Cargando…

Microstructure Evolution and Mechanical Properties of Underwater Dry and Local Dry Cavity Welded Joints of 690 MPa Grade High Strength Steel

Q690E high strength low alloy (HSLA) steel plays an important role in offshore structures. In addition, underwater local cavity welding (ULCW) technique was widely used to repair important offshore constructions. However, the high cooling rate of ULCW joints results in bad welding quality compared w...

Descripción completa

Detalles Bibliográficos
Autores principales:	Shi, Yonghua, Sun, Kun, Cui, Shuwan, Zeng, Min, Yi, Jianglong, Shen, Xiaoqin, Yi, Yaoyong
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2018
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5793665/ https://www.ncbi.nlm.nih.gov/pubmed/29361743 http://dx.doi.org/10.3390/ma11010167

Ejemplares similares

Correlation between Microstructure and Hydrogen Degradation of 690 MPa Grade Marine Engineering Steel
por: Ma, Heng, et al.
Publicado: (2021)

Effect of Heat Input on the Microstructure and Mechanical Properties of Local Dry Underwater Welded Duplex Stainless Steel
por: Hu, Yu, et al.
Publicado: (2023)

Microstructure and Impact Toughness of Local-Dry Keyhole Tungsten Inert Gas Welded Joints
por: Cui, Shuwan, et al.
Publicado: (2019)

Underwater Local Cavity Welding of S460N Steel
por: Tomków, Jacek, et al.
Publicado: (2020)

Microstructure, Pitting Corrosion Resistance and Impact Toughness of Duplex Stainless Steel Underwater Dry Hyperbaric Flux-Cored Arc Welds
por: Hu, Yu, et al.
Publicado: (2017)

Effect of Welding Peak Temperature on Microstructure and Impact Toughness of Heat-Affected Zone of Q690 High Strength Bridge Steel
por: Zhang, Yue, et al.
Publicado: (2021)

Investigation on Microstructure and Properties of Duplex Stainless Steel Welds by Underwater Laser Welding with Different Shielding Gas
por: Wang, Kai, et al.
Publicado: (2021)

Experimental and Numerical Analysis of Fracture Mechanics Behavior of Heterogeneous Zones in S690QL1 Grade High Strength Steel (HSS) Welded Joint
por: Tomerlin, Damir, et al.
Publicado: (2023)

Seismic Performance of Steel-Reinforced Concrete Columns with Q690 High-Strength Steel
por: Wang, Jun, et al.
Publicado: (2022)

Neutron Diffraction Evaluation of Near Surface Residual Stresses at Welds in 1300 MPa Yield Strength Steel
por: Harati, Ebrahim, et al.
Publicado: (2017)

Influence of Different Welding Parameters on the Morphology, Microstructure, and Mechanical Properties of 780 Duplex-Phase Steel Laser Lap Welded Joint
por: Cui, Shuwan, et al.
Publicado: (2022)

Morphology, Microstructure, and Mechanical Properties of S32101 Duplex Stainless-Steel Joints in K-TIG Welding
por: Cui, Shuwan, et al.
Publicado: (2022)

The Microstructure and Pitting Corrosion Behavior of K-TIG Welded Joints of the UNS S32101 Duplex Stainless Steel
por: Cui, Shuwan, et al.
Publicado: (2022)

Influence of Welding Speeds on the Morphology, Mechanical Properties, and Microstructure of 2205 DSS Welded Joint by K-TIG Welding
por: Cui, Shuwan, et al.
Publicado: (2021)

Transient Microstructure Evolutions and Local Properties of Dual-Phase 980 MPa Grade Steel Via Friction Stir Spot Processing †
por: Taniguchi, Koichi, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of Underwater Laser Welding of Titanium Alloy
por: Guo, Ning, et al.
Publicado: (2019)

Effect of Mo Content on Hydrogen Evolution Reaction of 1400 MPa-Grade High-Strength Bolt Steel
por: Xiong, Xilin, et al.
Publicado: (2023)

