Cargando…

Influence of Minor Zn Addition on Precipitation Behavior and Intergranular Corrosion Properties of Al-Mg-Si Alloy

The effect of 0.2 wt.% Zn addition on microstructure, age hardening and intergranular corrosion (IGC) properties of Al-Mg-Si alloy were investigated by scanning electron microscope, transmission electron microscope, hardness testing, and electrochemistry testing. The results showed that the addition...

Descripción completa

Detalles Bibliográficos
Autores principales: Chi, Shuiqing, Deng, Yunlai, Xu, Xuehong, Guo, Xiaobin
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2020
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7040899/
https://www.ncbi.nlm.nih.gov/pubmed/32024129
http://dx.doi.org/10.3390/ma13030650
Descripción
Sumario:The effect of 0.2 wt.% Zn addition on microstructure, age hardening and intergranular corrosion (IGC) properties of Al-Mg-Si alloy were investigated by scanning electron microscope, transmission electron microscope, hardness testing, and electrochemistry testing. The results showed that the addition of Zn can accelerate the transformation of GP zones into β″, and make the intragranular precipitates become smaller and with higher density. This is beneficial to the precipitation strengthening of the alloy, leading to obtaining higher hardness and enhancing the age hardening response. The peak hardness of the alloy with the addition of Zn is 125.8 HV which means increasing the hardness by 12.7 HV, compared with the alloy without Zn. However, the addition of Zn makes the precipitate-free zone (PFZ) of the alloy wider, and coarsens the grain boundary precipitates slightly, which result in the reduction of IGC resistance of Al-Mg-Si alloy. The maximum corrosion depth of the Zn-containing alloy is 121.3 μm in the peak age condition, which is 35.7 μm deeper than the alloy without Zn. The result of the potentiodynamic polarization curves also demonstrated the increase of IGC sensitivity. The corrosion current density of the alloy with added Zn is 0.595 μA/cm(2) in the peak age condition, while that for the alloy without Zn is 0.199 μA/cm(2).