Cargando…

Tribological Performance of Microhole-Textured Carbide Tool Filled with CaF(2)

To enhance the friction and wear performance of cemented carbide, textured microholes were machined on micro Electron Discharge Machining (EDM) on the tool rake face, and Calcium Fluoride (CaF(2)) powders were burnished into the microholes. The friction and wear characteristics of the microhole-text...

Descripción completa

Detalles Bibliográficos
Autores principales:	Song, Wenlong, Wang, Shoujun, Lu, Yang, Xia, Zixiang
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2018
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6164090/ https://www.ncbi.nlm.nih.gov/pubmed/30205435 http://dx.doi.org/10.3390/ma11091643

Ejemplares similares

Fabrication and Tribological Performance of Zr-Coated Carbide against 40Cr Hardened Steel
por: Song, Wenlong, et al.
Publicado: (2018)

Tribology Performance of Surface Texturing Plunger
por: Wei, Songbo, et al.
Publicado: (2019)

Microstructure and Tribological Performance of Mesocarbon Microbead–Silicon Carbide Composites
por: Wang, Xiaojie, et al.
Publicado: (2019)

Angular Dependence of Solar Cell Parameters in Crystalline Silicon Solar Cells Textured with Periodic Array of Microholes
por: Altinoluk, Serra, et al.
Publicado: (2020)

Electrodischarge Drilling of Microholes in c-BN
por: Wyszynski, Dominik, et al.
Publicado: (2020)

PTCDA adsorption on CaF(2) thin films
por: Rahe, Philipp
Publicado: (2020)

Epitaxial Growth of Crystalline CaF(2) on Silicene
por: Nazzari, Daniele, et al.
Publicado: (2022)

Performance Optimization of Microvalves Based on a Microhole Array for Microfluidic Chips
por: Sun, Cuimin, et al.
Publicado: (2020)

Radiation-Induced Nucleation and Growth of CaSi(2) Crystals, Both Directly during the Epitaxial CaF(2) Growth and after the CaF(2) Film Formation
por: Dvurechenskii, Anatoly V., et al.
Publicado: (2022)

Luminescence and stability of Tb doped CaF(2) nanoparticles
por: Hasabeldaim, E. H. H., et al.
Publicado: (2023)

Effect of Textured Dimples on the Tribological Behavior of WC/Co Cemented Carbide in Dry Sliding with Al(2)O(3)/WC Ceramic
por: Chen, Jiansong, et al.
Publicado: (2022)

Tribological Properties of Micro-Groove Cemented Carbide by Laser Processing
por: Zheng, Guoqiang, et al.
Publicado: (2021)

Surface Characterization and Tribological Performance of Anodizing Micro-Textured Aluminum-Silicon Alloys
por: Chen, Luanxia, et al.
Publicado: (2019)

Influence of CaF(2)@Al(2)O(3) on Cutting Performance and Wear Mechanism of Al(2)O(3)/Ti(C,N)/CaF(2)@Al(2)O(3) Self-Lubricating Ceramic Tools in Turning
por: Zhang, Shuai, et al.
Publicado: (2020)

Tailored Laser Structuring of Tungsten Carbide Cutting Tools for Improving Their Tribological Performance in Turning Aluminum Alloy Al6061 T6
por: Baumann, Robert, et al.
Publicado: (2023)

Processing and Profile Control of Microhole Array for PDMS Mask with Femtosecond Laser
por: Zhang, Xifang, et al.
Publicado: (2022)

Improving Thermal Conductivity and Tribological Performance of Polyimide by Filling Cu, CNT, and Graphene
por: Liu, Chen, et al.
Publicado: (2023)

Femtosecond Laser Texturing of Surfaces for Tribological Applications
por: Bonse, Jörn, et al.
Publicado: (2018)

Reusability and fractional read-out in CaF${_2}$ :TM (TLD-300)
por: Furetta, C, et al.
Publicado: (1985)

Unveiling the Effect of CaF(2) on the Microstructure and Transport Properties of Phosphosilicate Systems
por: Du, Yizhe, et al.
Publicado: (2022)

Experimental Characterization of Laser Trepanned Microholes in Superalloy GH4220 with Water-Based Assistance
por: Wang, Liang, et al.
Publicado: (2022)

Tribological Investigation of Textured Surfaces in Starved Lubrication Conditions
por: Bhaumik, Shubrajit, et al.
Publicado: (2022)

Annealing cycle effects on the TL sensitivity of CaF${_2}$ :Tm (TLD-300)
por: Furetta, C, et al.
Publicado: (1985)

The properties of CaF2(Dy) used as a thermoluminescent dosimeter at low doses
por: Budd, T A
Publicado: (1976)

CaF(2): A novel electrolyte for all solid-state electrochromic devices
por: Chen, Xi, et al.
Publicado: (2022)

Numerical investigation of the tribological performance of micro-dimple textured surfaces under hydrodynamic lubrication
por: Li, Kangmei, et al.
Publicado: (2017)

Tribology of Pore-Textured Hard Surfaces under Physiological Conditions: Effects of Texture Scales
por: Xi, Yiwen, et al.
Publicado: (2023)

Investigation of the Tribological Characteristics of Aluminum 6061-Reinforced Titanium Carbide Metal Matrix Composites
por: Veeresh Kumar, G. B., et al.
Publicado: (2021)

Effect of Microstructural and Tribological Behaviors of Sputtered Titanium Carbide Thin Film on Copper Substrate
por: Ogunlana, Musibau Olalekan, et al.
Publicado: (2022)

A perforated microhole-based microfluidic device for improving sprouting angiogenesis in vitro
por: Chen, Sijia, et al.
Publicado: (2017)

Picoliter droplet array based on bioinspired microholes for in situ single-cell analysis
por: Du, Lin, et al.
Publicado: (2020)

Understanding Transient Ionic Diode Currents and Impedance Responses for Aquivion-Coated Microholes
por: Carneiro-Neto, Evaldo Batista, et al.
Publicado: (2023)

Addition of Nano CaF(2)@SiO(2) and SiC Whiskers in Ceramic Tools for Wear Reduction and Improved Machinability
por: Zhang, Wenhao, et al.
Publicado: (2022)

Effect of Tb-doped Concentration Variation on the Electrical and Dielectric Properties of CaF(2) Nanoparticles
por: Cui, Xiaoyan, et al.
Publicado: (2018)

Achieving Effective Multimodal Imaging with Rare-Earth Ion-Doped CaF(2) Nanoparticles
por: Yu, Zhenfeng, et al.
Publicado: (2022)

Quantitative fluoride imaging of teeth using CaF emission by laser induced breakdown spectroscopy
por: Martinez, Mauro, et al.
Publicado: (2022)

Dataset on tribological, characterization and thermal properties of Silicon carbide reinforced polyamide composites for industrial applications
por: Kumar, S. Sathees, et al.
Publicado: (2020)

On the Microstructure, Strength, Fracture, and Tribological Properties of Iron-Based MMCs with Addition of Mixed Carbide Nanoparticulates
por: Królczyk, Grzegorz, et al.
Publicado: (2020)

Performance of Cutting Tool with Cross-Chevron Surface Texture Filled with Green Synthesized Aluminium Oxide Nanoparticles
por: N., Sathiya Narayanan, et al.
Publicado: (2019)

Preparation of Al(2)O(3)/Ti(C,N)/ZrO(2)/CaF(2)@Al(OH)(3) Ceramic Tools and Cutting Performance in Turning
por: Chen, Zhaoqiang, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_df4topmb743e10l5ochjtgflvh