A Comparative Study on Microstructural Characterization of Thick High Strength Low Alloy Steel Weld by Arc Welding and Laser Welding
por: Chen, Yunxia, et al.
Publicado: (2023)

The Effect of Localized Vibration during Welding on the Microstructure and Mechanical Behavior of Steel Welds
por: Ingram, Ehud, et al.
Publicado: (2019)

Fatigue life of underwater wet welded low carbon steel SS400
por: Muhayat, N., et al.
Publicado: (2020)

Weldability of Underwater Wet-Welded HSLA Steel: Effects of Electrode Hydrophobic Coatings
por: Tomków, Jacek
Publicado: (2021)

Thermo-Mechanical Simulation of Underwater Friction Stir Welding of Low Carbon Steel
por: Memon, Shabbir, et al.
Publicado: (2021)

Technological, Microstructural and Strength Aspects of Welding and Post-Weld Heat Treatment of Martensitic, Wear-Resistant Hardox 600 Steel
por: Konat, Łukasz
Publicado: (2021)

Keeping Cavities Dry
por: Davis, K. B
Publicado: (1871)

Microstructure Effect of Heat Input on Ballistic Performance of Welded High Strength Armor Steel
por: Souza, Elson Renato Santos, et al.
Publicado: (2021)

Influence of Vanadium Micro-Alloying on the Microstructure of Structural High Strength Steels Welded Joints
por: Stornelli, Giulia, et al.
Publicado: (2023)

Induction Heating in Underwater Wet Welding—Thermal Input, Microstructure and Diffusible Hydrogen Content
por: Brätz, Oliver, et al.
Publicado: (2022)

Study on Morphology, Microstructure and Properties of 6063-T6 Aluminum Alloy Joints in MIG Welding
por: Cui, Shuwan, et al.
Publicado: (2023)

Laser Shock Peening Improves the Corrosion Resistance of an E690 High-Strength Steel Cladding Layer
por: Qin, Jiaxin, et al.
Publicado: (2023)

Research on Underwater Wet Laser Self-Fusion Welding Process and Analysis of Microstructure and Properties of TC4 Titanium Alloy Weld
por: Cai, Zhihai, et al.
Publicado: (2022)

Synergetic Effects of Ferrite Content and Tempering Temperature on Mechanical Properties of a 960 MPa Grade HSLA Steel
por: Wang, Shaoyang, et al.
Publicado: (2018)

Drying Cavities Preparatory to Filling
por: Taft,, et al.
Publicado: (1855)

Role of Bead Sequence in Underwater Welding
por: Tomków, Jacek, et al.
Publicado: (2019)

Dissimilar Laser Welding of Austenitic Stainless Steel and Abrasion-Resistant Steel: Microstructural Evolution and Mechanical Properties Enhanced by Post-Weld Heat Treatment
por: Hietala, Mikko, et al.
Publicado: (2021)

Effect of Post-Weld Heat Treatment on Microstructure and Fracture Toughness of X80 Pipeline Steel Welded Joint
por: Wang, Xueli, et al.
Publicado: (2022)

Microstructure Heterogeneity and Mechanical Properties of a High-Strength Ductile Laminated Steel by Electron Beam Welding
por: He, Qiong, et al.
Publicado: (2023)

Study on microstructure evolution in welded lap joint configuration of dissimilar advanced high-strength steels using low-frequency laser wobble welding
por: Nicola, Contuzzi, et al.
Publicado: (2023)

Effect of Mechanical Shock Treatment on Microstructure and Corrosion Properties of Manual Argon Arc Welding Joints of 2205 Duplex Stainless Steel
por: Gao, Lingqing, et al.
Publicado: (2022)

Effect of Filling Rate on Underwater Wet Welding Process and Weld Appearance
por: Zhang, Xin, et al.
Publicado: (2020)

An Investigation of the Microstructure of an Intermetallic Layer in Welding Aluminum Alloys to Steel by MIG Process
por: Nguyen, Quoc Manh, et al.
Publicado: (2015)

Cannot write session to /tmp/vufind_sessions/sess_4pqam8859t5i04j3cdogolfbon