Cargando…

Effects of Ultrasonic Treatment on the Microstructure and Mechanical Properties of Mg-3Y-3.5Sm-2Zn-0.6Zr (wt %) Alloy

Ultrasonic treatment (UST) was applied in the smelting process of Mg-3Y-3.5Sm-2Zn-0.6Zr (wt %) alloy and the microstructure as well as mechanical properties of the experimental alloy were investigated. Results showed that the effect of UST on grain refinement was obvious, and the distribution of the...

Descripción completa

Detalles Bibliográficos
Autores principales:	Liu, Minghua, Li, Miaomiao, Wang, Along, Zhang, Mengqi, Wang, Wei, Wang, Wenli
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2019
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6747611/ https://www.ncbi.nlm.nih.gov/pubmed/31450671 http://dx.doi.org/10.3390/ma12172722

Ejemplares similares

Microstructure and properties evolution of Mg–2Y–0.6Nd–0.6Zr alloy rolled at room and liquid nitrogen temperature
por: Tan, Yun, et al.
Publicado: (2021)

Effect of Cold Working on the Properties and Microstructure of Cu-3.5 wt% Ti Alloy
por: Huang, Lue, et al.
Publicado: (2022)

Study of Structure and Mechanical Properties of Fine-Grained Aluminum Alloys Al-0.6wt.%Mg-Zr-Sc with Ratio Zr:Sc = 1.5 Obtained by Cold Drawing
por: Nokhrin, Aleksey, et al.
Publicado: (2019)

A Study on the Effect of Ultrasonic Treatment on the Microstructure of Sn-30 wt.% Bi Alloy
por: Wang, Shuo, et al.
Publicado: (2018)

Microstructure and Hot Deformation Behavior of the Mg–8 wt.% Sn–1.5 wt.% Al Alloy
por: Sun, Zhaoqian, et al.
Publicado: (2021)

Enhanced Grain Refinement and Precipitation of the IEECAPed Mg-Sm-Zn-Zr Alloy by Nd Addition
por: Liu, Kun, et al.
Publicado: (2021)

Microstructures, Mechanical Properties, and Corrosion Behavior of As-Cast Mg–2.0Zn–0.5Zr–xGd (wt %) Biodegradable Alloys
por: Yao, Huai, et al.
Publicado: (2018)

Effect of Ca and Zr Additions on Microstructure and Mechanical Properties of As-Extruded Mg-3Sn Alloy
por: Jia, Zheng, et al.
Publicado: (2022)

An Enhanced Understanding of the Powder Bed Fusion–Laser Beam Processing of Mg-Y(3.9wt%)-Nd(3wt%)-Zr(0.5wt%) (WE43) Alloy through Thermodynamic Modeling and Experimental Characterization
por: Nilsson Åhman, Hanna, et al.
Publicado: (2022)

Effects of Fe-Ions Irradiation on the Microstructure and Mechanical Properties of FeCrAl-1.5wt.% ZrC Alloys
por: Wang, Runzhong, et al.
Publicado: (2021)

Effects of the Mg/Si Ratio on Microstructure, Mechanical Properties, and Precipitation Behavior of Al–Mg–Si–1.0 wt %-Zn Alloys
por: Li, Yong, et al.
Publicado: (2018)

Achieving excellent superplasticity of Mg-7Zn-5Gd-0.6Zr alloy at low temperature regime
por: Yin, Siqi, et al.
Publicado: (2019)

The Effect of (Mg, Zn)(12)Ce Phase Content on the Microstructure and the Mechanical Properties of Mg–Zn–Ce–Zr Alloy
por: Li, Yuguang, et al.
Publicado: (2022)

Synthesizing Ag(+): MgS, Ag(+): Nb(2)S(5), Sm(3+): Y(2)S(3), Sm(3+):Er(2)S(3), and Sm(3+):ZrS(2) Compound Nanoparticles for Multicolor Fluorescence Imaging of Biotissues
por: Li, Zongan, et al.
Publicado: (2020)

The Influence of the Deformation Method on the Microstructure and Properties of Magnesium Alloy Mg-Y-RE-Zr
por: Bednarczyk, Iwona, et al.
Publicado: (2022)

The Microstructural Evolution and Grain Growth Kinetics of Fine-Grained Extruded Mg-Nd-Zn-Zr Alloy
por: Jiao, Xueyan, et al.
Publicado: (2022)

Production of (Sm,Zr)(Fe,Co)(3) magnets
por: Saito, Tetsuji
Publicado: (2022)

Discrepancies in the Microstructures of Annealed Cu–Zr Bulk Alloy and Cu–Zr Alloy Films
por: Sun, Haoliang, et al.
Publicado: (2019)

