Cargando…
Correction of radiographic measurements of acetabular cup wear for variations in pelvis orientation
Radiographic measurement of two-dimensional acetabular cup wear is usually carried out on a series of follow-up radiographs of the patient’s pelvis. Since the orientation of the pelvis might not be consistent at every X-ray examination, the resulting change in view of the wear plane introduces error...
Autor principal: | Derbyshire, Brian |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
SAGE Publications
2018
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5846875/ https://www.ncbi.nlm.nih.gov/pubmed/29473454 http://dx.doi.org/10.1177/0954411918754924 |
Ejemplares similares
-
The efficacy of a “double-D-shaped” wire marker for radiographic measurement of acetabular cup orientation and wear
por: Derbyshire, Brian, et al.
Publicado: (2013) -
Validation of a new 2-D technique for radiographic wear measurement of cemented, highly cross-linked polyethylene acetabular cups
por: Derbyshire, Brian, et al.
Publicado: (2017) -
“Simple mechanical devices did not improve pelvis positioning in AP pelvis radiographs for reliable assessment of the acetabular orientation”
por: Brockmeyer, Matthias, et al.
Publicado: (2019) -
Direct comparison of polyethylene wear in cemented and uncemented acetabular cups
por: Bjerkholt, Håvard, et al.
Publicado: (2010) -
Trigonometric Algorithm Defining the True Three-Dimensional Acetabular Cup Orientation: Correlation Between Measured and Calculated Cup Orientation Angles
por: Snijders, T.E., et al.
Publicado: (2018)