Cargando…

Correlative electrochemical strain and scanning electron microscopy for local characterization of the solid state electrolyte Li(1.3)Al(0.3)Ti(1.7)(PO(4))(3)

Correlative microscopy has been used to investigate the relationship between Li-ion conductivity and the microstructure of lithium aluminum titanium phosphate (Li(1.3)Al(0.3)Ti(1.7)(PO(4))(3), LATP) with high spatial resolution. A key to improvement of solid state electrolytes such as LATP is a bett...

Descripción completa

Detalles Bibliográficos
Autores principales:	Schön, Nino, Gunduz, Deniz Cihan, Yu, Shicheng, Tempel, Hermann, Schierholz, Roland, Hausen, Florian
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Beilstein-Institut 2018
Materias:	Full Research Paper
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6009433/ https://www.ncbi.nlm.nih.gov/pubmed/29977690 http://dx.doi.org/10.3762/bjnano.9.148

Ejemplares similares

Effect of Low Environmental Pressure on Sintering Behavior of NASICON-Type Li(1.3)Al(0.3)Ti(1.7)(PO(4))(3) Solid Electrolytes: An In Situ ESEM Study
por: Camara, Osmane, et al.
Publicado: (2023)

Investigating the Interface between Ceramic Particles and Polymer Matrix in Hybrid Electrolytes by Electrochemical Strain Microscopy
por: Veelken, Philipp M., et al.
Publicado: (2022)

Li-Ion Conductive Li(1.3)Al(0.3)Ti(1.7)(PO(4))(3) (LATP) Solid Electrolyte Prepared by Cold Sintering Process with Various Sintering Additives
por: Vinnichenko, Mykola, et al.
Publicado: (2022)

Combined wet milling and heat treatment in water vapor for producing amorphous to crystalline ultrafine Li(1.3)Al(0.3)Ti(1.7)(PO(4))(3) solid electrolyte particles
por: Kozawa, Takahiro
Publicado: (2021)

Sputter-Deposited Amorphous Li(3)PO(4) Solid Electrolyte Films
por: Ohnishi, Tsuyoshi, et al.
Publicado: (2022)

Effect of Electrolyte Concentration on the Electrochemical Performance of Spray Deposited LiFePO(4)
por: Floraki, Christina, et al.
Publicado: (2023)

Enhancing the Electrochemical Performance of High Voltage LiNi(0.5)Mn(1.5)O(4) Cathode Materials by Surface Modification with Li(1.3)Al(0.3)Ti(1.7)(PO(4))(3)/C
por: Yang, Tingting, et al.
Publicado: (2023)

Electrical and Structural Properties of Li(1.3)Al(0.3)Ti(1.7)(PO(4))(3)—Based Ceramics Prepared with the Addition of Li(4)SiO(4)
por: Kwatek, Konrad, et al.
Publicado: (2021)

Stabilizing the Li(1.3)Al(0.3)Ti(1.7)(PO(4))(3)|Li Interface for High Efficiency and Long Lifespan Quasi‐Solid‐State Lithium Metal Batteries
por: Chen, Zhen, et al.
Publicado: (2022)

In situ Electrochemical-AFM Study of LiFePO(4) Thin Film in Aqueous Electrolyte
por: Wu, Jiaxiong, et al.
Publicado: (2016)

Identifying the Structure of the Intermediate, Li(2/3)CoPO(4), Formed during Electrochemical Cycling of LiCoPO(4)
por: Strobridge, Fiona C., et al.
Publicado: (2014)

Potentiometric CO(2) Sensor Using Li(+) Ion Conducting Li(3)PO(4) Thin Film Electrolyte
por: Noh, Whyo Sub, et al.
Publicado: (2005)

Influence of Al Alloying on the Electrochemical Behavior of Zn Electrodes for Zn–Air Batteries With Neutral Sodium Chloride Electrolyte
por: Durmus, Yasin Emre, et al.
Publicado: (2019)

Morphology-Directed Synthesis of LiFePO(4) and LiCoPO(4) from Nanostructured Li(1+2x)PO(3+x)
por: El-Shinawi, Hany, et al.
Publicado: (2019)

LiDy(PO(3))(4)
por: Chehimi-Moumen, Fathia, et al.
Publicado: (2008)

LiHo(PO(3))(4)
por: Ben Zarkouna, Emna, et al.
Publicado: (2009)

Synthesis and electrochemical properties of Mn-doped Li(2)Mn(0.1)Ti(1.9)(PO(4))(3) materials
por: Sun, Lixia, et al.
Publicado: (2023)

A Novel Cathode Material Synthesis and Thermal Characterization of (1-x-y) LiCo(1/3)Ti(1/3)Fe(1/3)PO(4), xLi(2)MnPO(4), yLiFePO(4) Composites for Lithium-Ion Batteries (LIBs)
por: Li, Lu, et al.
Publicado: (2022)