Heterogeneous nucleation of β-type precipitates on nanoscale Zr-rich particles in a Mg-6Zn-0.5Cu-0.6Zr alloy
por: Zhu, Hongmei, et al.
Publicado: (2012)

Microstructure and Porosity Evolution of the Ti–35Zr Biomedical Alloy Produced by Elemental Powder Metallurgy
por: Matuła, Izabela, et al.
Publicado: (2020)

Fabrication and wear behaviour of Mg-3wt.%Al-x wt. % SiC composites
por: Jayasathyakawin, S., et al.
Publicado: (2023)

Microstructure and Texture Evolution of Mg-Gd-Y-Zr Alloy during Reciprocating Upsetting-Extrusion
por: Wu, Guoqin, et al.
Publicado: (2020)

Microstructure and Texture Evolution of Mg–Gd–Y–Zn–Zr Alloy by Compression–Torsion Deformation
por: Xu, Ping, et al.
Publicado: (2019)

Effect of Sn Content on the Microstructure, Mechanical Properties and Corrosion Behavior of Biodegradable Mg–x (1, 3 and 5 wt.%) Sn–1Zn–0.5Ca Alloys
por: Zhao, Zheng-Xue, et al.
Publicado: (2018)

Effect of Zr and Er Addition on the Microstructural Evolution of a Novel Al−Mg−Zn−Er−Zr Alloy during Hot Compression
por: Wu, Minbao, et al.
Publicado: (2023)

Degradation Behavior and Mechanical Integrity of a Mg-0.7Zn-0.6Ca (wt.%) Alloy: Effect of Grain Sizes and Crystallographic Texture
por: Millán-Ramos, Benjamin, et al.
Publicado: (2022)

Effect of the Microstructure and Distribution of the Second Phase on the Stress Corrosion Cracking of Biomedical Mg-Zn-Zr-xSr Alloys
por: Chen, Lianxi, et al.
Publicado: (2018)

Effect of LPSO and SFs on microstructure evolution and mechanical properties of Mg-Gd-Y-Zn-Zr alloy
por: Xu, Chao, et al.
Publicado: (2017)

Microstructural Study of a Mg–Zn–Zr Alloy Hot Compressed at a High Strain Rate
por: You, Jing, et al.
Publicado: (2020)

Effect of Er on Microstructure and Corrosion Behavior of Al–Zn–Mg–Cu–Sc–Zr Aluminum Alloys
por: Xing, Qingyuan, et al.
Publicado: (2022)

Dynamic Precipitation in Mg–8.08Gd–2.41Sm–0.30Zr Alloy during Hot Compression
por: Zhu, Limin, et al.
Publicado: (2018)

Effects of Complex Modification by Sr–Sb on the Microstructures and Mechanical Properties of Al–18 wt % Mg(2)Si–4.5Cu Alloys
por: Sun, Youhong, et al.
Publicado: (2016)

Microstructures and Mechanical Properties of a Nanostructured Al-Zn-Mg-Cu-Zr-Sc Alloy under Natural Aging
por: Shen, Gaoliang, et al.
Publicado: (2023)

Microstructure and hydrogen storage kinetics of Mg(89)RE(11) (RE = Pr, Nd, Sm) binary alloys
por: Chen, Li, et al.
Publicado: (2019)

Hot Deformation Behavior and Processing Maps of an As-Cast Al-5Mg-3Zn-1Cu (wt%) Alloy
por: Lei, Chuan, et al.
Publicado: (2023)

Ageing behavior of extruded Mg–8.2Gd–3.8Y–1.0Zn–0.4Zr (wt.%) alloy containing LPSO phase and γ′ precipitates
por: Xu, C., et al.
Publicado: (2017)

Microstructure Evolution in Mg-Zn-Zr-Gd Biodegradable Alloy: The Decisive Bridge Between Extrusion Temperature and Performance
por: Yao, Huai, et al.
Publicado: (2018)

Deformation Mechanism, Microstructure, and Mechanical Properties Evolution of Mg–Gd–Y–Zr Alloy during Cold Torsion
por: Xiao, Hongchao, et al.
Publicado: (2021)

Microstructure and Mechanical Properties of an Al–Mg–Si–Zr Alloy Processed by L-PBF and Subsequent Heat Treatments
por: Yang, Wonseok, et al.
Publicado: (2022)

Effect of Zn Addition on the Microstructure, Mechanical Properties, and Fracture Behavior of As-Cast Mg-Gd-Y-Zr Alloys
por: Xia, Xiangsheng, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_eb2vtgqilq3k3guf9od7fk228i