Cargando…

Experimental and Numerical Investigations of Thin-Walled Stringer-Stiffened Panels Welded with RFSSW Technology under Uniaxial Compression

Many aircraft structures are thin walled and stringer-stiffened, and therefore, prone to a loss of stability. This paper deals with accurate and validated stability analysis of the model of aircraft skin under compressive loading. Both experimental and numerical analyzes are conducted. Two different...

Descripción completa

Detalles Bibliográficos
Autores principales:	Kubit, Andrzej, Trzepiecinski, Tomasz, Święch, Łukasz, Faes, Koen, Slota, Jan
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2019
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6601042/ https://www.ncbi.nlm.nih.gov/pubmed/31159451 http://dx.doi.org/10.3390/ma12111785

Ejemplares similares

Investigation into the Effect of RFSSW Parameters on Tensile Shear Fracture Load of 7075-T6 Alclad Aluminium Alloy Joints
por: Kubit, Andrzej, et al.
Publicado: (2021)

Ultimate Load-Carrying Ability of Rib-Stiffened 2024-T3 and 7075-T6 Aluminium Alloy Panels under Axial Compression
por: Slota, Ján, et al.
Publicado: (2021)

Strength Analysis of a Rib-Stiffened GLARE-Based Thin-Walled Structure
por: Kubit, Andrzej, et al.
Publicado: (2020)

Cross-Influence between Intra-Laminar Damages and Fibre Bridging at the Skin–Stringer Interface in Stiffened Composite Panels under Compression
por: Russo, Angela, et al.
Publicado: (2019)

Failure Analysis of Hat-Stringer-Stiffened Aircraft Composite Panels under Four-Point Bending Loading
por: Li, Binkai, et al.
Publicado: (2022)

Multi-Criteria Optimisation of Friction Stir Welding Parameters for EN AW-2024-T3 Aluminium Alloy Joints
por: Kubit, Andrzej, et al.
Publicado: (2022)

Surface Finish Analysis in Single Point Incremental Sheet Forming of Rib-Stiffened 2024-T3 and 7075-T6 Alclad Aluminium Alloy Panels
por: Trzepieciński, Tomasz, et al.
Publicado: (2021)

An Experimental and Numerical Study on Impact and Compression after Impact of Stiffened Composite Panels
por: Wang, Peiyan, et al.
Publicado: (2022)

Experimental and Numerical Studies of Low-Profile, Triangular Grid-Stiffened Plates Subjected to Shear Load in the Post-Critical States of Deformation
por: Święch, Łukasz
Publicado: (2019)

Effect of Sandblasting on Static and Fatigue Strength of Flash Butt Welded 75Cr4 Bandsaw Blades
por: Kubit, Andrzej, et al.
Publicado: (2021)

Uncoupling shear and uniaxial elastic moduli of semiflexible biopolymer networks: compression-softening and stretch-stiffening
por: van Oosten, Anne S. G., et al.
Publicado: (2016)

An Experimental Study of the Frictional Properties of Steel Sheets Using the Drawbead Simulator Test
por: Trzepiecinski, Tomasz, et al.
Publicado: (2019)

Effect of Corrosion Protection Method on Properties of RSW and RFSSW Lap Joints Applied in Production of Thin-Walled Aerostructures
por: Dudek, Agata, et al.
Publicado: (2020)

Investigating Residual Stresses in Metal-Plastic Composites Stiffening Ribs Formed Using the Single Point Incremental Forming Method
por: Kubit, Andrzej, et al.
Publicado: (2022)

On the Influence of Linear Energy/Heat Input Coefficient on Hardness and Weld Bead Geometry in Chromium-Rich Stringer GMAW Coatings
por: Pawlik, Jan, et al.
Publicado: (2022)

Numerical Investigation on Guided Waves Dispersion and Scattering Phenomena in Stiffened Panels
por: De Luca, Alessandro, et al.
Publicado: (2021)

Numerical Simulation of Dynamic Mechanical Properties of Concrete under Uniaxial Compression
por: Peng, Yijiang, et al.
Publicado: (2019)

