Cargando…

Investigation on Microstructures and Mechanical Properties of the Hypoeutectic Al-10Si-0.8Fe-XEr Alloy

In this paper, the effect of Er addition (0.2, 0.5, 0.65, 0.8, 1.0, and 1.5 wt. %) on the microstructure evolution and tensile properties of as-cast hypereutectic Al-10Si-0.8Fe alloy was investigated. The phases and their morphologies in these alloys were identified by XRD and SEM equipped with EDX...

Descripción completa

Detalles Bibliográficos
Autores principales:	Tang, Peng, Liu, Yiyuan, Zhao, Yanjun, Hu, Zhiliu, Wang, Huachun, Peng, Linxin, Deng, Songyun, Huang, Kui
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Hindawi 2020
Materias:	Research Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7210530/ https://www.ncbi.nlm.nih.gov/pubmed/32426086 http://dx.doi.org/10.1155/2020/9147871

Ejemplares similares

Study on the Effect of Pre-Refinement and Heat Treatment on the Microstructure and Properties of Hypoeutectic Al-Si-Mg Alloy
por: Lin, Ling, et al.
Publicado: (2022)

Influence of Alloying Element Mg on Na and Sr Modifying Al-7Si Hypoeutectic Alloy
por: Huang, Chunfa, et al.
Publicado: (2022)

Multistep nucleation and multi-modification effect of Sc in hypoeutectic Al-Mg-Si alloys
por: Trudonoshyn, Oleksandr, et al.
Publicado: (2019)

Influence of Modification on Flow Stress Behavior and Corrosive Properties of a Hypoeutectic Al-Si Alloy
por: Du, Kai, et al.
Publicado: (2022)

Effect of Rapid Heating and Cooling Conditions on Microstructure Formation in Powder Bed Fusion of Al-Si Hypoeutectic Alloy: A Phase-Field Study
por: Okugawa, Masayuki, et al.
Publicado: (2022)

Relevance of electrical current distribution to the forced flow and grain refinement in solidified Al-Si hypoeutectic alloy
por: Zhang, Y. H., et al.
Publicado: (2018)

Magnetic Properties and Microstructure of FeCoNi(CuAl)(0.8)Sn(x) (0 ≤ x ≤ 0.10) High-Entropy Alloys
por: Li, Zhong, et al.
Publicado: (2018)

Optimizing mechanical properties of Fe(26.7)Co(26.7)Ni(26.7)Si(8.9)B(11) high entropy alloy by inducing hypoeutectic to quasi-duplex microstructural transition
por: Zhang, Ze-Qun, et al.
Publicado: (2019)

Characterization of Microstructures and Tensile Properties of Recycled Al-Si-Cu-Fe-Mn Alloys with Individual and Combined Addition of Titanium and Cerium
por: Wang, Kang, et al.
Publicado: (2018)

Effects of Cr Content on Microstructure and Mechanical Properties of Co-Free FeCr(y)NiAl(0.8) High-Entropy Alloys
por: Cui, Puchang, et al.
Publicado: (2023)

Tailoring Mechanical and Magnetic Properties in Dual-Phase FeCoNi(CuAl)(0.8) High-Entropy Alloy
por: Tan, Xiaohua, et al.
Publicado: (2023)

The Xer activation factor of TLCΦ expands the possibilities for Xer recombination
por: Miele, Solange, et al.
Publicado: (2022)

Effect of Initial Fe Content on Microstructure and Mechanical Properties of Recycled Al-7.0Si-Fe-Mn Alloys with Constant Mn/Fe Ratio
por: Song, Dongfu, et al.
Publicado: (2022)

Deformation Inhomogeneities of a Hypoeutectic Aluminum-Silicon Alloy Modified by Electron Beam Treatment
por: Ustinov, Artem, et al.
Publicado: (2023)

Nanostructured Hypoeutectic Fe-B Alloy Prepared by a Self-propagating High Temperature Synthesis Combining a Rapid Cooling Technique
por: Fu, Licai, et al.
Publicado: (2008)

Microstructure Evolution and Mechanical Properties of FeCoCrNiCuTi(0.8) High-Entropy Alloy Prepared by Directional Solidification
por: Xu, Yiku, et al.
Publicado: (2020)

Microstructure, Mechanical Properties, and Corrosion Resistance of Thermomechanically Processed AlZn6Mg0.8Zr Alloy
por: Kowalski, Aleksander, et al.
Publicado: (2018)

