Cargando…

Combined Effects of Texture and Grain Size Distribution on the Tensile Behavior of α-Titanium

This work analyzes the role of both the grain size distribution and the crystallographic texture on the tensile behavior of commercially pure titanium. Specimens with different microstructures, especially with several mean grain sizes, were specifically prepared for that purpose. It is observed that...

Descripción completa

Detalles Bibliográficos
Autores principales:	Richeton, Thiebaud, Wagner, Francis, Chen, Cai, Toth, Laszlo S.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2018
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6073333/ https://www.ncbi.nlm.nih.gov/pubmed/29949896 http://dx.doi.org/10.3390/ma11071088

Ejemplares similares

Complexity and Anisotropy of Plastic Flow of α-Ti Probed by Acoustic Emission and Local Extensometry
por: Lebyodkin, Mikhail, et al.
Publicado: (2018)

Grain-Size Distribution Effects on the Attenuation of Laser-Generated Ultrasound in α-Titanium Alloy
por: Bai, Xue, et al.
Publicado: (2018)

Micromechanical Modeling of the Elasto-Viscoplastic Behavior and Incompatibility Stresses of β-Ti Alloys
por: Lhadi, Safaa, et al.
Publicado: (2018)

Polycrystal Simulation of Texture-Induced Grain Coarsening during Severe Plastic Deformation
por: Zhang, Chi, et al.
Publicado: (2020)

Characterization and Analysis of Strain Heterogeneity at Grain-Scale of Titanium Alloy with Tri-Modal Microstructure during Tensile Deformation
por: Gao, Pengfei, et al.
Publicado: (2018)

Tensile Deformation Behaviors of Pure Ti with Different Grain Sizes under Wide-Range of Strain Rate
por: Deguchi, Misaki, et al.
Publicado: (2023)

Revealing Grain Boundary Sliding from Textures of a Deformed Nanocrystalline Pd–Au Alloy
por: Toth, Laszlo S., et al.
Publicado: (2018)

Effects of Deformation Texture and Grain Size on Corrosion Behavior of Mg–3Al–1Zn Alloy Sheets
por: Li, Da-Wei, et al.
Publicado: (2020)

Effect of the Texture of the Ultrafine-Grained Ti-6Al-4V Titanium Alloy on Impact Toughness
por: Modina, Iuliia M., et al.
Publicado: (2023)

Complete Goss Secondary Recrystallization by Control of the Grain Size and Texture of Primary Recrystallization in Grain-Oriented Silicon Steel
por: Xu, Zhanyi, et al.
Publicado: (2021)

Deformation Behavior and Tensile Properties of the Semi-Equiaxed Microstructure in Near Alpha Titanium Alloy
por: Luo, Minglang, et al.
Publicado: (2021)

Sample Sizes Based on Weibull Distribution and Normal Distribution for FRP Tensile Coupon Test
por: Yang, Yongxin, et al.
Publicado: (2019)

Atomistic Simulation of Tensile Deformation Behavior of ∑5 Tilt Grain Boundaries in Copper Bicrystal
por: Zhang, Liang, et al.
Publicado: (2014)

The Tensile Properties, Scratch Behaviors and Sliding Wear of Oxide Scale Formed on Titanium Grade 2
por: Aniołek, Krzysztof, et al.
Publicado: (2020)

In Situ Tensile Observation of the Effect of Annealing on Fracture Behavior of Laser Additive Manufactured Titanium Alloy
por: Xu, Ming, et al.
Publicado: (2023)

Compression Behavior and Textures of Ti57-Nb43 Alloy at High Temperatures
por: Szűcs, Máté, et al.
Publicado: (2023)

Tribological Behavior of Titanium Alloy Treated by Nitriding and Surface Texturing Composite Technology
por: Kang, Jiajie, et al.
Publicado: (2019)

Tensile and Viscoelastic Behavior in Nacre-Inspired Nanocomposites: A Coarse-Grained Molecular Dynamics Study
por: Singh, Param Punj, et al.
Publicado: (2022)

