Cargando…

Experimental Characterization of Inkjet-Printed Stretchable Circuits for Wearable Sensor Applications

This paper introduces a cost-effective method for the fabrication of stretchable circuits on polydimethylsiloxane (PDMS) using inkjet printing of silver nanoparticle ink. The fabrication method, presented here, allows for the development of fully stretchable and wearable sensors. Inkjet-printed sinu...

Descripción completa

Detalles Bibliográficos
Autores principales:	Abu-Khalaf, Jumana, Saraireh, Razan, Eisa, Saleh, Al-Halhouli, Ala’aldeen
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2018
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6210026/ https://www.ncbi.nlm.nih.gov/pubmed/30332756 http://dx.doi.org/10.3390/s18103476

Ejemplares similares

Fabrication of Stretchable Circuits on Polydimethylsiloxane (PDMS) Pre-Stretched Substrates by Inkjet Printing Silver Nanoparticles
por: Abu-Khalaf, Jumana M., et al.
Publicado: (2018)

Optimization of Geometry Parameters of Inkjet-Printed Silver Nanoparticle Traces on PDMS Substrates Using Response Surface Methodology
por: Abu-Khalaf, Jumana, et al.
Publicado: (2019)

Fabrication and Evaluation of a Novel Non-Invasive Stretchable and Wearable Respiratory Rate Sensor Based on Silver Nanoparticles Using Inkjet Printing Technology
por: Al-Halhouli, Ala’aldeen, et al.
Publicado: (2019)

Monitoring Symptoms of Infectious Diseases: Perspectives for Printed Wearable Sensors
por: Al-Halhouli, Ala’aldeen, et al.
Publicado: (2021)

Clinical Evaluation of Respiratory Rate Measurements on COPD (Male) Patients Using Wearable Inkjet-Printed Sensor
por: Al-Halhouli, Ala’aldeen, et al.
Publicado: (2021)

Sheath-less high throughput inertial separation of small microparticles in spiral microchannels with trapezoidal cross-section
por: Al-Halhouli, Ala'aldeen, et al.
Publicado: (2019)

Inkjet-printed stretchable and low voltage synaptic transistor array
por: Molina-Lopez, F., et al.
Publicado: (2019)

Low Cost Lab on Chip for the Colorimetric Detection of Nitrate in Mineral Water Products
por: Khanfar, Mohammad F., et al.
Publicado: (2017)

High-Efficiency Small Sample Microparticle Fractionation on a Femtosecond Laser-Machined Microfluidic Disc
por: Al-Halhouli, Ala’aldeen, et al.
Publicado: (2020)

An inkjet-printed bendable antenna for wearable electronics
por: Yu, Hang, et al.
Publicado: (2023)

Lab on a Chip for the Colorimetric Determination of Nitrite in Processed Meat Products in the Jordanian Market
por: Khanfar, Mohammad F., et al.
Publicado: (2019)

An In-Line Photonic Biosensor for Monitoring of Glucose Concentrations
por: Al-Halhouli, Ala'aldeen, et al.
Publicado: (2014)

Development of Active Centrifugal Pump for Microfluidic CD Platforms
por: Al-Halhouli, Ala’aldeen, et al.
Publicado: (2020)

New generation of spinning systems for robust active mixing on microfluidic CDs: oil/water emulsion as an evaluation test
por: Al-Halhouli, Ala'aldeen, et al.
Publicado: (2018)

Coaxial Printing of Silicone Elastomer Composite Fibers for Stretchable and Wearable Piezoresistive Sensors
por: Tang, Zhenhua, et al.
Publicado: (2019)

Printed Stretchable Graphene Conductors for Wearable Technology
por: van Hazendonk, Laura S., et al.
Publicado: (2022)

Spiral Microchannels with Trapezoidal Cross Section Fabricated by Femtosecond Laser Ablation in Glass for the Inertial Separation of Microparticles
por: Al-Halhouli, Ala’aldeen, et al.
Publicado: (2018)

Review of Recent Inkjet-Printed Capacitive Tactile Sensors
por: Salim, Ahmed, et al.
Publicado: (2017)

An Atlas for the Inkjet Printing of Large-Area Tactile Sensors
por: Baldini, Giulia, et al.
Publicado: (2022)

Inkjet-Printed Temperature Sensors Characterized according to Standards
por: Jäger, Jonas, et al.
Publicado: (2022)

Soft Stretchable Conductive Carboxymethylcellulose Hydrogels for Wearable Sensors
por: Park, Kyuha, et al.
Publicado: (2022)

Stretchable Sensors: Novel Human Motion Monitoring Wearables
por: Cho, Chia-Jung, et al.
Publicado: (2023)

Solution‐Processed Vertically Stacked Complementary Organic Circuits with Inkjet‐Printed Routing
por: Kwon, Jimin, et al.
Publicado: (2016)

A Printed Organic Circuit System for Wearable Amperometric Electrochemical Sensors
por: Shiwaku, Rei, et al.
Publicado: (2018)

Over-Stretching Tolerant Conductors on Rubber Films by Inkjet-Printing Silver Nanoparticles for Wearables
por: Albrecht, Andreas, et al.
Publicado: (2018)

Tailoring inkjet-printed PEDOT:PSS composition toward green, wearable device fabrication
por: Galliani, Marina, et al.
Publicado: (2023)

Printed Electronics as Prepared by Inkjet Printing
por: Beedasy, Vimanyu, et al.
Publicado: (2020)

A Flexible Proximity Sensor Fully Fabricated by Inkjet Printing
por: Wang, Chin-Tsan, et al.
Publicado: (2010)

Paper as Active Layer in Inkjet-Printed Capacitive Humidity Sensors
por: Gaspar, Cristina, et al.
Publicado: (2017)

Inkjet-Printed Functionalization of CMUT-Based CO(2) Sensors
por: Barauskas, Dovydas, et al.
Publicado: (2022)

Printable Stretchable Silver Ink and Application to Printed RFID Tags for Wearable Electronics
por: Zhong, Tao, et al.
Publicado: (2019)

Enhanced inertial focusing of microparticles and cells by integrating trapezoidal microchambers in spiral microfluidic channels
por: Al-Halhouli, Ala'aldeen, et al.
Publicado: (2019)

Inkjet Printing of Carbon Nanotubes
por: Tortorich, Ryan P., et al.
Publicado: (2013)

Chromatographic Effects in Inkjet Printing
por: Venditti, Gianmarco, et al.
Publicado: (2021)

Fully inkjet-printed two-dimensional material field-effect heterojunctions for wearable and textile electronics
por: Carey, Tian, et al.
Publicado: (2017)

Optimized inkjet-printed silver nanoparticle films: theoretical and experimental investigations
por: Mypati, Sreemannarayana, et al.
Publicado: (2018)

Inkjet printed circuits based on ambipolar and p-type carbon nanotube thin-film transistors
por: Kim, Bongjun, et al.
Publicado: (2017)

Fabrication of Bendable Circuits on a Polydimethylsiloxane (PDMS) Surface by Inkjet Printing Semi-Wrapped Structures
por: Sun, Jiazhen, et al.
Publicado: (2016)

All Inkjet-Printed Graphene-Silver Composite Ink on Textiles for Highly Conductive Wearable Electronics Applications
por: Karim, Nazmul, et al.
Publicado: (2019)

Inkjet Printable Polydimethylsiloxane for All-Inkjet-Printed Multilayered Soft Electrical Applications
por: Mikkonen, Riikka, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_87mmm0m3r07ulh2jgq9b4d85o1