Cargando…

Achieving High Strength and Good Ductility in As-Extruded Mg–Gd–Y–Zn Alloys by Ce Micro-Alloying

In this study, the effect of Ce additions on microstructure evolution of Mg–7Gd–3.5Y–0.3Zn (wt %) alloys during the casting, homogenization, aging and extrusion processing are investigated, and novel mechanical properties are also obtained. The results show that Ce addition promotes the formation of...

Descripción completa

Detalles Bibliográficos
Autores principales:	Gao, Zhengyuan, Hu, Linsheng, Li, Jinfeng, An, Zhiguo, Li, Jun, Huang, Qiuyan
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2018
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5793600/ https://www.ncbi.nlm.nih.gov/pubmed/29320471 http://dx.doi.org/10.3390/ma11010102

Ejemplares similares

Achieving High Yield Strength and Ductility in As-Extruded Mg-0.5Sr Alloy by High Mn–Alloying
por: Zhou, Shibo, et al.
Publicado: (2020)

Strengthening Effects of Zn Addition on an Ultrahigh Ductility Mg-Gd-Zr Magnesium Alloy
por: Hu, Yaobo, et al.
Publicado: (2018)

Characteristics of the Mg-Zn-Ca-Gd Alloy after Mechanical Alloying
por: Lesz, Sabina, et al.
Publicado: (2021)

Phase Formation of Mg-Zn-Gd Alloys on the Mg-rich Corner
por: Luo, Lan, et al.
Publicado: (2018)

Computer Alloy Design of Ti Modified Al-Si-Mg-Sr Casting Alloys for Achieving Simultaneous Enhancement in Strength and Ductility
por: Zhang, Shaoji, et al.
Publicado: (2022)

Effect of Zn and Ca Addition on Microstructure and Strength at Room Temperature of As-Cast and As-Extruded Mg-Sn Alloys
por: Zhang, Yang, et al.
Publicado: (2018)

Microstructure and Mechanical Properties of Hot-Extruded Mg–Zn–Ga–(Y) Biodegradable Alloys
por: Bazhenov, Viacheslav, et al.
Publicado: (2022)

Development of Hot-Extruded Mg–RE–Zn Alloy Bar with High Mechanical Properties
por: Li, Zehua, et al.
Publicado: (2019)

Corrosion Behavior and Biocompatibility of Hot-Extruded Mg–Zn–Ga–(Y) Biodegradable Alloys
por: Bazhenov, Viacheslav, et al.
Publicado: (2022)

The Effect of (Mg, Zn)(12)Ce Phase Content on the Microstructure and the Mechanical Properties of Mg–Zn–Ce–Zr Alloy
por: Li, Yuguang, et al.
Publicado: (2022)

Self-patterning Gd nano-fibers in Mg-Gd alloys
por: Li, Yangxin, et al.
Publicado: (2016)

Achieving excellent superplasticity of Mg-7Zn-5Gd-0.6Zr alloy at low temperature regime
por: Yin, Siqi, et al.
Publicado: (2019)

Effect of Zn and Cu Addition on Mechanical Properties of As-Extruded Mg-3Sn-1Ca Alloy
por: Jia, Zheng, et al.
Publicado: (2022)

Effects of Heat Treatment on Microstructure and Mechanical Properties of Weldable Al–Mg–Zn–Sc Alloy with High Strength and Ductility
por: Jiang, Long, et al.
Publicado: (2023)

The Microstructural Evolution and Grain Growth Kinetics of Fine-Grained Extruded Mg-Nd-Zn-Zr Alloy
por: Jiao, Xueyan, et al.
Publicado: (2022)

Achieving High-Strength and Toughness in a Mg-Gd-Y Alloy Using Multidirectional Impact Forging
por: Lu, Songhe, et al.
Publicado: (2022)

Developing Mg-Gd-Dy-Ag-Zn-Zr Alloy with High Strength via Nano-Precipitation
por: Xie, Jinshu, et al.
Publicado: (2023)

Effect of Heat Treatments on the Corrosion Resistance of a High Strength Mg-Gd-Y-Zn-Zr Alloy
por: Xu, Hang, et al.
Publicado: (2022)

