Influence of Manufacturing Technology on the Structure of 80W–20Re Heavy Sinters

Preliminary measurement results of 80W–20Re heavy sinters are presented in this paper. Tested samples were taken from three different technology processes, i.e., resistance sintering (RS), pulse plasma sintering (PPS), and conventional sintering in a vacuum furnace. In the first two cases, the obtai...

Descripción completa

Detalles Bibliográficos
Autores principales: Majewski, Tomasz, Durejko, Tomasz, Urbaniak, Wiesław, Petelska, Aneta D., Łazińska, Magdalena, Zasada, Dariusz, Woźniak, Ryszard
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2019
Materias:
Article
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC6926816/
https://www.ncbi.nlm.nih.gov/pubmed/31795402
http://dx.doi.org/10.3390/ma12233965
Descripción
Sumario:Preliminary measurement results of 80W–20Re heavy sinters are presented in this paper. Tested samples were taken from three different technology processes, i.e., resistance sintering (RS), pulse plasma sintering (PPS), and conventional sintering in a vacuum furnace. In the first two cases, the obtained sinters were of similar usable properties (porosity and microhardness), while for vacuum sintering, the material with high porosity was obtained. At the same time, it was found that sintering with the use of electric current (RS, PPS) generates microstructures with highly elongated grains.

Ejemplares similares