Cargando…

A Novel Approach to Improve the Microstructure and Mechanical Properties of Al–Mg–Si Aluminum Alloys during Twin-Roll Casting

The main purpose of this present study was to investigate the different processing conditions on the microstructure, segregation behavior of alloying elements, and mechanical properties of Al−Mg−Si alloy twin-roll cast slab prepared using a novel twin-roll casting technology. The simulation of tempe...

Descripción completa

Detalles Bibliográficos
Autores principales:	Li, Yong, He, Chen, Li, Jiadong, Wang, Zhaodong, Wu, Di, Xu, Guangming
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2020
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7178634/ https://www.ncbi.nlm.nih.gov/pubmed/32268532 http://dx.doi.org/10.3390/ma13071713

Ejemplares similares

Effects of the Mg/Si Ratio on Microstructure, Mechanical Properties, and Precipitation Behavior of Al–Mg–Si–1.0 wt %-Zn Alloys
por: Li, Yong, et al.
Publicado: (2018)

Microstructure, Precipitates Behavior, and Mechanical Properties of Age-Hardened Al-Mg-Si Alloy Sheet Fabricated by Twin-Roll Casting
por: Gao, Guanjun, et al.
Publicado: (2022)

Effect of Rolling Route on Microstructure and Tensile Properties of Twin-Roll Casting AZ31 Mg Alloy Sheets
por: Luo, Dan, et al.
Publicado: (2016)

Effects of the Quenching Rate on the Microstructure, Mechanical Properties and Paint Bake-Hardening Response of Al–Mg–Si Automotive Sheets
por: Gao, Guanjun, et al.
Publicado: (2019)

Microstructure and Hot Deformation Behavior of Twin Roll Cast Mg-2Zn-1Al-0.3Ca Alloy
por: Kittner, Kristina, et al.
Publicado: (2019)

Microstructure and Mechanical Properties of Al-Mg-Si Similar Alloy Laminates Produced by Accumulative Roll Bonding
por: Li, Zhigang, et al.
Publicado: (2021)

Effect of Rolling Temperature on Microstructure and Properties of Al-Mg-Li Alloy
por: Li, Weiwei, et al.
Publicado: (2022)

Microstructure and Mechanical Properties of High Vacuum Die-Cast AlSiMgMn Alloys at as-Cast and T6-Treated Conditions
por: Liu, Fei, et al.
Publicado: (2019)

Effect of the Type of Inorganic Binder on the Microstructure and Properties of AlSi7Mg Alloy Castings Made by Ablation Casting Technology
por: Kamińska, Jadwiga, et al.
Publicado: (2022)

Cyclic Deformation Behavior of A Heat-Treated Die-Cast Al-Mg-Si-Based Aluminum Alloy
por: Mohammed, Sohail, et al.
Publicado: (2020)

Microstructure, Phase Formation and Heat-Treating of Novel Cast Al-Mg-Zn-Cu-Si Lightweight Complex Concentrated Aluminum Based Alloy
por: Chaskis, Spyridon, et al.
Publicado: (2022)

Effects of Ultrasonic Bending Vibration Introduced by an L-Shaped Ultrasonic Rod on the Microstructure and Properties of a 1060 Aluminum Alloy Strip Formed by Twin-Roll Casting
por: Shi, Chen, et al.
Publicado: (2020)

Microstructural Characterization of the As-Cast and Homogenized Al-Cu-Mg-Ag Alloy
por: Lin, Haitao, et al.
Publicado: (2023)

Effects of Solidification Cooling Rate on the Microstructure and Mechanical Properties of a Cast Al-Si-Cu-Mg-Ni Piston Alloy
por: Tian, Lusha, et al.
Publicado: (2018)

Microstructure and Mechanical Behavior of Quaternary Eutectic α+θ+Q+Si Clusters in As-Cast Al-Mg-Si-Cu Alloys
por: Li, Kai, et al.
Publicado: (2023)

Microstructural Improvement of Eutectic Al + Mg(2)Si Phases on Al–Zn–Si–Mg Cast Alloy with TiB(2) Particles Additions
por: Kim, Byungjoo, et al.
Publicado: (2021)

Research Progress on Multi-Component Alloying and Heat Treatment of High Strength and Toughness Al–Si–Cu–Mg Cast Aluminum Alloys
por: Zhang, Mingshan, et al.
Publicado: (2023)

