Cargando…

Substitution of Ag for Cu in Cu(2)ZnSn(S,Se)(4): Toward Wide Band Gap Absorbers with Low Antisite Defects for Thin Film Solar Cells

Cation substitution is a promising approach to reduce the antisite defects and further improve the efficiency of Cu(2)ZnSn(S,Se)(4) (CZTSSe) cells. In this paper, silver (Ag) has been introduced into Cu(2)ZnSn(S,Se)(4) (CZTSSe) thin film to replace Cu partially and form (Cu(1-x)Ag(x))(2)ZnSn(S,Se)(4...

Descripción completa

Detalles Bibliográficos
Autores principales:	Wu, Yanjie, Sui, Yingrui, He, Wenjie, Zeng, Fancong, Wang, Zhanwu, Wang, Fengyou, Yao, Bin, Yang, Lili
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7023403/ https://www.ncbi.nlm.nih.gov/pubmed/31947756 http://dx.doi.org/10.3390/nano10010096

Ejemplares similares

Enhancing the Performance of Aqueous Solution-Processed Cu(2)ZnSn(S,Se)(4) Photovoltaic Materials by Mn(2+) Substitution
por: He, Wenjie, et al.
Publicado: (2020)

Insight into the Effect of Selenization Temperature for Highly Efficient Ni-Doped Cu(2)ZnSn(S,Se)(4) Solar Cells
por: Zeng, Fancong, et al.
Publicado: (2022)

A Study on the Effects of Selenization Temperature on the Properties of Na-Doped Cu(2)ZnSn(S,Se)(4) Thin Film and Its Correlation with the Performance of Solar Cells
por: Wang, Zhanwu, et al.
Publicado: (2021)

Exploring the Effect of Selenidation Time on the Ni-Doped Cu(2)ZnSn(S,Se)(4) Solar Cell
por: Zeng, Fancong, et al.
Publicado: (2022)

Optimization of the Selenization Temperature on the Mn-Substituted Cu(2)ZnSn(S,Se)(4) Thin Films and Its Impact on the Performance of Solar Cells
por: Wang, Zhanwu, et al.
Publicado: (2022)

Investigation on the Selenization Treatment of Kesterite Cu(2)Mg(0.2)Zn(0.8)Sn(S,Se)(4) Films for Solar Cell
por: Jiang, Dongyue, et al.
Publicado: (2019)

Inkjet‐Printed Cu(2)ZnSn(S, Se)(4) Solar Cells
por: Lin, Xianzhong, et al.
Publicado: (2015)

Efficient (Cu(1−x)Ag(x))(2)ZnSn(S,Se)(4) solar cells on flexible Mo foils
por: Yu, Xue, et al.
Publicado: (2018)

Solution-Processed Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells Using Elemental Cu, Zn, Sn, S, and Se Powders as Source
por: Guo, Jing, et al.
Publicado: (2015)

Investigation of Optimum Mg Doping Content and Annealing Parameters of Cu(2)Mg(x)Zn(1−x)SnS(4) Thin Films for Solar Cells
por: Sui, Yingrui, et al.
Publicado: (2019)

Performance Enhancement in Powder-Fabricated Cu(2)(ZnSn)Se(4) Solar Cell by Roll Compression
por: Park, Jaehyun, et al.
Publicado: (2023)

Flexible Cu(2)ZnSn(S,Se)(4) solar cells with over 10% efficiency and methods of enlarging the cell area
por: Yang, Kee-Jeong, et al.
Publicado: (2019)

Impact of Na Doping on the Carrier Transport Path in Polycrystalline Flexible Cu(2)ZnSn(S,Se)(4) Solar Cells
por: Jeong, Woo‐Lim, et al.
Publicado: (2020)

A Route to Phase Controllable Cu(2)ZnSn(S(1−x)Se(x))(4) Nanocrystals with Tunable Energy Bands
por: Ji, Shulin, et al.
Publicado: (2013)

Doping of Sb into Cu(2)ZnSn(S,Se)(4) absorber layer via Se&Sb(2)Se(3) co-selenization strategy for enhancing open-circuit voltage of kesterite solar cells
por: Zhao, Benhui, et al.
Publicado: (2022)

Band-gap-graded Cu(2)ZnSn(S(1-x),Se(x))(4) Solar Cells Fabricated by an Ethanol-based, Particulate Precursor Ink Route
por: Woo, Kyoohee, et al.
Publicado: (2013)

Cu(2)ZnSn(S,Se)(4) thin-films prepared from selenized nanocrystals ink
por: Aruna-Devi, R., et al.
Publicado: (2019)

Sulfurization induced surface constitution and its correlation to the performance of solution-processed Cu(2)ZnSn(S,Se)(4) solar cells
por: Zhong, Jie, et al.
Publicado: (2014)

