Cargando…
A Comparison of Ethylene-Tar-Derived Isotropic Pitches Prepared by Air Blowing and Nitrogen Distillation Methods and Their Carbon Fibers
Two isotropic pitches were prepared by air blowing and nitrogen distillation methods using ethylene tar (ET) as a raw material. The corresponding carbon fibers were obtained through conventional melt spinning, stabilization, and carbonization. The structures and properties of the resultant pitches a...
Autores principales: | Shi, Kui, Yang, Jianxiao, Ye, Chong, Liu, Hongbo, Li, Xuanke |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2019
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6356327/ https://www.ncbi.nlm.nih.gov/pubmed/30669384 http://dx.doi.org/10.3390/ma12020305 |
Ejemplares similares
-
Constructing the Bridge from Isotropic to Anisotropic
Pitches for Preparing Pitch-Based Carbon Fibers with Tunable Structures
and Properties
por: Yuan, Guanming, et al.
Publicado: (2020) -
Preparation of Isotropic Carbon Fibers from Kerosene-Purified Coal Tar Pitch by Co-Carbonization with Pyrolysis Fuel Oil
por: Lee, Seon Ho, et al.
Publicado: (2021) -
Effects of Bromination-Dehydrobromination on the Microstructure of Isotropic Pitch Precursors for Carbon Fibers
por: Liang, Dingcheng, et al.
Publicado: (2020) -
Distilled Tar Water in the Treatment of Hemorrhages
Publicado: (1888) -
Ablation Behavior of the SiC-Coated Three-Dimensional Highly Thermal Conductive Mesophase-Pitch-Based Carbon-Fiber-Reinforced Carbon Matrix Composite under Plasma Flame
por: Ye, Chong, et al.
Publicado: (2019)