Calculation Based on the Formation of Mg(2)Si and Its Effect on the Microstructure and Properties of Al–Si Alloys
por: Hao, Jianfei, et al.
Publicado: (2021)

The Behaviour of Bifilm Defects in Cast Al-7Si-Mg Alloy
por: El-Sayed, Mahmoud Ahmed
Publicado: (2016)

Formation of strength platform in cast Al–Si–Mg–Cu alloys
por: Dong, Xixi, et al.
Publicado: (2019)

Microstructure Evolution and Mechanical Properties of Al–Cu–Mg Alloys with Si Addition
por: Shah, Abdul Wahid, et al.
Publicado: (2023)

Influence of Alloyed Ga on the Microstructure and Corrosion Properties of As-Cast Mg–5Sn Alloys
por: Ren, Jing, et al.
Publicado: (2019)

Numerical Simulation and Experimental Validation of Squeeze Casting of AlSi9Mg Aluminum Alloy Component with a Large Size
por: Jiang, Jufu, et al.
Publicado: (2022)

Synergistic Effects of La and Y on the Microstructure and Mechanical Properties of Cast Al-Si-Cu Alloys
por: Shuai, Luming, et al.
Publicado: (2022)

Microstructure and Mechanical Properties of Hypo- and Hypereutectic Cast Mg/Mg(2)Si Composites
por: Braszczyńska-Malik, Katarzyna N., et al.
Publicado: (2020)

Effect of Minor Er Additions on the Microstructures and Mechanical Properties of Cast Al-Cu-Mg-Ag Alloys
por: Xie, Haoyu, et al.
Publicado: (2021)

Structure and Properties of Cast Ti-Al-Si Alloys
por: Knaislová, Anna, et al.
Publicado: (2021)

Intermetallics Formation during Solidification of Al-Si-Cu-Mg Cast Alloys
por: Mohamed, Adel M. A., et al.
Publicado: (2022)

Effect of Sm + Er and Heat Treatment on As-Cast Microstructure and Mechanical Properties of 7055 Aluminum Alloy
por: Wang, Jue, et al.
Publicado: (2023)

Intrinsic and Extrinsic Effects of Microstructure on Properties in Cast Al Alloys
por: Tiryakioğlu, Murat
Publicado: (2020)

Thermal Creep Behavior and Creep Crystallization of Al-Mg-Si Aluminum Alloys
por: Zhang, Qinmin, et al.
Publicado: (2022)

Novel twin-roll-cast Ti/Al clad sheets with excellent tensile properties
por: Kim, Dae Woong, et al.
Publicado: (2017)

Microstructure and Mechanical Properties of Cast Al-Si-Cu-Mg-Ni-Cr Alloys: Effects of Time and Temperature on Two-Stage Solution Treatment and Ageing
por: Xiao, Lairong, et al.
Publicado: (2023)

Effects of Trace Elements on the Microstructural and Machinability Characteristics of Al–Si–Cu–Mg Castings
por: Zedan, Yasser, et al.
Publicado: (2022)

Study on the Effect of Pre-Refinement and Heat Treatment on the Microstructure and Properties of Hypoeutectic Al-Si-Mg Alloy
por: Lin, Ling, et al.
Publicado: (2022)

Effects of Rapid Quenching on Grain Boundary Microstructure and Mechanical Properties of an Al-Mg-Si-Cu Alloy
por: Yan, Qiao, et al.
Publicado: (2023)

High-Temperature Tensile Mechanical Properties and Microstructure of Rolled 6082-T6 Aluminum Alloy Sheets
por: Ye, Tuo, et al.
Publicado: (2023)

Microstructure and Mechanical Properties of the As-Cast and As-Homogenized Mg-Zn-Sn-Mn-Ca Alloy Fabricated by Semicontinuous Casting
por: Lu, Xing, et al.
Publicado: (2018)

Study on the Microstructure of Mg-4Zn-4Sn-1Mn-xAl As-Cast Alloys
por: Liu, Junlin, et al.
Publicado: (2023)

Effect of Sc on the Hot Cracking Properties of 7xxx Aluminum Alloy and the Microstructure of Squeeze Castings
por: Xu, Yongtao, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_h7lmhg7bg7cgk852blvbq8vusm