Manipulating the ordered oxygen complexes to achieve high strength and ductility in medium-entropy alloys
por: Jiao, Meiyuan, et al.
Publicado: (2023)

Achievement of High Strength and Ductility in Al–Si–Cu–Mg Alloys by Intermediate Phase Optimization in As-Cast and Heat Treatment Conditions
por: Zhang, Bingrong, et al.
Publicado: (2020)

Effect of Sn Addition on Microstructure and Corrosion Behavior of As-Extruded Mg–5Zn–4Al Alloy
por: Ding, Jian, et al.
Publicado: (2019)

In-vivo efficacy of biodegradable ultrahigh ductility Mg-Li-Zn alloy tracheal stents for pediatric airway obstruction
por: Wu, Jingyao, et al.
Publicado: (2020)

Tensile Properties and Corrosion Behavior of Extruded Low-Alloyed Mg–1Sn–1Al–1Zn Alloy: The Influence of Microstructural Characteristics
por: Cheng, Weili, et al.
Publicado: (2018)

Microstructure and Texture Evolution of Mg–Gd–Y–Zn–Zr Alloy by Compression–Torsion Deformation
por: Xu, Ping, et al.
Publicado: (2019)

Microstructure and mechanical properties of the Mg–Gd–Zn alloy prepared by sintering of rapidly-solidified ribbons
por: Luo, Wenbo, et al.
Publicado: (2022)

Comparison of Corrosion Performance of Extruded and Forged WE43 Mg Alloy
por: Liu, Guonan, et al.
Publicado: (2022)

Study on Bulk Texture and Mechanical Properties of As-Extruded Wide Mg-Al-Zn Alloy Sheets with Different Al Addition
por: Li, Yu-Qing, et al.
Publicado: (2022)

The Synergistic Effect of Trace Ag and Hot Extruding on the Microstructure and Properties of a Biodegradable Mg-Zn-Sr-Ag Alloy
por: Shi, Qifeng, et al.
Publicado: (2023)

High-content ductile coherent nanoprecipitates achieve ultrastrong high-entropy alloys
por: Liang, Yao-Jian, et al.
Publicado: (2018)

A new insight into ductile fracture of ultrafine-grained Al-Mg alloys
por: Yu, Hailiang, et al.
Publicado: (2015)

Strong and ductile AZ31 Mg alloy with a layered bimodal structure
por: Luo, Xuan, et al.
Publicado: (2019)

Comparison of Thermal Deformation Behavior and Characteristics of Mg-Gd-Y-Zn Alloys with and without Bulk LPSO Phase
por: Chen, Dongjie, et al.
Publicado: (2023)

Hydrogen enhances strength and ductility of an equiatomic high-entropy alloy
por: Luo, Hong, et al.
Publicado: (2017)

Effect of Ce Addition on Modifying the Microstructure and Achieving a High Elongation with a Relatively High Strength of As-Extruded AZ80 Magnesium Alloy
por: Wang, Zheng, et al.
Publicado: (2018)

Effect of LPSO and SFs on microstructure evolution and mechanical properties of Mg-Gd-Y-Zn-Zr alloy
por: Xu, Chao, et al.
Publicado: (2017)

Change of Deformation Mechanisms Leading to High Strength and Large Ductility in Mg-Zn-Zr-Ca Alloy with Fully Recrystallized Ultrafine Grained Microstructures
por: Zheng, Ruixiao, et al.
Publicado: (2019)

Mechanical and Corrosion Properties of Mg-Based Alloys with Gd Addition
por: Kania, Aneta, et al.
Publicado: (2019)

Concurrence of High Corrosion Resistance and Strength with Excellent Ductility in Ultrafine-Grained Mg-3Y Alloy
por: Zemková, Mária, et al.
Publicado: (2022)

Ageing behavior of extruded Mg–8.2Gd–3.8Y–1.0Zn–0.4Zr (wt.%) alloy containing LPSO phase and γ′ precipitates
por: Xu, C., et al.
Publicado: (2017)

Achieving room-temperature brittle-to-ductile transition in ultrafine layered Fe-Al alloys
por: Li, Lu-Lu, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_dke6juvdchg82jqkvoft593ktj