Cargando…

Promoted Anodizing Reaction and Enhanced Coating Performance of Al–11Si Alloy: The Role of an Equal-Channel-Angular-Pressed Substrate

In this paper, the effect of the equal-channel-angular-pressed (ECAPed) substrate on the coating formation and anticorrosion performance of the anodized Al–11Si alloy was systematically investigated. The ECAP process dramatically refines both Al and Si phases of the alloy. The parallel anodizing cir...

Descripción completa

Detalles Bibliográficos
Autores principales:	Zhou, Zhikai, Song, Dan, Liang, Ningning, Jiang, Haiyang, Gao, Bo, Wu, Yuna, Ma, Aibin, Qiao, Yanxin, Sun, Jiapeng, Jiang, Jinghua, Ma, Xiaolong
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2019
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6804279/ https://www.ncbi.nlm.nih.gov/pubmed/31590409 http://dx.doi.org/10.3390/ma12193255

Ejemplares similares

The Effect of Rotary-Die Equal-Channel Angular Pressing Process on the Microstructure, the Mechanical and Friction Properties of GW103 Alloy
por: Chen, Cai, et al.
Publicado: (2022)

Microstructure and Properties of Mg-Zn-Y Alloy Powder Compacted by Equal Channel Angular Pressing
por: Chiu, Chun, et al.
Publicado: (2018)

Microstructural Evolution, Hardness, and Strengthening Mechanisms in SLM AlSi10Mg Alloy Subjected to Equal-Channel Angular Pressing (ECAP)
por: Snopiński, Przemysław, et al.
Publicado: (2021)

Micro-Tensile Behavior of Mg-Al-Zn Alloy Processed by Equal Channel Angular Pressing (ECAP)
por: Máthis, Kristián, et al.
Publicado: (2018)

Structure Optimization of a Fe–Mn–Pd Alloy by Equal-Channel Angular Pressing for Biomedical Use
por: Rybalchenko, Olga, et al.
Publicado: (2022)

Investigation of Microstructure and Mechanical Properties of SLM-Fabricated AlSi10Mg Alloy Post-Processed Using Equal Channel Angular Pressing (ECAP)
por: Snopiński, Przemysław, et al.
Publicado: (2022)

Influence of Equal Channel Angular Pressing Passes on the Microstructures and Tensile Properties of Mg-8Sn-6Zn-2Al Alloy
por: Cheng, Weili, et al.
Publicado: (2017)

Deformation of high density polyethylene by dynamic equal-channel-angular pressing
por: Wu, Xiangji, et al.
Publicado: (2018)

High Temperature Deformation of Twin-Roll Cast Al-Mn-Based Alloys after Equal Channel Angular Pressing
por: Málek, Přemysl, et al.
Publicado: (2015)

The Effect of Equal-Channel Angular Pressing on the Microstructure, the Mechanical and Corrosion Properties and the Anti-Tumor Activity of Magnesium Alloyed with Silver
por: Estrin, Yuri, et al.
Publicado: (2019)

Stress Corrosion Cracking Behavior of Fine-Grained Al5083 Alloys Processed by Equal-Channel Angular Pressing (ECAP)
por: Seikh, Asiful H., et al.
Publicado: (2021)

Bioactivity Features of a Zn-1%Mg-0.1%Dy Alloy Strengthened by Equal-Channel Angular Pressing
por: Martynenko, Natalia, et al.
Publicado: (2023)

Effects of Built Direction and Deformation Temperature on the Grain Refinement of 3D Printed AlSi10Mg Alloy Processed by Equal Channel Angular Pressing (ECAP)
por: Snopiński, Przemysław, et al.
Publicado: (2023)

Impact of Equal Channel Angular Pressing on Mechanical Behavior and Corrosion Resistance of Hot-Rolled Ti-2Fe-0.1B Alloy
por: Wang, Yanhuai, et al.
Publicado: (2020)

The Correlation of Microstructure and Mechanical Properties of In-Situ Al-Mg(2)Si Cast Composite Processed by Equal Channel Angular Pressing
por: Chegini, Mahdi, et al.
Publicado: (2019)

Wear Behavior of the Multiheterostructured AZ91 Mg Alloy Prepared by ECAP and Aging
por: Xu, Bingqian, et al.
Publicado: (2020)

Microstructure Evolution in High Purity Aluminum Single Crystal Processed by Equal Channel Angular Pressing (ECAP)
por: Dong, Jinfang, et al.
Publicado: (2017)

