Cargando…
Influence of the Oxide and Ethanol Surface Layer on Phase Transformation of Al-Based Nanocomposite Powders under High-Energy Milling
Pure Al particles reinforced with amorphous-nanocrystalline Cu(36)Zr(48)Ag(8)Al(8) particles composite powders were prepared by high-energy milling without and with ethanol. The mechanical milling procedures were compared so that in the case of dry milling the particle size increased owing to cold w...
Autor principal: | Janovszky, Dora |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2019
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6515449/ https://www.ncbi.nlm.nih.gov/pubmed/31010079 http://dx.doi.org/10.3390/ma12081305 |
Ejemplares similares
-
Phase Transformation and Morphology Evolution of Ti(50)Cu(25)Ni(20)Sn(5) during Mechanical Milling
por: Janovszky, Dora, et al.
Publicado: (2018) -
Effect of Milling Time on the Microstructure, Physical and Mechanical Properties of Al-Al(2)O(3) Nanocomposite Synthesized by Ball Milling and Powder Metallurgy
por: Toozandehjani, Meysam, et al.
Publicado: (2017) -
The Influence of Powder Milling on Properties of SPS Compacted FeAl
por: Michalcová, Alena, et al.
Publicado: (2020) -
Preparation of polypropylene/Mg–Al layered double hydroxides nanocomposites through wet pan-milling: non-isothermal crystallization behaviour
por: Zheng, Yilei, et al.
Publicado: (2018) -
Magnetism and ε-τ Phase Transformation in MnAl-Based Nanocomposite Magnets
por: Crisan, Alina Daniela, et al.
Publicado: (2021)