Comparative Study on Welding Characteristics of Laser-CMT and Plasma-CMT Hybrid Welded AA6082-T6 Aluminum Alloy Butt Joints

Laser-CMT (Cold Metal Transfer) and plasma-CMT hybrid welding are two promising alternative joining technologies for traditional Metal-Inert-Gas (MIG) welding of the aluminum alloy joints in the high speed trains manufacturing industry. In this work, a comparative study on the weld formation, microstructure, micro-hardness, and mechanical properties of the butt joints in the two welding methods was conducted. The results indicate that the overall quality of the laser-CMT and plasma-CMT welds were good, especially of the laser-CMT hybrid weld, and the laser-CMT hybrid welding process needed a lower heat input. The width of the partially melted zone of the laser-CMT hybrid weld was narrower than that in the plasma-CMT hybrid weld. Micro-hardness test results show that two distinct softening regions were identified in the heat affected zone, and the micro-hardness values of each zone in the laser-CMT hybrid weld were lower than that in the plasma-CMT hybrid weld. The tensile strength of the laser-CMT hybrid welded joints was higher than that of the plasma-CMT hybrid welded joints, which could reach up to 79.4% and 73.7% of the base materials, respectively. All the fractures occurred in the softening region and exhibited a ductile shear fracture with a shear angle of approximately 45°. The fractographs manifested that the laser-CMT and plasma-CMT hybrid welded joints presented ductile fracture and ductile-brittle fracture features, respectively.