Effect of Equal Channel Angular Pressing on the Dynamic Softening Behavior of Ti-6Al-4V Alloy in the Hot Deformation Process
por: Zhao, Zhiyong, et al.
Publicado: (2021)

Effect of the Equal Channel Angular Pressing on the Microstructure and Phase Composition of a 7xxx Series Al-Zn-Mg-Zr Alloy
por: Ahmed, Anwar Qasim, et al.
Publicado: (2023)

Development of High-Performance Enamel Coating on Grey Iron by Low-Temperature Sintering
por: Song, Dan, et al.
Publicado: (2018)

Decreasing Bio-Degradation Rate of the Hydrothermal-Synthesizing Coated Mg Alloy via Pre-Solid-Solution Treatment
por: Song, Dan, et al.
Publicado: (2017)

Investigation of Severe Plastic Deformation Effects on Magnesium RZ5 Alloy Sheets Using a Modified Multi-Pass Equal Channel Angular Pressing (ECAP) Technique
por: Sahoo, Partha Sarathi, et al.
Publicado: (2023)

Wear Behavior and Microstructure of Mg-Sn Alloy Processed by Equal Channel Angular Extrusion
por: Chen, Jung-Hsuan, et al.
Publicado: (2017)

Coupling Effect of Porosity and Cell Size on the Deformation Behavior of Al Alloy Foam under Quasi-Static Compression
por: Yang, Donghui, et al.
Publicado: (2019)

Extensive Broadband Near-Infrared Emissions from Ge(x)Si(1−x) Alloys on Micro-Hole Patterned Si(001) Substrates
por: Peng, Kun, et al.
Publicado: (2021)

Bio-corrosion impacts on mechanical integrity of ZM21 Mg for orthopaedic implant application processed by equal channel angular pressing
por: Prithivirajan, S., et al.
Publicado: (2021)

Investigating the Microstructure and Mechanical Properties of Aluminum-Matrix Reinforced-Graphene Nanosheet Composites Fabricated by Mechanical Milling and Equal-Channel Angular Pressing
por: Hasanzadeh Azar, Mahdi, et al.
Publicado: (2019)

Microstructural Evolution at Micro/Meso-Scale in an Ultrafine-Grained Pure Aluminum Processed by Equal-Channel Angular Pressing with Subsequent Annealing Treatment
por: Xu, Jie, et al.
Publicado: (2015)

Enhancement of Mechanical Properties and Rolling Formability in AZ91 Alloy by RD-ECAP Processing
por: Xu, Qiong, et al.
Publicado: (2019)

Anodic Fabrication of Ti-Ni-Si-O Nanostructures on Ti10Ni5Si Alloy
por: Li, Ting, et al.
Publicado: (2019)

Decade of Twist Channel Angular Pressing: A Review
por: Macháčková, Adéla
Publicado: (2020)

A porous silicon anode prepared by dealloying a Sr-modified Al–Si eutectic alloy for lithium ion batteries
por: Jiang, Piaopiao, et al.
Publicado: (2022)

Fast Growth of Highly Ordered TiO(2) Nanotube Arrays on Si Substrate under High-Field Anodization
por: Song, Jingnan, et al.
Publicado: (2016)

Ordered GeSi nanorings grown on patterned Si (001) substrates
por: Ma, Yingjie, et al.
Publicado: (2011)

Nanoscale growth of a Sn-guided SiGeSn alloy on Si (111) substrates by molecular beam epitaxy
por: Wang, Liming, et al.
Publicado: (2020)

Influence of Si, Cu, B, and Trace Alloying Elements on the Conductivity of the Al-Si-Cu Alloy
por: Yang, Zhao, et al.
Publicado: (2022)

Properties of Fe–Si Alloy Anode for Lithium-Ion Battery Synthesized Using Mechanical Milling
por: Lee, Kikang, et al.
Publicado: (2022)

Polarization behavior of Pb–Co powder-pressed alloy for electrowinning
por: Wang, Shuai, et al.
Publicado: (2018)

The effect of alloying elements on the properties of pressed and non-pressed biodegradable Fe–Mn–Ag powder metallurgy alloys
por: Caligari Conti, Malcolm, et al.
Publicado: (2019)

Epitaxial growth of SiGe films by annealing Al–Ge alloyed pastes on Si substrate
por: Fukuda, Keisuke, et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_vv14lfm442va4cv3165m5o76gh