Computed tomography detection of stapled interlobar fissure facilitates diagnosing postoperative lobar torsion: A case report

INTRODUCTION: Atelectasis of the right middle lobe following right upper lobectomy may result from lobar torsion, bronchial kink, or impacted mucus plug. Although clinical consequence of lobar torsion could be serious, differentiating it from bronchial kink is occasionally challenging. PRESENTATION OF CASE: A 39-year old man with non-small cell lung cancer of cT1aN0M0 stage IA underwent right upper lobectomy. On postoperative day 1, we identified middle lobe atelectasis on the chest X-ray and performed bronchoscopy, which showed an obstruction of the right middle lobe bronchus without mucoid impaction. We injected air using a bronchoscope to the middle lobe, which re-expanded it. However, on postoperative day 2, chest X-ray showed a slightly collapsed and opacified middle lobe. Although enhanced computed tomography showed a patent middle lobe pulmonary artery, we noticed that a staple placed in the horizontal fissure was in contact with the lower lobe, implying the possibility of lobar torsion. Rethoracotomy on postoperative day 2 revealed a 240° clockwise rotation of the congested middle lobe. Therefore, we performed simple detorsion. The patient was discharged 10 days after rethoracotomy without further adverse events. DISCUSSION: In our case, patency of the pulmonary artery and temporary improvement of the atelectasis using a bronchoscopic aeration maneuver could not rule out the possibility of lobar torsion. CONCLUSION: The position of the staple placed on the interlobar fissure should be evaluated using computed tomography in postoperative middle lobe atelectasis. If the aeration maneuver for middle lobe atelectasis using bronchoscope fails, rethoracotomy should be considered.