Cargando…

Evolution of Grain Interfaces in Annealed Duplex Stainless Steel after Parallel Cross Rolling and Direct Rolling

Changes in various grain interfaces, including the grain boundary and phase boundary, are a strong indication of microstructural changes, particularly ultra-fined grains achieved by large strain deformation and subsequent annealing. After direct rolling and cross rolling with the same strain of ε =...

Descripción completa

Detalles Bibliográficos
Autores principales:	Wang, Ming, Li, Haoqing, Tian, Yujing, Guo, Hong, Fang, Xiaoying, Guo, Yuebin
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2018
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5978193/ https://www.ncbi.nlm.nih.gov/pubmed/29772723 http://dx.doi.org/10.3390/ma11050816

Ejemplares similares

Superficial Grain Refinement of 316L Stainless Steel by Rolling with Rough Rolls
por: Maril, Yasmin, et al.
Publicado: (2023)

Hierarchical Multiple Precursors Induced Heterogeneous Structures in Super Austenitic Stainless Steels by Cryogenic Rolling and Annealing
por: Tan, Duo, et al.
Publicado: (2023)

Statistical Research of Stainless Austenitic Steel Grain Size Distribution after Screw Rolling
por: Skripalenko, Mikhail Mikhailovich, et al.
Publicado: (2020)

On the Strength of a 316L-Type Stainless Steel Subjected to Cold or Warm Rolling Followed by Annealing
por: Odnobokova, Marina, et al.
Publicado: (2020)

Creation of 3D Model of Stainless-Steel Billet’s Grain after Three-High Screw Rolling
por: Skripalenko, Mikhail Mikhailovich, et al.
Publicado: (2022)

Neutron and X-ray Diffraction Analysis of Macro and Phase-Specific Micro Residual Stresses in Deep Rolled Duplex Stainless Steels
por: Pulvermacher, Samuel, et al.
Publicado: (2021)

Advances in Duplex Stainless Steels
por: Pezzato, Luca, et al.
Publicado: (2022)

Effect of Rolling Temperature on Microstructure Evolution and Mechanical Properties of AISI316LN Austenitic Stainless Steel
por: Xiong, Yi, et al.
Publicado: (2018)

Numerical Prediction of Microstructure Evolution of Small-Diameter Stainless Steel Balls during Cold Skew Rolling
por: Zhou, Jing, et al.
Publicado: (2023)

The Effect of Ni Interlayer on the Hot-Rolled and Quenched Stainless Steel Clad Plate
por: Lin, Zengmeng, et al.
Publicado: (2020)

Microstructure Evolution and Mechanical Properties of Medium Carbon Martensitic Steel during Warm Rolling and Annealing Process
por: Liu, Guolong, et al.
Publicado: (2021)

Effect of Annealing Temperature on the Mechanical and Corrosion Behavior of a Newly Developed Novel Lean Duplex Stainless Steel
por: Guo, Yanjun, et al.
Publicado: (2014)

Micromechanical Observation and Numerical Simulation for Local Deformation Evolution of Duplex Stainless Steel
por: Zhao, Jian, et al.
Publicado: (2022)

Evolution of Power Losses in Bending Rolled Fully Finished NO Electrical Steel Treated under Unconventional Annealing Conditions
por: Petryshynets, Ivan, et al.
Publicado: (2019)

Proposal for the award of a contract for the supply of rolled and forged round bars in stainless steel
Publicado: (2017)

Effect of Reduction Sequence during Rolling on Deformed Texture and Anisotropy of Ferritic Stainless Steel
por: Cho, Sang Heon, et al.
Publicado: (2023)

Microstructure and Mechanical Properties of Ultrafine-Grained Copper by Accumulative Roll Bonding and Subsequent Annealing
por: Liu, Xueran, et al.
Publicado: (2020)

The Influence of Annealing on the Microstructural and Textural Evolution of Cold-Rolled Er Metal
por: Chen, Shiying, et al.
Publicado: (2022)