In Situ Li(3)PO(4)/PVA Solid Polymer Electrolyte Protective Layer Stabilizes the Lithium Metal Anode
por: Hao, Shuaiguo, et al.
Publicado: (2020)

Near ideal synaptic functionalities in Li ion synaptic transistor using Li(3)PO(x)Se(x) electrolyte with high ionic conductivity
por: Nikam, Revannath Dnyandeo, et al.
Publicado: (2019)

Rhombohedral Li(1+x)Y(x)Zr(2-x)(PO(4))(3) Solid Electrolyte Prepared by Hot-Pressing for All-Solid-State Li-Metal Batteries
por: Li, Qinghui, et al.
Publicado: (2020)

Defects and dopant properties of Li(3)V(2)(PO(4))(3)
por: Kuganathan, Navaratnarajah, et al.
Publicado: (2019)

Enhanced high voltage performance of LiNi(0.5)Mn(0.3)Co(0.2)O(2) cathode via the synergistic effect of LiPO(2)F(2) and FEC in fluorinated electrolyte for lithium-ion batteries
por: Li, Rui, et al.
Publicado: (2021)

Material Optimization Engineering toward xLiFePO(4)·yLi(3)V(2)(PO(4))(3) Composites in Application-Oriented Li-Ion Batteries
por: Pi, Yuqiang, et al.
Publicado: (2022)

Lithium samarium polyphosphate, LiSm(PO(3))(4)
por: Zhao, Dan, et al.
Publicado: (2010)

Hydrothermally synthesized nanostructured LiMn(x)Fe(1−x)PO(4) (x = 0–0.3) cathode materials with enhanced properties for lithium-ion batteries
por: Trinh, Dung V., et al.
Publicado: (2021)

Investigating the magnetic and magnetocaloric behaviors of LiSm(PO(3))(4)
por: Tran, T. A., et al.
Publicado: (2023)

Transport Properties of Flexible Composite Electrolytes Composed of Li(1.5)Al(0.5)Ti(1.5)(PO(4))(3) and a Poly(vinylidene fluoride-co-hexafluoropropylene) Gel Containing a Highly Concentrated Li[N(SO(2)CF(3))(2)]/Sulfolane Electrolyte
por: Ock, Ji-young, et al.
Publicado: (2021)

Reducing interfacial resistance of a Li(1.5)Al(0.5)Ge(1.5)(PO(4))(3) solid electrolyte/electrode interface by polymer interlayer protection
por: Wang, Leidanyang, et al.
Publicado: (2020)

LiNi(0.4)Co(0.3)Mn(0.3)O(2 )thin film electrode by aerosol deposition
por: Kim, Icpyo, et al.
Publicado: (2012)

Enhancement of Electrochemical Performance of LiFePO(4)@C by Ga Coating
por: Yi, Dawei, et al.
Publicado: (2020)

Dosimetric and spectroscopic study of LiMgPO(4) doped with Tm(3+) and Er(3+)
por: Guo, Jingyuan, et al.
Publicado: (2023)

Carbonisation temperature dependence of electrochemical activity of nitrogen-doped carbon fibres from electrospinning as air-cathodes for aqueous-alkaline metal–air batteries
por: Gehring, Markus, et al.
Publicado: (2019)

Crystallization behavior of the Li(2)S–P(2)S(5) glass electrolyte in the LiNi(1/3)Mn(1/3)Co(1/3)O(2) positive electrode layer
por: Tsukasaki, Hirofumi, et al.
Publicado: (2018)

Preparation and Electrochemical Properties of Li(3)V(2)(PO(4))(3−x)Br(x)/Carbon Composites as Cathode Materials for Lithium-Ion Batteries
por: Cao, Xiaoyu, et al.
Publicado: (2017)

Elimination of Fluorination: The Influence of Fluorine-Free Electrolytes on the Performance of LiNi(1/3)Mn(1/3)Co(1/3)O(2)/Silicon–Graphite Li-Ion Battery Cells
por: Hernández, Guiomar, et al.
Publicado: (2020)

TlPO(3) and its comparison with isotypic RbPO(3) and CsPO(3)
por: Weil, Matthias
Publicado: (2020)

Microstructural details of spindle-like lithium titanium phosphate revealed in three dimensions
por: Zhang, Qian, et al.
Publicado: (2021)

Structural and Electrochemical Consequences of Al and Ga Cosubstitution in Li(7)La(3)Zr(2)O(12) Solid Electrolytes
por: Rettenwander, Daniel, et al.
Publicado: (2016)

Enhanced electrochemical performance of lithia/Li(2)RuO(3) cathode by adding tris(trimethylsilyl)borate as electrolyte additive
por: Lee, Byeong Gwan, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_n1ce83o7orq5hhk16ltmf9rh4u