The effects of irrigation volume to the heat generation during implant surgery

BACKGROUND: To evaluate the effects of the amount of irrigation on heat generated during implant site preparation. MATERIAL AND METHODS: Ten freshly dissected sheep mandibles were sectioned into 30 equal bone blocks and transferred into a heat-controlled water tank. Implant socket preparations were performed with four consecutive drills. Temperature measurements were performed with a thermocouple inserted into the bone immediately before the preparation and after the drilling using three different physiologic saline irrigation set-ups: 1- No irrigation, 2- 12 ml/min and 3- 30 ml/min irrigation volume. The temperature differences between three different irrigation set-ups for implant drills 1, 2, 3 and 4, and the temperature differences between the drills for three different irrigation set-ups were separately compared. RESULTS: The temperature difference of no irrigation group was significantly higher than 12 ml/min and 30 ml/min groups for all four drills (p<0.05), whereas no statistically significant difference was found between 12 ml/min and 30 ml/min irrigation groups. (P >0.05) The temperature difference of drill 1 is significantly higher than drills 2, 3 and 4 for no irrigation group. (P <0.05) The temperature differences of drill 1, 2 and 3 were significantly higher than the temperature difference of drill 4 for 12 ml/min irrigation group. (p<0.05). CONCLUSIONS: The heat generated during drilling is not directly proportional to the coolant volume. Given that certain amount of irrigation is applied, implant sites can be prepared safely without the need for additional irrigation, which may result in reduced visibility of the surgical site and therefore a suboptimal surgery. Key words:Dental implants, irrigation, heat generation, drilling.