Deformation Behavior under Tension with Pulse Current of Ultrafine-Grain and Coarse-Grain CP Titanium
por: Stolyarov, Vladimir, et al.
Publicado: (2022)

Effect of laser welding on the titanium ceramic tensile bond strength
por: GALO, Rodrigo, et al.
Publicado: (2011)

Calculation for tensile strength and fracture toughness of granite with three kinds of grain sizes using three-point-bending test
por: Yu, Miao, et al.
Publicado: (2018)

The Influence of Lath, Block and Prior Austenite Grain (PAG) Size on the Tensile, Creep and Fatigue Properties of Novel Maraging Steel
por: Simm, Thomas, et al.
Publicado: (2017)

Reliability of Total Grain-Size Distribution of Tephra Deposits
por: Pioli, L., et al.
Publicado: (2019)

Impact of Titanium Dioxide in the Mechanical Recycling of Post-Consumer Polyethylene Terephthalate Bottle Waste: Tensile and Fracture Behavior
por: Loaeza, David, et al.
Publicado: (2021)

Comparison of Grain-Growth Mean-Field Models Regarding Predicted Grain Size Distributions
por: Roth, Marion, et al.
Publicado: (2023)

Pore Size Distribution Characteristics of High Rank Coal with Various Grain Sizes
por: Liu, Ling-li, et al.
Publicado: (2020)

Influence of Fine Grains on the Bending Fatigue Behavior of Two Implant Titanium Alloys
por: Cao, Xiaojian, et al.
Publicado: (2020)

Thermal Stability and Mechanical Behavior of Ultrafine-Grained Titanium with Different Impurity Content
por: Majchrowicz, Kamil, et al.
Publicado: (2023)

Degradation Behavior and Mechanical Integrity of a Mg-0.7Zn-0.6Ca (wt.%) Alloy: Effect of Grain Sizes and Crystallographic Texture
por: Millán-Ramos, Benjamin, et al.
Publicado: (2022)

Effects of Texture and Grain Size on the Yield Strength of ZK61 Alloy Rods Processed by Cyclic Extrusion and Compression
por: Zhang, Lixin, et al.
Publicado: (2017)

The effect of texture and grain size on improving the mechanical properties of Mg-Al-Zn alloys by friction stir processing
por: Peng, Jinhua, et al.
Publicado: (2018)

Influence of Fe and Mn on the Microstructure Formation in 5xxx Alloys—Part II: Evolution of Grain Size and Texture
por: Grasserbauer, Jakob, et al.
Publicado: (2021)

Unlocking Deformation Path in Asymmetric Rolling by Texture Simulation
por: Dhinwal, Satyaveer Singh, et al.
Publicado: (2019)

Textural equilibrium melt geometries around tetrakaidecahedral grains
por: Rudge, John F.
Publicado: (2018)

Tensile deformation behavior of twist grain boundaries in CoCrFeMnNi high entropy alloy bicrystals
por: Lee, Hyunsoo, et al.
Publicado: (2021)

Influence of Accumulative Roll Bonding on the Texture and Tensile Properties of an AZ31 Magnesium Alloy Sheets
por: Trojanová, Zuzanka, et al.
Publicado: (2018)

Characterizing Distributions of Tensile Strength and Crack Precursor Size to Evaluate Filler Dispersion Effects and Reliability of Rubber
por: Robertson, Christopher G., et al.
Publicado: (2020)

Tensile Properties of <111>-Oriented Nanotwinned Cu with Different Columnar Grain Structures
por: Li, Yu-Jin, et al.
Publicado: (2020)

Grain iron and zinc density in pearl millet: combining ability, heterosis and association with grain yield and grain size
por: Kanatti, Anand, et al.
Publicado: (2014)

Secondary electron emission characteristics of untreated and ion-textured titanium
por: Curren, A N, et al.
Publicado: (1989)

Cannot write session to /tmp/vufind_sessions/sess_vku6j4cos498v0acrnrf7mbm43