Cargando…

Influence of Homogenization on Microstructural Response and Mechanical Property of Al-Cu-Mn Alloy

The evolution of the microstructures and properties of large direct chill (DC)-cast Al-Cu-Mn alloy ingots during homogenization was investigated. The results revealed that the Al-Cu-Mn alloy ingots had severe microsegregation and the main secondary phase was Al(2)Cu, with minimal Al(7)Cu(2)Fe phase....

Descripción completa

Detalles Bibliográficos
Autores principales: Wang, Jian, Lu, Yalin, Zhou, Dongshuai, Sun, Lingyan, Li, Renxing, Xu, Wenting
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2018
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6025167/
https://www.ncbi.nlm.nih.gov/pubmed/29844253
http://dx.doi.org/10.3390/ma11060914
Descripción
Sumario:The evolution of the microstructures and properties of large direct chill (DC)-cast Al-Cu-Mn alloy ingots during homogenization was investigated. The results revealed that the Al-Cu-Mn alloy ingots had severe microsegregation and the main secondary phase was Al(2)Cu, with minimal Al(7)Cu(2)Fe phase. Numerous primary eutectic phases existed in the grain boundary and the main elements were segregated at the interfaces along the interdendritic region. The grain boundaries became discontinuous, residual phases were effectively dissolved into the matrix, and the segregation degree of all elements was reduced dramatically during homogenization. In addition, the homogenized alloys exhibited improved microstructures with finer grain size, higher number density of dislocation networks, higher density of uniformly distributed θ′ or θ phase (Al(2)Cu), and higher volume fraction of high-angle grain boundaries compared to the nonhomogenized samples. After the optimal homogenization scheme treated at 535 °C for 10 h, the tensile strength and elongation% were about 24 MPa, 20.5 MPa, and 1.3% higher than those of the specimen without homogenization treatment.