Hydraulic Fracturing Experiment Investigation for the Application of Geothermal Energy Extraction

[Image: see text] As an attractive renewable energy source, deep geothermal energy is increasingly explored. Granite is a typical geothermal reservoir rock type with low permeability, and hydraulic fracturing is a promising reservoir stimulation method which could obviously enhance the reservoir permeability. Previous hydraulic fracturing studies were mostly conducted on artificial samples and small cylindrical granites. The fracturing pressures of artificial samples and small real rock sample were much lower than that of field operation, and it was difficult to observe morphological changes in small rocks. Hence, this paper presents a hydraulic fracturing experimental study on large-scale granite with a sample size of 300 × 300 × 300 mm under high temperatures. Besides, injection flow rate is an important parameter for on-site hydraulic fracturing; previous studies usually only focused on breakdown pressure, and there is a lack of comprehensive analysis about fracturing pressure curves and fracturing characteristics caused by different injection flow rates. This study aims to investigate the influence of injection flow rate on different pressure curve characteristic parameters which are initiation pressure, propagation time, breakdown pressure, postfracturing pressure, fracture geometry, and fracture permeability. The mean injection power was proposed to roughly estimate the fracture total lengths. These results could provide some guidance for field-scale reservoir stimulation and heat extraction efficiency improvement.