Removal of Ammonia from the Municipal Waste Treatment Effluents using Natural Minerals

Due to various ecological problems, it is required to remove the ammonia nitrogen from wastewater. Industrial wastewater that was not subjected to any purification was used in this study, while most processes described in the literature were carried out using synthetically prepared solutions. The study investigated the removal of ammonium ions using ion exchange on various commercial minerals, in 3 h long batch ion-exchange experiments. Furthermore, research on the sodium chloride activation of the selected mineral was conducted. The screening of the mineral with the highest removal potential was conducted taking into account the adsorption capacity (q) and maximal removal efficiency (E), based on the NH(4)(+) ions changes determined using the selective electrode and spectrophotometric cuvette tests. The highest adsorption capacity (q = 4.92 mg/g) of ammonium ions with the maximum removal efficiency (52.3%) was obtained for bentonite, with a 0–0.05 mm particle size. After pretreatment with a 1 mol/L NaCl solution, maximum efficiency increments were observed (55.7%). The Langmuir adsorption isotherm corresponds well with the equilibrium adsorption data (R(2) from 0.97 to 0.98), while the Freundlich model was found to be mismatched (R(2) = 0.77). Based on these results it was concluded that natural sorbents may be effectively applied in wastewater treatment. It can be observed that as the size of sorbent particles gets lower, the adsorption capacity, as well as the removal efficiency, gets higher. The bentonite pretreatment with the NaCl solution did not result in the expected efficiency improvement. The 2 mol/L solution affected about 3.5% of the removal efficiency yield.