Reducing series resistance in Cu(2)ZnSn(S,Se)(4) nanoparticle ink solar cells on flexible molybdenum foil substrates
por: Xu, Xinya, et al.
Publicado: (2018)

Analytical Modeling and Optimization of Cu(2)ZnSn(S,Se)(4) Solar Cells with the Use of Quantum Wells under the Radiative Limit
por: Rodriguez-Osorio, Karina G., et al.
Publicado: (2023)

Synthesis of simple, low cost and benign sol–gel Cu(2)In(x)Zn(1−x)SnS(4) alloy thin films: influence of different rapid thermal annealing conditions and their photovoltaic solar cells
por: Sui, Yingrui, et al.
Publicado: (2018)

Influence of alkali metals (Na, Li, Rb) on the performance of electrostatic spray-assisted vapor deposited Cu(2)ZnSn(S,Se)(4) solar cells
por: Altamura, Giovanni, et al.
Publicado: (2016)

Mapping Shunting Paths at the Surface of Cu(2)ZnSn(S,Se)(4) Films via Energy-Filtered Photoemission Microscopy
por: Tiwari, Devendra, et al.
Publicado: (2018)

Aqueous-Solution-Processed Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells via an Improved Successive Ion-Layer-Adsorption–Reaction Sequence
por: Suryawanshi, Mahesh P., et al.
Publicado: (2017)

Enhanced efficiency of Cu(2)ZnSn(S,Se)(4) solar cells via anti-reflectance properties and surface passivation by atomic layer deposited aluminum oxide
por: Zhang, Bingye, et al.
Publicado: (2018)

Improving Ultraviolet Responses in Cu(2)ZnSn(S,Se)(4) Thin-Film Solar Cells Using Quantum Dot-Based Luminescent Down-Shifting Layer
por: Jeong, Woo-Lim, et al.
Publicado: (2021)

Spectroscopy and Theoretical Modeling of Phonon Vibration Modes and Band Gap Energy of Cu(2)ZnSn(S(x)Se(1–x))(4) Bulk Crystals and Thin Films
por: Babichuk, Ivan S., et al.
Publicado: (2021)

DMF‐Based Large‐Grain Spanning Cu(2)ZnSn(S (x) ,Se(1‐) (x) )(4) Device with a PCE of 11.76%
por: Cui, Yubo, et al.
Publicado: (2022)

Magnetotransport and conductivity mechanisms in Cu(2)ZnSn(x)Ge(1−x)S(4) single crystals
por: Lähderanta, Erkki, et al.
Publicado: (2018)

Nanoscale observation of surface potential and carrier transport in Cu(2)ZnSn(S,Se)(4) thin films grown by sputtering-based two-step process
por: Kim, Gee Yeong, et al.
Publicado: (2014)

Cu(6)Sn(5) Whiskers Precipitated in Sn3.0Ag0.5Cu/Cu Interconnection in Concentrator Silicon Solar Cells Solder Layer
por: Zhang, Liang, et al.
Publicado: (2017)

First-principles insights into the electronic structure, optical and band alignment properties of earth-abundant Cu(2)SrSnS(4) solar absorber
por: Dzade, Nelson Y.
Publicado: (2021)

Contrasting the Material Chemistry of Cu(2)ZnSnSe(4) and Cu(2)ZnSnS((4–) (x) ())Se(x)
por: Aguiar, Jeffery A., et al.
Publicado: (2016)

Thermoelectric Properties of Cu(2)SnSe(3)-SnS Composite
por: Siyar, Muhammad, et al.
Publicado: (2019)

N-type thermoelectric Ag(8)SnSe(6) with extremely low lattice thermal conductivity by replacing Ag with Cu
por: Yang, Chao, et al.
Publicado: (2021)

Study on the Degradation of Methylene Blue by Cu-Doped SnSe
por: Fan, Li, et al.
Publicado: (2023)

An investigation into the effects of band gap and doping concentration on Cu(In,Ga)Se(2) solar cell efficiency
por: Asaduzzaman, Md., et al.
Publicado: (2016)

Synthesis and Electronic Structure of Mid-Infrared Absorbing Cu(3)SbSe(4) and Cu(x)SbSe(4) Nanocrystals
por: Moser, Annina, et al.
Publicado: (2023)

Ag-Mg antisite defect induced high thermoelectric performance of α-MgAgSb
por: Feng, Zhenzhen, et al.
Publicado: (2017)

Mechanochemical Synthesis of Sustainable Ternary and Quaternary Nanostructured Cu(2)SnS(3), Cu(2)ZnSnS(4), and Cu(2)ZnSnSe(4) Chalcogenides for Thermoelectric Applications
por: Nautiyal, Himanshu, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_jhuh577otleb6a10hsm753fs0h