Cargando…
PA12 Powder Recycled from SLS for FDM
In this study, Polyamide 12 (PA12) powder recycled after selective laser sintering (SLS) was made into filaments for fused deposition modelling (FDM). Compared with fresh PA12, the melt flow rate (MFR) of the recycled PA12 powder decreased by 77%, but the mechanical properties were only slightly red...
Autores principales: | Feng, Li, Wang, Yan, Wei, Qinya |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2019
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6523659/ https://www.ncbi.nlm.nih.gov/pubmed/31013575 http://dx.doi.org/10.3390/polym11040727 |
Ejemplares similares
-
On the Reuse of SLS Polyamide 12 Powder
por: Gomes, Pedro C., et al.
Publicado: (2022) -
Environmental and Economic Analysis of FDM, SLS and MJF Additive Manufacturing Technologies
por: Tagliaferri, Vincenzo, et al.
Publicado: (2019) -
Preparation of nickel/PA12 composite particles by defect-induced electroless plating for use in SLS processing
por: Gui, Chengmei, et al.
Publicado: (2018) -
Flatwise to Upright Build Orientations under Three-Point Bending Test of Nylon 12 (PA12) Additively Manufactured by SLS
por: Baba, Marius Nicolae
Publicado: (2022) -
3D/4D Printing of Polymers: Fused Deposition Modelling (FDM), Selective Laser Sintering (SLS), and Stereolithography (SLA)
por: Kafle, Abishek, et al.
Publicado: (2021)