Cargando…

A Comparative Study on the Addition Methods of TiO(2) Sintering Aid to the Properties of Porous Alumina Membrane Support

TiO(2) is usually used as a sintering aid to lower the sintering temperature of porous alumina membrane support. Two ways of the addition of TiO(2) are chosen: in-situ precipitation and in-situ hydrolysis. The results show that the distribution status of TiO(2) has an important effect on the propert...

Descripción completa

Detalles Bibliográficos
Autores principales:	Yang, Yulong, Chang, Qibing, Hu, Zhiwen, Zhang, Xiaozhen
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2018
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6161020/ https://www.ncbi.nlm.nih.gov/pubmed/30044442 http://dx.doi.org/10.3390/membranes8030049

Ejemplares similares

Microstructure and Mechanical Properties of Microwave Sintered ZrO(2) Bioceramics with TiO(2) Addition
por: Kuo, Hsien-Nan, et al.
Publicado: (2016)

In Situ Investigation of Strain Localization in Sintered, Porous Segmented Alumina
por: Kibitkin, Vladimir, et al.
Publicado: (2021)

Study of the Aid Effect of CuO-TiO(2)-Nb(2)O(5) on the Dielectric and Structural Properties of Alumina Ceramics
por: Shakirzyanov, Rafael I., et al.
Publicado: (2023)

Nanoporous TiN/TiO(2)/Alumina Membrane for Photoelectrochemical Hydrogen Production from Sewage Water
por: Almohammedi, Abdullah, et al.
Publicado: (2021)

The Effect of Particle Shape on Sintering Behavior and Compressive Strength of Porous Alumina
por: Miyake, Kimiya, et al.
Publicado: (2018)

The Effect of TiO(2) Doped Photocatalytic Nano-Additives on the Hydration and Microstructure of Portland and High Alumina Cements
por: Pérez-Nicolás, María, et al.
Publicado: (2017)

Constructing Porous Alumina Frameworks by Sintering for Enhanced Thermal Conductivity of Polymer Composites
por: Wu, Xian, et al.
Publicado: (2022)

Influence of Alumina Grade on Sintering Properties and Possible Application in Binder Jetting Additive Technology
por: Kwiatkowski, Maciej, et al.
Publicado: (2023)

A Hydrogen Gas Sensor Based on TiO(2) Nanoparticles on Alumina Substrate
por: Mohd Chachuli, Siti Amaniah, et al.
Publicado: (2018)

Supercapacitive performance of TiO(2) boosted by a unique porous TiO(2)/Ti network and activated Ti(3+)
por: Wang, Qi, et al.
Publicado: (2019)

Influence of zirconia addition in TiO(2) and TiO(2)–CeO(2) aerogels on the textural, structural and catalytic properties of supported vanadia in chlorobenzene oxidation
por: Gannoun, Chiraz, et al.
Publicado: (2022)

Effect of Two-Step Sintering on Properties of Alumina Ceramics Containing Waste Alumina Powder
por: Vukšić, Milan, et al.
Publicado: (2022)

Effect of TiO(2) as an additive on the sintering performance of Sm-doped CeO(2)-based electrolyte for solid oxide fuel cells
por: Sun, Xuzhuo, et al.
Publicado: (2022)

Effect of TiO(2) on the Sintering Behavior of Low-Grade Vanadiferous Titanomagnetite Ore
por: Yang, Songtao, et al.
Publicado: (2021)

Potential of 3D Hierarchical Porous TiO(2)-Graphene Aerogel (TiO(2)-GA) as Electrocatalyst Support for Direct Methanol Fuel Cells
por: Osman, Siti Hasanah, et al.
Publicado: (2023)

Porous TiO(2) Assembled from Monodispersed Nanoparticles
por: Liu, Xu, et al.
Publicado: (2016)

Compressibility of porous TiO(2) nanoparticle coating on paperboard
por: Stepien, Milena, et al.
Publicado: (2013)

Ordered Porous TiO(2)@C Layer as an Electrocatalyst Support for Improved Stability in PEMFCs
por: Liu, Gaoyang, et al.
Publicado: (2021)

