Cargando…

Exploring the Effect of Poly(propylene carbonate) Polyol in a Biobased Epoxy Interpenetrating Network

[Image: see text] Poly(propylene carbonate) (PPC) polyol derived from carbon dioxide has been used to make a tough biobased interpenetrating polymer network (IPN). PPC polyol (10, 20, and 30 phr) was added to an epoxy/poly(furfuryl alcohol) IPN, and the effect of PPC polyol on the tensile modulus, t...

Descripción completa

Detalles Bibliográficos
Autores principales: Roudsari, Ghodsieh Mashouf, Mohanty, Amar K., Misra, Manjusri
Formato: Online Artículo Texto
Lenguaje:English
Publicado: American Chemical Society 2017
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6641153/
https://www.ncbi.nlm.nih.gov/pubmed/31457458
http://dx.doi.org/10.1021/acsomega.6b00458
Descripción
Sumario:[Image: see text] Poly(propylene carbonate) (PPC) polyol derived from carbon dioxide has been used to make a tough biobased interpenetrating polymer network (IPN). PPC polyol (10, 20, and 30 phr) was added to an epoxy/poly(furfuryl alcohol) IPN, and the effect of PPC polyol on the tensile modulus, tensile strength, tensile toughness, and notched Izod impact strength was determined. Dynamic mechanical analysis (DMA) was used to investigate the effect of PPC polyol on the glass-transition temperature. Loss area (LA) as a characteristic of IPN damping properties was evaluated using DMA. Scanning electron microscopy (SEM) and atomic force microscopy (AFM) were used to obtain more information on the morphology of IPNs on the micro- and nanoscale. It was found that the incorporation of PPC polyol improved the notched Izod impact strength and tensile toughness up to 190 and 220%, respectively. The damping factor peak was broadened with the addition of PPC polyol, and the glass-transition temperature was decreased as the amount of PPC polyol increased. The IPN with 20 phr PPC polyol exhibited better damping properties than neat epoxy and the epoxy/PFA IPN. SEM and AFM images revealed that PPC polyol domains were dispersed in the epoxy phase with an average diameter of around 280 nm.