The Effect of Shot Peening on Residual Stress and Surface Roughness of AMS 5504 Stainless Steel Joints Welded Using the TIG Method
por: Bucior, Magdalena, et al.
Publicado: (2022)

Technologies for Joining and Forming Thin-Walled Structures in the Construction of Transportation Vehicles
por: Fydrych, Dariusz, et al.
Publicado: (2023)

Experimental and Numerical Study on Uniaxial Compression Failure of Concrete Confined by Nylon Ties
por: Wang, Hui, et al.
Publicado: (2022)

Experimental and Numerical Study of Vacuum Resin Infusion of Stiffened Carbon Fiber Reinforced Panels
por: Lionetto, Francesca, et al.
Publicado: (2020)

Predicting Welding Distortion in a Panel Structure with Longitudinal Stiffeners Using Inherent Deformations Obtained by Inverse Analysis Method
por: Liang, Wei, et al.
Publicado: (2014)

Numerical Simulation of Failure Behavior of Brittle Heterogeneous Rock under Uniaxial Compression Test
por: Liu, Jia, et al.
Publicado: (2022)

Experiment and Numerical Simulation for the Compressive Buckling Behavior of Double-Sided Laser-Welded Al–Li Alloy Aircraft Fuselage Panel
por: Zhang, Yunlong, et al.
Publicado: (2020)

Numerical Simulation of Uniaxial Compressive Strength and Failure Characteristics of Non-Uniform Water-Bearing Sandstone
por: Song, Mingwei, et al.
Publicado: (2023)

Lamb Wave Line Sensing for Crack Detection in a Welded Stiffener
por: An, Yun-Kyu, et al.
Publicado: (2014)

Experimental Behavior of Thin-Tile Masonry under Uniaxial Compression. Multi-Leaf Case Study
por: Llorens, Joan, et al.
Publicado: (2021)

Numerical Studies on the Failure Process of Heterogeneous Brittle Rocks or Rock-Like Materials under Uniaxial Compression
por: Guo, Songfeng, et al.
Publicado: (2017)

Experimental and Numerical Analysis of a Composite Thin-Walled Cylindrical Structures with Different Variants of Stiffeners, Subjected to Torsion
por: Kopecki, Tomasz, et al.
Publicado: (2019)

Pneumocystis carinii versus Pneumocystis jiroveci: Another Misnomer (Response to Stringer et al.)
por: Hughes, Walter T.
Publicado: (2003)

Numerical simulation of welding
por: Bergheau, J M
Publicado: (2004)

Analysis of Surface Texture and Roughness in Composites Stiffening Ribs Formed by SPIF Process
por: Al-Sabur, Raheem, et al.
Publicado: (2023)

Experimental and Numerical Investigation of 3D Printing PLA Origami Tubes under Quasi-Static Uniaxial Compression
por: Chen, Weidong, et al.
Publicado: (2022)

Unique Role of Vimentin Networks in Compression Stiffening of Cells and Protection of Nuclei from Compressive Stress
por: Pogoda, Katarzyna, et al.
Publicado: (2022)

Fatal Second Impact Syndrome in Rowan Stringer, A 17-Year-Old Rugby Player
por: Tator, Charles, et al.
Publicado: (2019)

Deformation Behavior of Human Dentin under Uniaxial Compression
por: Zaytsev, Dmitry, et al.
Publicado: (2012)

Method to study cell migration under uniaxial compression
por: Srivastava, Nishit, et al.
Publicado: (2017)

Effect of the Uniaxial Compression on the GaAs Nanowire Solar Cell
por: Alekseev, Prokhor A., et al.
Publicado: (2020)

Transverse susceptibility of nickel thin films with uniaxial anisotropy
por: Mathews, Scott A., et al.
Publicado: (2021)

Modelling of Friction Phenomena Existed in Drawbead in Sheet Metal Forming
por: Trzepieciński, Tomasz, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_r61j4irbflhbf17bh2ieln6l2r