Simultaneous Improvement of Strength and Ductility of Dual-Phase Steel Processed by Multi-Step Cyclic Rolling and Intercritical Annealing
por: Liu, Litao, et al.
Publicado: (2022)

Friction and the Hot Rolling of Steel
por: Panjkovic, Vladimir
Publicado: (2014)

Ultrasonic Assessment of the Influence of Cold Rolling and Recrystallization Annealing on the Elastic Constants in a TWIP Steel
por: Carvajal, Linton, et al.
Publicado: (2021)

Roll-to-roll solvent annealing of printed P3HT : IC(X)A devices
por: Hart, Andrew S., et al.
Publicado: (2019)

Basic Mechanical Properties of Duplex Stainless Steel Bars and Experimental Study of Bonding between Duplex Stainless Steel Bars and Concrete
por: Li, Qingfu, et al.
Publicado: (2021)

Microstructure and Texture Evolution of the Magnesium Alloy ZMX210 during Rolling and Annealing
por: Kurz, Gerrit, et al.
Publicado: (2023)

Comparison between Mechanical Properties and Structures of a Rolled and a 3D-Printed Stainless Steel
por: Natali, Stefano, et al.
Publicado: (2019)

Cold Roll Forming Process Design for Complex Stainless-Steel Section Based on COPRA and Orthogonal Experiment
por: Wang, Jing, et al.
Publicado: (2022)

Microstructural Evolution and Mechanical Behavior of Thermally Aged Cast Duplex Stainless Steel
por: Li, Zhenhua, et al.
Publicado: (2020)

The Research of the Rolling Speed Influence on the Mechanism of Strip Breaks in the Steel Rolling Process
por: Rusnák, Ján, et al.
Publicado: (2020)

Annealing Effects in Twin-Roll Cast AA8006 Aluminium Sheets Processed by Accumulative Roll-Bonding
por: Cieslar, Miroslav, et al.
Publicado: (2014)

Microstructure and Mechanical Properties of a Cold-Rolled Ultrafine-Grained Dual-Phase Steel
por: Pan, Zhiyi, et al.
Publicado: (2018)

Micro Characterization of Hot-Rolled Plate of Nb-Bearing Grain-Oriented Silicon Steel
por: Wang, Yong, et al.
Publicado: (2022)

Corrosion Resistance of GMAW Duplex Stainless Steels Welds
por: Miranda-Pérez, Argelia Fabiola, et al.
Publicado: (2023)

Microstructure and Mechanical Properties of Hot- Rolled and Cold-Rolled Medium-Mn TRIP Steels
por: Liu, Chunquan, et al.
Publicado: (2018)

Effect of Solutionizing Duration and Temperature on the Electrochemical Corrosion and Pitting Resistance of Cold-Rolled Super Austenitic Stainless Steel
por: Adesina, Akeem Yusuf, et al.
Publicado: (2022)

Evolution of Microstructure and Texture in Grain-Oriented 6.5% Si Steel Processed by Rolling with Intrinsic Inhibitors and Additional Inhibitors
por: Liang, Ruiyang, et al.
Publicado: (2023)

Micro-deformation evolutions of the constituent phases in duplex stainless steel during cyclic nanoindentation
por: Cui, Yuan-Yuan, et al.
Publicado: (2018)

The Microstructure Evolution and Mechanical Properties of Rotary Friction Welded Duplex Stainless Steel Pipe
por: Zhang, Shuxin, et al.
Publicado: (2023)

Microstructure and Mechanical Properties of 4Al Alumina-Forming Austenitic Steel after Cold-Rolling Deformation and Annealing
por: Jiang, Chenchen, et al.
Publicado: (2020)

Effect of Annealing on the Interface and Mechanical Properties of Cu-Al-Cu Laminated Composite Prepared with Cold Rolling
por: Fu, Xing, et al.
Publicado: (2020)

Grain Growth Mechanism of Lamellar-Structure High-Purity Nickel via Cold Rolling and Cryorolling during Annealing
por: Li, Zhide, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_g9qnjvnvu8mp1kg0e65l2dc6vi