Cargando…

Three-Dimensional Finite Element Analysis of the Undercut Anchor Group Effect in Rock Cone Failure

An objective of this study was to investigate the group effect in rock cone failure occurring in pull-out with the use of 3D finite element analysis. At present, undercut anchors are typically applied as structural fasteners of steel elements in concrete buildings; however, new areas for their use a...

Descripción completa

Detalles Bibliográficos
Autores principales:	Jonak, Józef, Siegmund, Michał, Karpiński, Robert, Wójcik, Andrzej
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7143098/ https://www.ncbi.nlm.nih.gov/pubmed/32183419 http://dx.doi.org/10.3390/ma13061332

Ejemplares similares

Numerical Investigation of the Formation of a Failure Cone during the Pullout of an Undercutting Anchor
por: Jonak, Józef, et al.
Publicado: (2023)

The Influence of the Physical-Mechanical Parameters of Rock on the Extent of the Initial Failure Zone under the Action of an Undercut Anchor
por: Jonak, Józef, et al.
Publicado: (2021)

Influence of the Undercut Anchor Head Angle on the Propagation of the Failure Zone of the Rock Medium
por: Jonak, Józef, et al.
Publicado: (2021)

Influence of the Undercut Anchor Head Angle on the Propagation of the Failure Zone of the Rock Medium—Part II
por: Jonak, Józef, et al.
Publicado: (2021)

Determining the Effect of Rock Strength Parameters on the Breakout Area Utilizing the New Design of the Undercut/Breakout Anchor
por: Jonak, Józef, et al.
Publicado: (2022)

Analysis of the Rock Failure Cone Size Relative to the Group Effect from a Triangular Anchorage System
por: Jonak, Józef, et al.
Publicado: (2020)

Aggregate Effect on the Concrete Cone Capacity of an Undercut Anchor under Quasi-Static Tensile Load
por: Marcon, Marco, et al.
Publicado: (2018)

The mechanism and performance of rock breakage by undercutting disc cutter with advanced slotting
por: Jiang, Hongxiang, et al.
Publicado: (2023)

Undercutting of marine‐terminating glaciers in West Greenland
por: Rignot, Eric, et al.
Publicado: (2015)

Nanoimprint Replication of Biomimetic, Multilevel Undercut Nanostructures
por: Muehlberger, Michael, et al.
Publicado: (2021)

Finite Element Study On Arthroscopic Anchor Design Aspects
por: El-Anwar, Mohamed, et al.
Publicado: (2019)

The effect of thermo-mechanical fatigue on the retentive force and dimensional changes in polyetheretherketone clasps with different thickness and undercut
por: Güleryüz, Ayşegül, et al.
Publicado: (2021)

Chronic Posttraumatic Epilepsy following Neocortical Undercut Lesion in Mice
por: Ping, Xingjie, et al.
Publicado: (2016)

Effects of Mask Material on Lateral Undercut of Silicon Dry Etching
por: Zhang, Yongkang, et al.
Publicado: (2023)

Analyses of anatomical relationship between mandibular third molar roots and variations in lingual undercut of mandible using cone-beam computed tomography
por: Aktop, Sertac, et al.
Publicado: (2017)

A Three-Dimensional Printed Foot Orthosis for Flexible Flatfoot: An Exploratory Biomechanical Study on Arch Support Reinforcement and Undercut
por: Cheng, Ka-Wing, et al.
Publicado: (2021)

Conference on Representation Theory of Finite Groups and Finite-dimensional Algebras
por: Michler, Gerhard O, et al.
Publicado: (1991)

Mechanical Properties and Failure Mechanism of Anchored Bedding Rock Material under Impact Loading
por: Wu, Yunhao, et al.
Publicado: (2022)

Dramatic undercutting of piedmont rivers after the 2008 Wenchuan Ms 8.0 Earthquake
por: Fan, Niannian, et al.
Publicado: (2016)

The influence of undercut depths on the accuracy of casts poured from irreversible hydrocolloid impression materials
por: Mudliar, Vidya Latchmi, et al.
Publicado: (2020)

Mastering of NIL Stamps with Undercut T-Shaped Features from Single Layer to Multilayer Stamps
por: Taus, Philipp, et al.
Publicado: (2021)

Retreat of Humboldt Gletscher, North Greenland, Driven by Undercutting From a Warmer Ocean
por: Rignot, Eric, et al.
Publicado: (2021)

Use of Deep Learning Networks and Statistical Modeling to Predict Changes in Mechanical Parameters of Contaminated Bone Cements
por: Machrowska, Anna, et al.
Publicado: (2020)

One-Dimensional Finite Elements: An Introduction to the FE Method
por: Öchsner, Andreas, et al.
Publicado: (2013)

The finite-element method for three-dimensional thermomechanical applications
por: Dhondt, Guido
Publicado: (2004)

The Impact of Contaminating Poly (Methyl Methacrylate) (PMMA) Bone Cements on Their Compressive Strength
por: Szabelski, Jakub, et al.
Publicado: (2021)

Effect of Physiological Saline Solution Contamination on Selected Mechanical Properties of Seasoned Acrylic Bone Cements of Medium and High Viscosity
por: Karpiński, Robert, et al.
Publicado: (2020)

Adhesive Joint Degradation Due to Hardener-to-Epoxy Ratio Inaccuracy under Varying Curing and Thermal Operating Conditions
por: Szabelski, Jakub, et al.
Publicado: (2022)

Investigation of Damage Evolution in Heterogeneous Rock Based on the Grain-Based Finite-Discrete Element Model
por: Zhang, Shirui, et al.
Publicado: (2021)

Long-distance social relationships can both undercut and promote local natural resource management
por: Pisor, Anne C., et al.
Publicado: (2024)

Three-dimensional finite element analysis of unilateral mastication in malocclusion cases using cone-beam computed tomography and a motion capture system
por: Yang, Hun-Mu, et al.
Publicado: (2016)

Stability of Three‐Dimensional Printed Custom‐Made Metaphyseal Cone for Tibial Bone Defects Reconstruction: A Finite Element Analysis and Biomechanical Study
por: Wang, Xinguang, et al.
Publicado: (2023)

Improved anchoring nails: design and analysis of resistance ability: Tensile test and finite element analysis (FEA) of improved anchoring nails used in temporomandibular joint (TMJ) disc anchor
por: Zhou, Z. H., et al.
Publicado: (2018)

Three-dimensional finite element analysis of platform switched implant
por: Moon, Se-Young, et al.
Publicado: (2017)

Comparative finite element analysis of mandibular posterior single zirconia and titanium implants: a 3-dimensional finite element analysis
por: Choi, Sung-Min, et al.
Publicado: (2021)

Suture anchor fixation may be an alternative to tension band wiring in olecranon fractures: Finite element analysis
por: Kuru, Tolgahan, et al.
Publicado: (2020)

Influence of configuration and anchor in ligamentous augmentation to prevent proximal junctional kyphosis: A finite element study
por: Liu, Wei, et al.
Publicado: (2022)

Dislodgement resistance of modified resin-bonded fixed partial dentures utilizing tooth undercuts: an in vitro study
por: Doh, Re-Mee, et al.
Publicado: (2009)

The maximal subgroups of low-dimensional finite classical groups
por: Bray, John N, et al.
Publicado: (2013)

Study on mechanical characteristics of conductors with three-dimensional finite-element models
por: Liu, Jiaqiong, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_pf3tt31h997tkmpmi2ar79uqp2