Nanoscale stacking fault–assisted room temperature plasticity in flash-sintered TiO(2)
por: Li, Jin, et al.
Publicado: (2019)

The Effects of Sintering Temperature and Addition of TiH(2) on the Sintering Process of Cu
por: Hao, Huali, et al.
Publicado: (2019)

Improved Microstructure and Hardness Properties of Low-Temperature Microwave-Sintered Y(2)O(3) Stabilized ZrO(2) Ceramics with Additions of Nano TiO(2) Powders
por: Weng, Min-Hang, et al.
Publicado: (2020)

Preparation and morphology-dependent wettability of porous alumina membranes
por: Shimanovich, Dmitry L, et al.
Publicado: (2018)

The Interrelation of Synthesis Conditions and Wettability Properties of the Porous Anodic Alumina Membranes
por: Tishkevich, Daria I., et al.
Publicado: (2022)

Effect of Al(2)TiO(5) Content and Sintering Temperature on the Microstructure and Residual Stress of Al(2)O(3)–Al(2)TiO(5) Ceramic Composites
por: Fan, Kunyang, et al.
Publicado: (2021)

Efficient fabrication of ordered alumina through-hole membranes using a TiO(2) protective layer prepared by atomic layer deposition
por: Yanagishita, Takashi, et al.
Publicado: (2022)

Selective Laser Sintering of Porous Silica Enabled by Carbon Additive
por: Chang, Shuai, et al.
Publicado: (2017)

Effects of TiO(2) structure and Co addition as a second metal on Ru-based catalysts supported on TiO(2) for selective hydrogenation of furfural to FA
por: Tolek, Weerachon, et al.
Publicado: (2021)

Electrochemical Behavior of Inductively Sintered Al/TiO(2) Nanocomposites Reinforced by Electrospun Ceramic Nanofibers
por: Abdo, Hany S., et al.
Publicado: (2021)

Porous Alumina Films with Width-Controllable Alumina Stripes
por: Huang, Kai, et al.
Publicado: (2010)

Highly Flowable Nano TiO(2)/Porous Organic Polymer (POP) Supports for Efficient Metallocene Catalysts
por: Wang, Xiong, et al.
Publicado: (2020)

Sintering Behaviour of Waste Olivine and Olivine/Alumina Blends
por: Furlani, Erika, et al.
Publicado: (2014)

Fabrication of Porous TiO(2) Hollow Spheres and Their Application in Gas Sensing
por: Yang, Gang, et al.
Publicado: (2010)

Hollow Au@TiO(2) porous electrospun nanofibers for catalytic applications
por: Kumar, Labeesh, et al.
Publicado: (2020)

TiO(2)-decorated porous carbon nanofiber interlayer for Li–S batteries
por: Yanilmaz, Meltem
Publicado: (2020)

The optimized preparation of HA/L-TiO(2)/D-TiO(2) composite coating on porous titanium and its effect on the behavior osteoblasts
por: Fu, Xi, et al.
Publicado: (2020)

Effects of TiO(2) Nanoparticle Addition on Microstructure and Selected Properties of Ag–xTiO(2) Composites
por: Wąsik, Anna, et al.
Publicado: (2021)

Microwave and Terahertz Properties of Spark-Plasma-Sintered Zr(0.8)Sn(0.2)TiO(4) Ceramics
por: Nedelcu, Liviu, et al.
Publicado: (2022)

Mesoporous TiO(2)/TiC@C Composite Membranes with Stable TiO(2)-C Interface for Robust Lithium Storage
por: Zhang, Wei, et al.
Publicado: (2018)

Microwave Sintering of SiAlON Ceramics with TiN Addition
por: Sevgi Canarslan, Özgür, et al.
Publicado: (2019)

Effect of Microwave Sintering on the Properties of 0.95(Ca(0.88)Sr(0.12))TiO(3)–0.05(Bi(0.5)Na(0.5))TiO(3) Ceramics
por: Tian, Lei, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_1tg57239gnosaujpu8tblrp3on