Structural and mechanical aspects of hypoeutectic Zn–Mg binary alloys for biodegradable vascular stent applications
por: Pachla, W., et al.
Publicado: (2020)

Effect of Al-5Ti-0.25C-0.25B and Al-5Ti-1B Master Alloys on the Microstructure and Mechanical Properties of Al-9.5Si-1.5Cu-0.8Mn-0.6Mg Alloy
por: Wen, Yihan, et al.
Publicado: (2023)

Investigation of Microstructure and Wear Properties of Precipitates-Strengthened Cu-Ni-Si-Fe Alloy
por: Peng, Chun-Hao, et al.
Publicado: (2023)

The Effect of the β-Al(5)FeSi Phases on Microstructure, Mechanical and Fatigue Properties in A356.0 Cast Alloys with Higher Fe Content without Additional Alloying of Mn
por: Kuchariková, Lenka, et al.
Publicado: (2021)

Activation of Xer-recombination at dif: structural basis of the FtsKγ–XerD interaction
por: Keller, Andrew N., et al.
Publicado: (2016)

Effect of Al Element on the Microstructure and Properties of Cu-Ni-Fe-Mn Alloys
por: Yang, Ran, et al.
Publicado: (2018)

Enhanced Thermoelectric Performance of Polycrystalline Si(0.8)Ge(0.2) Alloys through the Addition of Nanoscale Porosity
por: Hosseini, S. Aria, et al.
Publicado: (2021)

Large Cryogenic Magnetostriction Induced by Hydrostatic Pressure in MnCo(0.92)Ni(0.08)Si Alloy
por: Hao, Xiaowen, et al.
Publicado: (2023)

Influence of Preparation Technology on Microstructural and Magnetic Properties of Fe(2)MnSi and Fe(2)MnAl Heusler Alloys
por: Jirásková, Yvonna, et al.
Publicado: (2019)

The dif/Xer Recombination Systems in Proteobacteria
por: Carnoy, Christophe, et al.
Publicado: (2009)

Effect of Modifier Form on Mechanical Properties of Hypoeutectic Silumin
por: Lipiński, Tomasz
Publicado: (2023)

Effect of Solidification on Microstructure and Properties of FeCoNi(AlSi)(0.2) High-Entropy Alloy Under Strong Static Magnetic Field
por: Wang, Jiaxiang, et al.
Publicado: (2018)

Effect of Si on Microstructure and Mechanical Properties of FeCrNi Medium Entropy Alloys
por: Ding, Fang, et al.
Publicado: (2023)

Structure and Properties of Fe–Al–Si Alloy Prepared by Mechanical Alloying
por: Novák, Pavel, et al.
Publicado: (2019)

Synergistic Effect of Strontium and Melt Quenching on the Solidification Microstructure of Hypereutectic Al-Si Alloys
por: Wang, Yunfei, et al.
Publicado: (2023)

Optimisation of Solidification Structure and Properties of Hypoeutectic Chromium Cast Iron
por: Siekaniec, Dorota, et al.
Publicado: (2022)

Microstructural Evolution of AlCoCrFeNiSi High-Entropy Alloy Powder during Mechanical Alloying and Its Coating Performance
por: Tian, Lihui, et al.
Publicado: (2018)

The Unconventional Xer Recombination Machinery of Streptococci/Lactococci
por: Le Bourgeois, Pascal, et al.
Publicado: (2007)

Functional Analysis of the Acinetobacter baumannii XerC and XerD Site-Specific Recombinases: Potential Role in Dissemination of Resistance Genes
por: Lin, David L., et al.
Publicado: (2020)

Microstructural Characteristics of Al-Ti-B Inoculation Wires and Their Addition to the AlSi7Mg0.3 Alloy
por: Knaislová, Anna, et al.
Publicado: (2022)

Influence of the Nb and V Addition on the Microstructure and Corrosion Resistance of the Fe-B-Co-Si Alloy
por: Mech, Rafał, et al.
Publicado: (2021)

On the Microstructure and Isothermal Oxidation of the Si-22Fe-12Cr-12Al-10Ti-5Nb (at.%) Alloy
por: Hernández-Negrete, Ofelia, et al.
Publicado: (2019)

Effect of Heat Treatment Process and Optimization of Its Parameters on Mechanical Properties and Microstructure of the AlSi11(Fe) Alloy
por: Jarco, Aleksandra, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_th55ujom8en1sjotlna0v3j66q