and Cross-Rolling Processes
por: Lim, Seong-Sik, et al.
Publicado: (2023)

Fabrication of ultra-thin nanostructured bimetallic foils by Accumulative Roll Bonding and Asymmetric Rolling
por: Yu, Hailiang, et al.
Publicado: (2013)

Abnormal texture evolution of accumulative roll bonded Al–Cu by adding alumina particles
por: Yousefi Mehr, Vahid, et al.
Publicado: (2022)

The Effect of Post-Weld Hot-Rolling on the Properties of Explosively Welded Mg/Al/Ti Multilayer Composite
por: Wachowski, Marcin, et al.
Publicado: (2020)

Microstructure, Precipitates Behavior, and Mechanical Properties of Age-Hardened Al-Mg-Si Alloy Sheet Fabricated by Twin-Roll Casting
por: Gao, Guanjun, et al.
Publicado: (2022)

Fe/Mg/Fe Multilayer Composite Sheet Fabricated by Roll Cladding
por: Ren, Daxin, et al.
Publicado: (2022)

Effect of the Rolling Process on the Properties of the Mg/Al Bimetallic Bars Obtained by the Explosive Welding Method
por: Mróz, Sebastian, et al.
Publicado: (2023)

A combined experimental and computational study on the reaction of fluoroarenes with Mg–Mg, Mg–Zn, Mg–Al and Al–Zn bonds
por: Bakewell, Clare, et al.
Publicado: (2018)

Effect of Al Layer Thickness on the Bonding and Mechanical Behavior of a Mg-(Al-)Ti Laminated Sheet Prepared by Hot-Rolling after Differential Preheating Treatment
por: Luo, Wenbo, et al.
Publicado: (2022)

Room Temperature Strengthening and High-Temperature Superplasticity of Mg-Li-Al-Sr-Y Alloy Fabricated by Asymmetric Rolling and Friction Stir Processing
por: Cao, Furong, et al.
Publicado: (2023)

Microstructure and Properties of Mg-Al-Ca-Mn Alloy with High Ca/Al Ratio Fabricated by Hot Extrusion
por: Chu, Aimin, et al.
Publicado: (2021)

Investigation on the Microstructure and Mechanical Properties of CNTs-AlSi10Mg Composites Fabricated by Selective Laser Melting
por: Luo, Shixuan, et al.
Publicado: (2021)

Study on the Properties of Carbon Nanotube (CNTs) Reinforced AlSi10Mg Composites Fabricated by Powder Metallurgy
por: Pan, Jian, et al.
Publicado: (2023)

Research on Microstructure and Properties of AlSi10Mg Fabricated by Selective Laser Melting
por: Pan, Wei, et al.
Publicado: (2022)

Superplastic Deformation Behavior of Rolled Mg-8Al-2Sn and Mg-8Al-1Sn-1Zn Alloys at High Temperatures
por: Zhang, Shao-You, et al.
Publicado: (2020)

Enhanced Mechanical Properties and Microstructure of Accumulative Roll-Bonded Co/Pb Nanocomposite
por: Karbasi, Maryam, et al.
Publicado: (2021)

Effect of the Shape of Rolling Passes and the Temperature on the Corrosion Protection of the Mg/Al Bimetallic Bars
por: Mróz, Sebastian, et al.
Publicado: (2021)

Development of interface-dominant bulk Cu/V nanolamellar composites by cross accumulative roll bonding
por: Zeng, L. F., et al.
Publicado: (2017)

Carbon–carbon bond activation by Mg, Al, and Zn complexes
por: Parr, Joseph M., et al.
Publicado: (2023)

Intermediate-Temperature Tensile Behavior of a Hot-Rolled Mg-Li-Al-Cd-Zn Alloy
por: Zhang, Lunyong, et al.
Publicado: (2022)

Egg White-Mediated Fabrication of Mg/Al-LDH-Hard Biochar Composite for Phosphate Adsorption
por: Ma, Xiaolong, et al.
Publicado: (2022)

Fabrication and wear behaviour of Mg-3wt.%Al-x wt. % SiC composites
por: Jayasathyakawin, S., et al.
Publicado: (2023)

Effect of Drying on the Fabrication of MgAl Layered Double Hydroxides
por: Silva Neto, Luiz D., et al.
Publicado: (2021)

Novel strip-cast Mg/Al clad sheets with excellent tensile and interfacial bonding properties
por: Kim, Jung-Su, et al.
Publicado: (2016)

Modification of Mg/Al-LDH by vanadate: effects on tribological properties and corrosion resistance
por: Ying, Lixia, et al.
Publicado: (2023)

Mechanical Properties of Al Matrix Composite Enhanced by In Situ Formed SiC, MgAl(2)O(4,) and MgO via Casting Process
por: Jiao, Yuhong, et al.
Publicado: (2021)

Interface Characteristics and Bonding Performance of the Corrugated Mg/Al Clad Plate
por: Li, Sha, et al.
Publicado: (2021)

A Novel Approach to Improve the Microstructure and Mechanical Properties of Al–Mg–Si Aluminum Alloys during Twin-Roll Casting
por: Li, Yong, et al.
Publicado: (2020)

Comparative study of mechanical properties of cast and forged Al-3Mg-MnO(2) and Al-8Mg-MnO(2) composites
por: Narain, Vikas, et al.
Publicado: (2020)

Analysis of Friction Stir Welding Tool Offset on the Bonding and Properties of Al–Mg–Si Alloy T-Joints
por: Memon, Shabbir, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_hpjsm5qo2e24stt0o98fm4clim