Cargando…
Measurements of Forces and Selected Surface Layer Properties of AW-7075 Aluminum Alloy Used in the Aviation Industry after Abrasive Machining
Measurements of forces during machining, especially thin-walled structures typical of the aviation industry, are important in the aspect of instability caused by vibration. One of the last stages of manufacturing by machining is the finishing treatment and deburring of the product’s edges. Brushes w...
Autores principales: | Matuszak, Jakub, Kłonica, Mariusz, Zagórski, Ireneusz |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2019
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6888093/ https://www.ncbi.nlm.nih.gov/pubmed/31717637 http://dx.doi.org/10.3390/ma12223707 |
Ejemplares similares
-
Trochoidal Milling and Neural Networks Simulation of Magnesium Alloys
por: Zagórski, Ireneusz, et al.
Publicado: (2019) -
Effect of the AWJM Method on the Machined Surface Layer of AZ91D Magnesium Alloy and Simulation of Roughness Parameters Using Neural Networks
por: Zagórski, Ireneusz, et al.
Publicado: (2018) -
Tribological Properties of Ni-P/Si(3)N(4) Nanocomposite Layers Deposited by Chemical Reduction Method on Aluminum Alloy AW-7075
por: Czapczyk, Kazimierz
Publicado: (2020) -
The Effect of Abrasive Waterjet Machining Parameters on the Condition of Al-Si Alloy
por: Kulisz, Monika, et al.
Publicado: (2020) -
Microstructure and Properties of Electroless Ni-P/Si(3)N(4) Nanocomposite Coatings Deposited on the AW-7075 Aluminum Alloy
por: Czapczyk, Kazimierz, et al.
Publicado: (2021)